The surface science of titanium dioxide

Scientific studies on photocatalysis started about two and a half decades ago. Titanium dioxide (TiO 2 ), which is one of the most basic materials in our daily life, has emerged as an excellent photocatalyst material for environmental purification. In this review, current progress in the area of TiO 2 photocatalysis, mainly photocatalytic air purification, sterilization and cancer therapy are discussed together with some fundamental aspects. A novel photoinduced superhydrophilic phenomenon involving TiO 2 and its applications are presented.

/pdf/titanium-dioxide-photocatalysis-4yiwrh1scn.pdf

Titanium dioxide photocatalysis

Abstract Scientific studies on photocatalysis started about two and a half decades ago. Titanium dioxide (TiO 2 ), which is one of the most basic materials in our daily life, has emerged as an excellent photocatalyst material for environmental purification. In this review, current progress in the area of TiO 2 photocatalysis, mainly photocatalytic air purification, sterilization and cancer therapy are discussed together with some fundamental aspects. A novel photoinduced superhydrophilic phenomenon involving TiO 2 and its applications are presented.

Titanium dioxide as photocatalysis

TiO2 photocatalysis and related surface phenomena

Jenny Schneider,*,† Masaya Matsuoka,‡ Masato Takeuchi,‡ Jinlong Zhang, Yu Horiuchi,‡ Masakazu Anpo,‡ and Detlef W. Bahnemann*,† †Institut fur Technische Chemie, Leibniz Universitaẗ Hannover, Callinstrasse 3, D-30167 Hannover, Germany ‡Faculty of Engineering, Osaka Prefecture University, 1 Gakuen-cho, Sakai Osaka 599-8531, Japan Key Lab for Advanced Materials and Institute of Fine Chemicals, East China University of Science and Technology, Shanghai 200237, China

Understanding TiO2 photocatalysis: mechanisms and materials.

Reversible surface wettability conversion on titanium dioxide (TiO2) single crystals has been achieved, and its mechanism has been examined by means of contact angle measurement and X-ray photoelectron spectroscopy (XPS). A UV light illuminated TiO2 single-crystal surface exhibited a 0° contact angle for both water and oil, indicative of a highly amphiphilic surface against its native hydrophobic surface. This was ascribed to photoreduction of surface Ti4+ to Ti3+ at definite sites, leading to preferential adsorption of dissociative water on top. A long-term storage of the highly amphiphilic surface resulted in reconversion of the surface wettability. It was found that the amphiphilic-to-hydrophobic reconversion is due to the replacement of the adsorbed hydroxyl groups by oxygen, which returns the surface geometric and electronic structures similar to the native TiO2 surface. The result of angle-resolved XPS measurement revealed that the surface reactions occurred at the uppermost layers of the single cry...

Studies of Surface Wettability Conversion on TiO2 Single-Crystal Surfaces

Changes in hydrophilicity of TiO2 film electrode surfaces by UV light irradiation in an aqueous solution were investigated under potential-controlled conditions. Although no change was observed when the electrode potential of TiO2 was set around its flat-band potential Efb, the photoinduced hydrophilic conversion proceeded at potentials positive of Efb. The hydrophilic conversion rate increased with larger positive potentials, but the addition of hole scavengers decreased the rate, suggesting that the diffusion of photogenerated holes to the surface is the important process for the hydrophilic conversion. Based on these results, we propose a model in which the photoinduced hydrophilicity is initiated by two-hole trapping by a surface lattice oxygen, producing an oxygen defect, followed by the dissociative adsorption of a water molecule at the defect site.

and Toshiya Watanabe

Papers

Studies of Surface Wettability Conversion on TiO2 Single-Crystal Surfaces

Enhancement of the Photoinduced Hydrophilic Conversion Rate of TiO2 Film Electrode Surfaces by Anodic Polarization