Depositing large components (>10 kg) in titanium, aluminium, steel and other metals is possible using Wire + Arc Additive Manufacturing. This technology adopts arc welding tools and wire as feedstock for additive manufacturing purposes. High deposition rates, low material and equipment costs, and good structural integrity make Wire+Arc Additive Manufacturing a suitable candidate for replacing the current method of manufacturing from solid billets or large forgings, especially with regards to low and medium complexity parts. A variety of components have been successfully manufactured with this process, including Ti–6Al–4V spars and landing gear assemblies, aluminium wing ribs, steel wind tunnel models and cones. Strategies on how to manage residual stress, improve mechanical properties and eliminate defects such as porosity are suggested. Finally, the benefits of non-destructive testing, online monitoring and in situ machining are discussed.

https://tandfonline.com/doi/pdf/10.1179/1743284715Y.0000000073

Wire + Arc Additive Manufacturing

Effects of gas shielding parameters on weld penetration of CO2 laser-TIG hybrid welding

Innovative Process Model of Ti-6Al-4V Additive Layer Manufacturing Using Cold Metal Transfer (CMT)

Effect of shielding gases on microstructure and mechanical properties of super austenitic stainless steel by hybrid welding

Wire arc additive manufacturing (WAAM): A new process to shape engineering materials

Cathode spot formation is very pronounced during arc welding of titanium and titanium alloys. The dynamic behaviour of these spots was observed to interfere with metal transfer during welding, this interference being a fundamental cause of poor weld quality in these alloys. In the present work, stabilisation of the arc cathode spot with a focused Nd–YAG laser beam during pulsed gas metal arc welding of titanium was investigated. The laser beam was focused near the leading edge of the weld pool and the laser power and focus spot size were varied to determine the values required to confine the cathode spot to the laser focus position. The results showed that, for fixed welding conditions, the laser power required to prevent cathode spot motion varied as a function of focus spot size. The required laser power was minimised at 200 W for a spot size of 0.6 mm. The laser stabilised arcs had lower voltage but approximately the same current density as stabilised arcs. Increased welding speeds required mar...

B. W. Shinn

Papers

Laser stabilisation of arc cathode spots in titanium welding