Accelerated curing of high performance fibre-reinforced polymer (FRP) composites via microwave heating or radiation, which can significantly reduce cure time and increase energy efficiency, has several major challenges (eg uneven depth of radiation penetration, reinforcing fibre shielding, uneven curing, introduction of hot spots etc) This article reviews the current scientific challenges with microwave curing of FRP composites considering the underlying physics of microwave radiation absorption in thermoset-matrix composites The fundamental principles behind efficient accelerated curing of composites using microwave radiation heating are reviewed and presented, especially focusing on the relation between penetration depth, microwave frequency, dielectric properties and cure degree Based on this review, major factors influencing microwave curing of thermoset-matrix composites are identified, and recommendations for efficient cure cycle design are provided

/pdf/accelerated-microwave-curing-of-fibre-reinforced-thermoset-4mzbhickfs.pdf

Accelerated microwave curing of fibre-reinforced thermoset polymer composites for structural applications: A review of scientific challenges

Interfacial shear strength of microwave processed carbon fiber/epoxy composites characterized by an improved fiber-bundle pull-out test

For the fabrication of carbon fibre reinforced composites used in aerospace industry, microwave curing technologies are more effective than traditional thermal curing technologies. However, the manufacturer's recommended cure cycles used in traditional autoclave curing are directly adopted into current microwave curing technologies without thorough validation. Here, a new cyclic heating and cooling methodology for microwave curing process control of composite is proposed by analyzing mechanisms of heat conduction, stress generation and curing kinetics. The results of the experiment carried out show significant reductions in residual strain, warpage, total curing time and energy consumption, compared with both traditional thermal curing and current microwave curing technologies. The mechanical properties of samples cured by the new process are compared with the autoclave cured ones.

/pdf/a-new-process-control-method-for-microwave-curing-of-carbon-4vuok9a7wm.pdf

A new process control method for microwave curing of carbon fibre reinforced composites in aerospace applications

Effect of microwave curing process on the flexural strength and interlaminar shear strength of carbon fiber/bismaleimide composites

Even though porous elastomers and elastomeric nanocomposites have shown many advantages for triboelectric nanogenerators (TENGs), their fabrication techniques are relatively complicated, inefficient, and time-consuming. In this work, we introduced a simple, efficient and rapid concept to fabricate porous polydimethylsiloxane (PDMS) nanocomposites. PDMS nanocomposites with various porous structure were produced within a few minutes through just one-step microwave irradiation without any post-processing. Three solvents with different boiling points were selected as sacrificial materials to control porous structure. To fabricate nanocomposites, BaTiO3 (BT) nanoparticles were mixed into the uncured PDMS and sacrificial solvent mixture. Additionally, Ni nanoparticles were also used to understand the effect of embedded material’s property on porous structure. The porous BT/PDMS nanocomposites fabricated via microwave irradiation greatly enhanced the electrical performance of TENGs as compared to a pure solid elastomer. The present study provides a simple, rapid and inexpensive approach for fabricating TENGs based on porous elastomeric nanocomposites.

/pdf/rapid-fabrication-of-microporous-batio-3-pdms-nanocomposites-z5kdzd7voy.pdf

A. Bismarck

Papers

Microwave curing of carbon–epoxy composites: Penetration depth and material characterisation Part A Applied science and manufacturing