General Bathymetric Chart of the Oceans (GEBCO) has released the GEBCO_2014 grid, a new digital bathymetric model of the world ocean floor merged with land topography from publicly available digital elevation models. GEBCO_2014 has a grid spacing of 30 arc seconds, and updates the 2010 release (GEBCO_08) by incorporating new versions of regional bathymetric compilations from the International Bathymetric Chart of the Arctic Ocean (IBCAO), the International Bathymetric Chart of the Southern Ocean (IBCSO), the Baltic Sea Bathymetry Database (BSBD), and data from the European Marine Observation and Data network (EMODnet) bathymetry portal, among other data sources. Approximately 33% of ocean grid cells (not area) have been updated in GEBCO_2014 from the previous version, including both new interpolated depth values and added soundings. These updates include large amounts of multibeam data collected using modern equipment and navigation techniques, improving portrayed details of the world ocean floor. Of all non-land grid cells in GEBCO_2014, approximately 18% are based on bathymetric control data, i.e., primarily multibeam and single beam soundings, or pre-prepared grids which may contain some interpolated values. The GEBCO_2014 grid has a mean and median depth of 3897 m and 3441 m, respectively. Hypsometric analysis reveals that 50% of the Earth's surface is comprised of seafloor located 3200 m below mean sea level, and that ~900 ship-years of surveying would be needed to obtain complete multibeam coverage of the world's oceans.

/pdf/a-new-digital-bathymetric-model-of-the-world-s-oceans-udw6vp0wrj.pdf

A new digital bathymetric model of the world's oceans

Greenland's bed topography is a primary control on ice flow, grounding line migration, calving dynamics, and subglacial drainage. Moreover, fjord bathymetry regulates the penetration of warm Atlantic water (AW) that rapidly melts and undercuts Greenland's marine-terminating glaciers. Here we present a new compilation of Greenland bed topography that assimilates seafloor bathymetry and ice thickness data through a mass conservation approach. A new 150 m horizontal resolution bed topography/bathymetric map of Greenland is constructed with seamless transitions at the ice/ocean interface, yielding major improvements over previous data sets, particularly in the marine-terminating sectors of northwest and southeast Greenland. Our map reveals that the total sea level potential of the Greenland ice sheet is 7.42 ± 0.05 m, which is 7 cm greater than previous estimates. Furthermore, it explains recent calving front response of numerous outlet glaciers and reveals new pathways by which AW can access glaciers with marine-based basins, thereby highlighting sectors of Greenland that are most vulnerable to future oceanic forcing.

/pdf/bedmachine-v3-complete-bed-topography-and-ocean-bathymetry-3l7x6a1c4k.pdf

BedMachine v3: Complete Bed Topography and Ocean Bathymetry Mapping of Greenland From Multibeam Echo Sounding Combined With Mass Conservation.

. We present a new bed elevation dataset for Greenland derived from a combination of multiple airborne ice thickness surveys undertaken between the 1970s and 2012. Around 420 000 line kilometres of airborne data were used, with roughly 70% of this having been collected since the year 2000, when the last comprehensive compilation was undertaken. The airborne data were combined with satellite-derived elevations for non-glaciated terrain to produce a consistent bed digital elevation model (DEM) over the entire island including across the glaciated–ice free boundary. The DEM was extended to the continental margin with the aid of bathymetric data, primarily from a compilation for the Arctic. Ice thickness was determined where an ice shelf exists from a combination of surface elevation and radar soundings. The across-track spacing between flight lines warranted interpolation at 1 km postings for significant sectors of the ice sheet. Grids of ice surface elevation, error estimates for the DEM, ice thickness and data sampling density were also produced alongside a mask of land/ocean/grounded ice/floating ice. Errors in bed elevation range from a minimum of ±10 m to about ±300 m, as a function of distance from an observation and local topographic variability. A comparison with the compilation published in 2001 highlights the improvement in resolution afforded by the new datasets, particularly along the ice sheet margin, where ice velocity is highest and changes in ice dynamics most marked. We estimate that the volume of ice included in our land-ice mask would raise mean sea level by 7.36 m, excluding any solid earth effects that would take place during ice sheet decay.

/pdf/a-new-bed-elevation-dataset-for-greenland-1esq4oikxe.pdf

A new bed elevation dataset for Greenland

Global Bathymetry and Topography at 15 Arc Sec: SRTM15+

The accuracy of state-of-the-art global barotropic tide models is assessed using bottom pressure data, coastal tide gauges, satellite altimetry, various geodetic data on Antarctic ice shelves, and independent tracked satellite orbit perturbations. Tide models under review include empirical, purely hydrodynamic (“forward”), and assimilative dynamical, i.e., constrained by observations. Ten dominant tidal constituents in the diurnal, semidiurnal, and quarter-diurnal bands are considered. Since the last major model comparison project in 1997, models have improved markedly, especially in shallow-water regions and also in the deep ocean. The root-sum-square differences between tide observations and the best models for eight major constituents are approximately 0.9, 5.0, and 6.5 cm for pelagic, shelf, and coastal conditions, respectively. Large intermodel discrepancies occur in high latitudes, but testing in those regions is impeded by the paucity of high-quality in situ tide records. Long-wavelength components of models tested by analyzing satellite laser ranging measurements suggest that several models are comparably accurate for use in precise orbit determination, but analyses of GRACE intersatellite ranging data show that all models are still imperfect on basin and subbasin scales, especially near Antarctica. For the M2 constituent, errors in purely hydrodynamic models are now almost comparable to the 1980-era Schwiderski empirical solution, indicating marked advancement in dynamical modeling. Assessing model accuracy using tidal currents remains problematic owing to uncertainties in in situ current meter estimates and the inability to isolate the barotropic mode. Velocity tests against both acoustic tomography and current meters do confirm that assimilative models perform better than purely hydrodynamic models.

Accuracy assessment of global barotropic ocean tide models

The International Bathymetric Chart of the Arctic Ocean (IBCAO) released its first gridded bathymetric compilation in 1999. The IBCAO bathymetric portrayals have since supported a wide range of Arc ...

/pdf/the-international-bathymetric-chart-of-the-arctic-ocean-28i8u5in03.pdf

Boris Fridman

Papers

The International Bathymetric Chart of the Arctic Ocean (IBCAO) Version 3.0