Polymeric and low molecular weight shale inhibitors: A review

Hole-cleaning performance comparison of oil-based and water-based drilling fluids

Improving the performance of oil based mud and water based mud in a high temperature hole using nanosilica nanoparticles

Viscoelastic properties of drilling fluids and their influence on cuttings transport

Hole cleaning and drilling fluid sweeps in horizontal and deviated wells: Comprehensive review

Drilling fluids for oil wells must meet a number of requirements, including maintaining formation integrity, lubricating the drill string, and transporting cuttings to the surface. In order to satisfy these needs, drilling fluids have become increasingly complex and expensive. To ensure safe and efficient drilling, it is vital for the drilling operator to be able to make a qualified choice of fluid appropriate for each individual well.API/ISO standards specify a set of tests for characterization of drilling fluids. However, fluids that are tested to have equal properties according to these standards are still observed to perform significantly different when used in the field. The aim of the full project is to provide a thorough comparison of drilling fluids in particular with respect to hole cleaning performance, in light of the issues presented above. As part of this investigation we here present results for two oil based drilling fluids, as well as for the corresponding base oil. The drilling fluids differ in composition by varying fraction of base oil, and thus density and water content.The fluids have been tested according to the API standard, and further, viscoelastic properties have been examined using an Anton Paar rheometer. The rheological test campaign includes determination of the linear viscoelastic range (LVER), viscosity and yield point, thixotropic time test, and temperature dependence of rheological parameters.Further, it is demonstrated how the rheological data may be used to interpret data from ongoing full scale flow loop experiments with the same fluids. In a more general context, the rheological test campaign of the drilling fluids is expected to make a crucial contribution for the petroleum industry in explaining observed differences in hole cleaning properties beyond what todays API/ISO industry standard provides.Copyright © 2015 by ASME

Rheological Properties of Oil Based Drilling Fluids and Base Oils

One important requirement for a drilling fluid is the ability to transport the cuttings out of the borehole. Improved hole cleaning is a key to solve several challenges in the drilling industry and will allow both longer wells and improved quality of well construction. It has been observed, however, that drilling fluids with similar properties according to the API standard can have significantly different behavior with respect to hole cleaning performance. The reasons for this are not fully understood.This paper presents results from flow loop laboratory tests without and with injected cuttings size particles using a base oil and a commercial oil based drilling fluid. The results demonstrate the importance of the rheological properties of the fluids for the hole cleaning performance. A thorough investigation of the viscoelastic properties of the fluids was performed with a Fann viscometer and a Paar-Physica rheometer, and was used to interpret the results from the flow loop experiments.Improved understanding of the fluid properties relevant to hole cleaning performance will help develop better models of wellbore hydraulics used in planning of well operations. Eventually this may lead to higher ROP with water based drilling fluids as obtained with oil based drilling fluids. This may ease cuttings handling in many operations and thereby significantly reduce the drilling cost using (normally) more environmentally friendly fluids.The experiments have been conducted as part of an industry-sponsored research project where understanding the hole cleaning performance of various oil and water based drilling fluids is the aim. The experiments have been performed under realistic conditions. The flow loop includes a 10 meter long test section with 2″ OD freely rotating drillstring inside a 4″ ID wellbore made of concrete. Sand particles were injected while circulating the drilling fluid through the test section in horizontal position.Copyright © 2015 by ASME

Benjamin Werner

Papers

Viscoelastic properties of drilling fluids and their influence on cuttings transport

Rheological Properties of Oil Based Drilling Fluids and Base Oils

Full Scale Flow Loop Experiments of Hole Cleaning Performances of Drilling Fluids

Experimental Investigation of Cuttings Transport With Oil Based Drilling Fluids

Comparison of Rheological Properties of Oil-Based and KCl Drilling Fluids