II. Structure of Perovskites 1982 A. Crystal Structure 1982 B. Nonstoichiometry in Perovskites 1983 1. Oxygen Nonstoichiometry 1983 2. Cation Nonstoichiometry 1984 C. Physical Properties 1985 D. Adsorption Properties 1986 1. CO and NO Adsorption 1986 2. Oxygen Adsorption 1987 E. Specific Surface and Porosity 1987 F. Thermal Stability in a Reducing Atmosphere 1989 III. Acid−Base and Redox Properties 1990 A. Acidity and Basicity 1990 B. Redox Processes 1991 1. Kinetics and Mechanisms 1992 2. Reduction−Oxidation Cycles 1993 C. Ion Mobility 1993 1. Oxygen Transport 1993 2. Cation Transport 1994 IV. Heterogeneous Catalysis 1995 A. Oxidation Reactions 1995 1. CO Oxidation 1995 2. Oxidation of Hydrocarbons 1996 B. Pollution Abatement 2001 1. NOx Decomposition 2001 2. Exhaust Treatment 2002 3. Stability 2004 C. Hydrogenation and Hydrogenolysis Reactions 2004 1. Hydrogenation of Carbon Oxides 2004 2. Hydrogenation and Hydrogenolysis Reactions 2006

Chemical structures and performance of perovskite oxides.

Hematite (α-Fe2O3) constitutes one of the most promising semiconductor materials for the conversion of sunlight into chemical fuels by water splitting. Its inherent drawbacks related to the long penetration depth of light and poor charge carrier conductivity are being progressively overcome by employing nanostructuring strategies and improved catalysts. However, the physical–chemical mechanisms responsible for the photoelectrochemical performance of this material (J(V) response) are still poorly understood. In the present study we prepared thin film hematite electrodes by atomic layer deposition to study the photoelectrochemical properties of this material under water-splitting conditions. We employed impedance spectroscopy to determine the main steps involved in photocurrent production at different conditions of voltage, light intensity, and electrolyte pH. A general physical model is proposed, which includes the existence of a surface state at the semiconductor/liquid interface where holes accumulate. T...

Water Oxidation at Hematite Photoelectrodes: The Role of Surface States

We report a plasmonic water splitting cell in which 95% of the effective charge carriers derive from surface plasmon decay to hot electrons, as evidenced by fuel production efficiencies up to 20-fold higher at visible, as compared to UV, wavelengths. The cell functions by illuminating a dense array of aligned gold nanorods capped with TiO2, forming a Schottky metal/semiconductor interface which collects and conducts the hot electrons to an unilluminated platinum counter-electrode where hydrogen gas evolves. The resultant positive charges in the Au nanorods function as holes and are extracted by an oxidation catalyst which electrocatalytically oxidizes water to oxygen gas.

Plasmonic photoanodes for solar water splitting with visible light.

Atomic layer deposition (ALD) was utilized to deposit uniform thin films of hematite (α-Fe2O3) on transparent conductive substrates for photocatalytic water oxidation studies. Comparison of the oxidation of water to the oxidation of a fast redox shuttle allowed for new insight in determining the rate limiting processes of water oxidation at hematite electrodes. It was found that an additional overpotential is needed to initiate water oxidation compared to the fast redox shuttle. A combination of electrochemical impedance spectroscopy, photoelectrochemical and electrochemical measurements were employed to determine the cause of the additional overpotential. It was found that photogenerated holes initially oxidize the electrode surface under water oxidation conditions, which is attributed to the first step in water oxidation. A critical number of these surface intermediates need to be generated in order for the subsequent hole-transfer steps to proceed. At higher applied potentials, the behavior of the electrode is virtually identical while oxidizing either water or the fast redox shuttle; the slight discrepancy is attributed to a shift in potential associated with Fermi level pinning by the surface states in the absence of a redox shuttle. A water oxidation mechanism is proposed to interpret these results.

/pdf/electrochemical-and-photoelectrochemical-investigation-of-62xdnznf4k.pdf

Electrochemical and photoelectrochemical investigation of water oxidation with hematite electrodes

An overview of photocells and photoreactors for photoelectrochemical water splitting

Photoelectrochemical devices for conversion of solar energy into both electrical energy and chemical energy are discussed with emphasis on how the various material properties of the photoactive electrodes influence device efficiency and stability. The similarity between photoelectrochemical cells (PECs) and solid state devices is used to model their behaviour and optimize such parameters as band gap, doping level, minority carrier lifetime, etc. A model is presented which calculates the electron affinity of any semiconductor and allows the prediction of the open circuit voltage of wet photovoltaic cells and optimum biasing forchemical producing cells. The effects of absorbed ions at the semiconductor/electrolyte interface are reviewed. The temperature dependence of the energy levels in the semiconductor and the electrolyte are considered and the implications of these results to operation of PECs at elevated temperature are discussed. The major differences between PECs and solid state devices are the stability considerations. The thermodynamics of this problem is discussed. Other important degradation mechanisms and some solutions to these problems are reviewed. Finally, a prognosis of the future of this field is presented.

D. S. Ginley

Papers

Principles of photoelectrochemical, solar energy conversion