White etching matter promoted by intergranular embrittlement

Non-saturated cyclic softening and uniaxial ratcheting of a high-strength steel: Experiments and viscoplastic constitutive modeling

An elasto-plastic-damage model for initiation and propagation of spalling in rolling bearings

The failure of a bearing-raceway assembly is governed by the spatial distribution of subsurface stresses at the vicinity of a bearing-raceway contact and the evolution of these stresses during rolling contact fatigue (RCF) loading. In this paper, we propose an experimental methodology that allows one to accurately measure the location and magnitude of the cyclically evolving elastoplastic von Mises stresses in terms of microhardness numbers. An M50NiL steel rod is subjected to RCF by three silicon nitride (Si3N4) balls for over several hundred million cycles at 5.5 GPa contact stress level. Microindentation hardness measurements within the subsurface RCF-affected regions of the rod revealed significant material hardening. A mechanistic methodology to construct a stress-life (S-N) diagram for RCF loading is proposed. S-N diagrams are constructed based on maximum von Mises stress amplitude and volume average von Mises stress amplitude. The effects of elastic modulus and yield strength gradient on stress fields are also considered in this analysis. Comparison of S-N diagrams based on both stress amplitudes indicates that the maximum von Mises stress amplitude overpredicts the fatigue strength of material in S-N diagrams. The experimental results obtained by following this methodology can help construct material hardening models for RCF, which may lead to an improved estimate of bearing fatigue life.

A New Approach Towards Life Prediction of Case Hardened Bearing Steels Subjected to Rolling Contact Fatigue

Effect of plasticity on the dynamic capacity of modern bearing steels

Microstructural and mechanical characterization investigations on three variants of a through-hardened M50 bearing steel are presented to compare and contrast their performances under rolling contact fatigue (RCF) loading. Baseline (BL) variant of M50 steel bearing balls is subjected to: (i) a surface nitriding treatment and (ii) a surface mechanical processing treatment, to obtain distinct microstructures and mechanical properties. These balls are subjected to RCF loading for several hundred million cycles at two different test temperatures, and the subsequent changes in subsurface hardness and compressive stress–strain response are measured. It was found that the RCF-affected subsurface regions grow larger in size at higher temperature. Micro-indentation hardness measurements within the RCF-affected regions revealed an increase in hardness in all the three variants. The size of the RCF-affected region and intensity of hardening were the largest in the BL material and smallest in the mechanically processed (MP) material. Based on Goodman's diagram, it is shown that the compressive residual stress reduces the effective fully reversed alternating stress amplitude and thereby retards the initiation and evolution of subsurface plasticity within the material during RCF loading. It is quantitatively shown that high material hardness and compressive residual stress are greatly beneficial for enhancing the RCF life of bearings.

Bryan McCoy

Papers

Influence of Residual Stress and Temperature on the Cyclic Hardening Response of M50 High-Strength Bearing Steel Subjected to Rolling Contact Fatigue