Development of a new high entropy alloy for wear resistance: FeCoCrNiW0.3 and FeCoCrNiW0.3 + 5 at.% of C

Effect of laser scanning speed on a Ti-45Al-2Cr-5Nb alloy processed by selective laser melting: Microstructure, phase and mechanical properties

Multiscale mechanical performance and corrosion behaviour of plasma sprayed AlCoCrFeNi high-entropy alloy coatings

A comparative study on the nanoindentation behavior, wear resistance and in vitro biocompatibility of SLM manufactured CP-Ti and EBM manufactured Ti64 gyroid scaffolds.

Nanoindentation based properties of Inconel 718 at elevated temperatures: A comparison of conventional versus additively manufactured samples

Indentation size effect in nanohardness

In this review, the development of techniques for determining the plasticity of mate rials by the indentation is considered. the development of methods for deter­ mining the plasticity of materials by the indentation is based on the use of funda­ mental ideas of the physics of strength and plasticity. Significant development of these me thods became possible after the introduction of a new plasticity characteristic δ = εp/εt, where εр is the plastic deformation, and εt is the total deformation. this plasticity characteristic corresponds to the modern physical definitions of plasticity, in contrast to the widely used elongation to failure δ. the new plasticity characteristic is easily determined by standard determination of hardness by the diamond pyramidal indenters at constant load P (designated as δН) and by instrumental nanoindentation (designated as δА, and δH ≈ δA). A significant advantage of the new plasticity charac­ teristic is the ability to determine it not only for metals, but for materials, which are brittle at the standard mechanical tests (ceramics, thin layers, coa tings, etc.), as well. In the development of ideas about theoretical strength, concepts of theoretical plasticity under the dislocation­free and dislocation deformation mechanisms are introduced. A number of studies have established a correlation of δН with the elec­ tronic structure of the material and its physical properties. As shown, the tabor parameter С (C = HM/σS, where HM is the Meyer hardness, and σS is the yield stress) is easily calculated by the δН value. therefore, indentation allows currently determining simply not only the hardness, but also the plasticity and yielding stress of materials. thus, indentation became a simple method for determination of the complex of mechanical properties of materials in a wide temperature range using a sample in the form of a metallographic specimen.

/pdf/plasticity-of-materials-determined-by-the-indentation-method-6gku931tzz.pdf

А. А. Golubenko

Papers

Indentation size effect in nanohardness

Plasticity of Materials Determined by the Indentation Method