A review on water in low rank coals: The existence, interaction with coal structure and effects on coal utilization

The knowledge of the intrinsic pore structure of coals is significant in elucidating the kinetics of mass transport and chemical reaction that leads to design of more efficient coal combustion and conversion equipment. The results of pore structure studies of Greek lignite are reported in this work. Isothermal drying of Greek lignite samples, under vacuum, caused mesopore structure evolution despite the severe (∼50%) particle size contraction due to heating. Mesopore volume and surface area were increased as the drying temperature was raised to 200°C while further drying up to 250°C caused a mesopore volume and surface area decrease. Lignite drying at 100°C for up to 3 h resulted in a monotonic increase of the mesopore structure properties while heating for a longer period i.e., 6 h, despite a slight increase of weight loss, caused pore volume and surface area reduction. Nitrogen sorption (77 K) hysteresis data obtained for partially dried samples have been processed to deduce BET surface area and pore si...

Evolution lignite mesopore structure during drying. effect of temperature and heating time

Spontaneous combustion of carbonaceous stockpiles. Part II. Factors affecting the rate of the low-temperature oxidation reaction

In order to improve the drying efficiency of lignite and restrain the moisture re-adsorption of dewatered coal, the drying characteristics of typical Chinese lignite, the re-adsorption performances of dewatered samples and the change in pore structure throughout the entire processes were investigated in this study. Lignite samples with four different particle size fractions were dried in a fixed-bed reactor in the temperature range 60–160°C. The re-adsorbing moisture behaviors of dewatered coal samples containing different water contents were investigated at temperatures of 20–40°C and humidities of 55–95%. The changes in the pore structure of raw coal and different dried samples were measured by mercury intrusion porosimetry (MIP) and the relations between their re-adsorption performance and change in pore structure were explored. The moisture removal yields of lignite increased with an increase in drying time and temperature and was close to 100% above 120°C and over 100% after holding 40 and 15 min at ...

Effect of Drying Conditions on Moisture Re-Adsorption Performance of Dewatered Lignite

Spontaneous combustion of carbonaceous stockpiles. Part I: the relative importance of various intrinsic coal properties and properties of the reaction system

Th.J. Linardos

Papers

Effects of drying upon lignite macro-pore structure