Biocomposites reinforced with natural fibers: 2000–2010

Recently, there has been a rapid growth in research and innovation in the natural fibre composite (NFC) area. Interest is warranted due to the advantages of these materials compared to others, such as synthetic fibre composites, including low environmental impact and low cost and support their potential across a wide range of applications. Much effort has gone into increasing their mechanical performance to extend the capabilities and applications of this group of materials. This review aims to provide an overview of the factors that affect the mechanical performance of NFCs and details achievements made with them.

A review of recent developments in natural fibre composites and their mechanical performance

https://hal.archives-ouvertes.fr/hal-02119698/document

Mechanical properties of components fabricated with open-source 3-D printers under realistic environmental conditions

This study provides a bibliographic review in the broad field of green composites seeking-out for materials with a potential to be applied in the near future on automotive body panels. Hereupon, materials deriving from renewable resources will be preferred as opposed to the exhaustible fossil products. With the technical information of bio-polymers and natural reinforcements a database was created with the mechanical performance of several possible components for the prospect green composite. Following the review, an assessment is performed where aspects of suitability for the candidate elements in terms of mechanical properties are analyzed. In that section, renewable materials for matrix and reinforcement are screened accordingly in order to identify which hold both adequate strength and stiffness performance along with affordable cost so as to be a promising proposal for a green composite.

Green composites: A review of adequate materials for automotive applications

PLA composites: From production to properties

PLA biocomposites with abaca and man-made cellulose fibres were processed by using combined moulding technology: two-step extrusion coating process and consecutively injection moulding. By adding 30 wt% of man-made cellulose, the Charpy impact strength at ambient temperature increased by factor 3.60, compared to unreinforced PLA. Tensile strength rose by factor 1.45 and stiffness by approx. 1.75. Reinforcing with abaca fibres (30 wt%) enhanced both E-Modulus and tensile strength by factor 2.40 and 1.20, respectively. The Charpy A-notch impact resistance of PLA/abaca could be improved by factor 2.4. SEM photographs show fibre pull-outs from the polymer matrix. The fibre orientation was analysed via optical microscopy. The after-process fibre length was significantly affected already during compounding process.

Dietrich Scherzer

Papers

Mechanical properties of PLA composites with man-made cellulose and abaca fibres