A theoretical model is developed for wave heights and set-up in a surf zone. In the time averaged equations of energy and momentum the energy flux, radiation stress and energy dissipation are determined by simple approximations which include the surface roller in the breaker. Comparison with measurements shows good agreement. Also the transitions immediately after breaking are analysed and shown to be in accordance with the above mentioned ideas and results.

/pdf/wave-heights-and-set-up-in-a-surf-zone-39q6lqmhg5.pdf

Wave Heights and Set-up in a Surf Zone

Surf zone dynamics simulated by a Boussinesq type model. Part I. Model description and cross-shore motion of regular waves

Hydrodynamics and sediment transport in the swash zone: a review and perspectives

Long-term morphological modeling of a tidal inlet: the Arcachon Basin, France

The response of the circulation of a coral reef system in Kaneohe Bay, Hawaii, to incident wave forcing was investigated using field data collected during a 10-month experiment. Results from the study revealed that wave forcing was the dominant mechanism driving the circulation over much of Kaneohe Bay. As predicted theoretically, wave setup generated near the reef crest resulting from wave breaking established a pressure gradient that drove flow over the reef and out of the two reef channels. Maximum reef setup was found to be roughly proportional to the offshore wave energy flux above a threshold root-mean-square wave height of 0.7 m (at which height setup was negligible). On the reef flat, the wave-driven currents increased approximately linearly with incident wave height; however, the magnitude of these currents was relatively weak (typically <20 cm s−1) because of (i) the mild fore-reef slope of Kaneohe Bay that reduced setup resulting from a combination of frictional wave damping and its re...

A.H. Brookins

Papers

Wave energy transformation on natural profiles