C
Carlos Henrique Lauro
Researcher at Universidade Federal de São João del-Rei
Publications - 54
Citations - 853
Carlos Henrique Lauro is an academic researcher from Universidade Federal de São João del-Rei. The author has contributed to research in topics: Machining & Surface roughness. The author has an hindex of 13, co-authored 46 publications receiving 660 citations. Previous affiliations of Carlos Henrique Lauro include University of Aveiro.
Papers
More filters
Journal ArticleDOI
Monitoring and processing signal applied in machining processes – A review
TL;DR: In this article, the first steps involved in choosing and defining various techniques that may be used to monitor machining processes are discussed, and the techniques to acquire and process the signals of the monitoring processes are outlined.
Journal ArticleDOI
Surface Roughness Investigation in the Hard Turning of Steel Using Ceramic Tools
TL;DR: In this article, the authors evaluated the use of conventional and multi-radii ceramic tools in the turning of AISI H13 in terms of surface quality using the analysis of variance (ANOVA).
Journal ArticleDOI
Experimental investigation on surface finish during intermittent turning of UNS M11917 magnesium alloy under dry and near dry machining conditions
TL;DR: In this paper, an experimental investigation in intermittent turning of UNS M11917 magnesium alloy, analysing different machining conditions: cutting speed, depth of cut and feed rate, along with the use of dry machining and minimum quantity lubrication (MQL) system, is presented.
Journal ArticleDOI
Analysis of form threads using fluteless taps in cast magnesium alloy (AM60)
Alessandra Olinda de Carvalho,Lincoln Cardoso Brandão,Túlio Hallak Panzera,Carlos Henrique Lauro +3 more
TL;DR: In this paper, the effect of the factors the hole diameter, the forming speed and types of tool on the responses: torque, hardness, fill rate, and thrust force of the form tapping process was investigated.
Journal ArticleDOI
Analysis of behaviour biocompatible titanium alloy (Ti-6Al-7Nb) in the micro-cutting
TL;DR: In this article, an orthogonal micro-cutting with the variation of the cutting speed, feed rate, and spindle speed was performed to investigate the ploughing effect in the chip, cutting forces, specific cutting energy, friction coefficient, temperature, and shear plane angle.