C
Chuanzhen Huang
Researcher at Shandong University
Publications - 405
Citations - 5988
Chuanzhen Huang is an academic researcher from Shandong University. The author has contributed to research in topics: Ceramic & Microstructure. The author has an hindex of 33, co-authored 358 publications receiving 3955 citations. Previous affiliations of Chuanzhen Huang include Chinese Ministry of Education & Yanshan University.
Papers
More filters
Journal ArticleDOI
Study on microstructure, mechanical properties and machinability of efficiently additive manufactured AISI 316L stainless steel by high-power direct laser deposition
TL;DR: In this paper, the effect of building direction on the microstructure, mechanical properties and machinability of stainless steel was investigated, and it was found that the micro-structure was homogeneous, at the building direction of 0°, while a number of larger dendritic grains were present in the microstructures, and the tensile properties and hardness values were higher than those at 90°.
Journal ArticleDOI
Effects of printing parameters of fused deposition modeling on mechanical properties, surface quality, and microstructure of PEEK
TL;DR: In this article, a finite element analysis (FEA) was used to simulate the melting conditions and fluidity of PEEK in a flow channel, in order to determine the parameters required to 3D print PEEK parts with sufficient surface quality and improved mechanical properties.
Journal ArticleDOI
Preparation of short CF/GF reinforced PEEK composite filaments and their comprehensive properties evaluation for FDM-3D printing
TL;DR: In this article, the potential of FDM-3D printing short carbon fiber (CF) and glass fiber (GF) reinforced high-performance PEEK composites has been investigated; the results indicate that the addition of CF/GF to PEEK can significantly enhance the tensile and flexural strength at the cost of ductility.
Journal ArticleDOI
Dynamic behavior and a modified Johnson–Cook constitutive model of Inconel 718 at high strain rate and elevated temperature
TL;DR: In this article, a constitutive model for Inconel 718 which is suitable for the cutting process is presented. But, there are few constitutive models for InConel 7 18 which are suitable for cutting process.
Journal ArticleDOI