Dry sliding wear of aluminium composites : A review

In the present investigation, the influence of B 4 C on the mechanical and Tribological behavior of Al 7075 composites is identified. Al 7075 particle reinforced composites were produced through casting, K 2 TiF 6 added as the flux, to overcome the wetting problem between B 4 C and liquid aluminium metal. The aluminium B 4 C composites thus produced were subsequently subjected to T6 heat treatment. The samples of Al 7075 composites were tested for hardness, tensile, compression, flexural strengths and wear behavior. The test results showed increasing hardness of composites compared with the base alloy because of the presence of the increased ceramic phase. The wear resistance of the composites increased with increasing content of B 4 C particles, and the wear rate was significantly less for the composite material compared to the matrix alloy. A mechanically mixed layer containing oxygen and iron was observed on the surface, and this acted as an effective insulation layer preventing metal to metal contact. The coefficient of friction decreased with increased B 4 C content and reached its minimum at 10 vol% B 4 C.

Influence of B4C on the tribological and mechanical properties of Al 7075–B4C composites

Wear behaviour of aluminium alloy and its composites reinforced by SiC particles using statistical analysis

The objective of this paper is to investigate the friction behavior and wear mechanism of copper matrix composites reinforced with SiC and graphite particles. The results indicate that a graphite-rich mechanically mixed layer (MML) formed on the tribo-surface was responsible for the good tribological properties of the hybrid composites at low normal loads. When graphite content was high enough for delamination wear to take place at high load, wear resistance deteriorated. A continuous supply of graphite to the tribo-surface is an important precondition for the formation of a graphite-rich MML and the benefit of its anti-friction properties for the copper hybrid composites.

Zhang Liangchi

Papers

Modelling friction and wear of scratching ceramic particle-reinforced metal composites