There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality.

Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

I and i

The aim of this paper is to present a review of current control techniques for three-phase voltage-source pulsewidth modulated converters. Various techniques, different in concept, have been described in two main groups: linear and nonlinear. The first includes proportional integral (stationary and synchronous) and state feedback controllers, and predictive techniques with constant switching frequency. The second comprises bang-bang (hysteresis, delta modulation) controllers and predictive controllers with on-line optimization. New trends in current control-neural networks and fuzzy-logic-based controllers-are discussed, as well. Selected oscillograms accompany the presentation in order to illustrate properties of the described controller groups.

Current control techniques for three-phase voltage-source PWM converters: a survey

Solid-state switch-mode rectification converters have reached a matured level for improving power quality in terms of power-factor correction (PFC), reduced total harmonic distortion at input AC mains and precisely regulated DC output in buck, boost, buck-boost and multilevel modes with unidirectional and bidirectional power flow. This paper deals with a comprehensive review of improved power quality converters (IPQCs) configurations, control approaches, design features, selection of components, other related considerations, and their suitability and selection for specific applications. It is targeted to provide a wide spectrum on the status of IPQC technology to researchers, designers and application engineers working on switched-mode AC-DC converters. A classified list of more than 450 research publications on the state of art of IPQC is also given for a quick reference.

/pdf/a-review-of-single-phase-improved-power-quality-ac-dc-2pm6h4zjxq.pdf

A review of single-phase improved power quality AC-DC converters

The authors discuss high-voltage power conversion. Conventional series connection and three-level voltage source inverter techniques are reviewed and compared. A novel versatile multilevel commutation cell is introduced: it is shown that this topology is safer and more simple to control, and delivers purer output waveforms. The authors show how this technique can be applied to either choppers or voltage-source inverters and generalized to any number of switches.<<ETX>>

Multi-level conversion : high voltage choppers and voltage-source inverters

This is the second-part paper of the survey on fault diagnosis and fault-tolerant techniques, where fault diagnosis methods and applications are overviewed, respectively, from the knowledge-based and hybrid/active viewpoints. With the aid of the first-part survey paper, the second-part review paper completes a whole overview on fault diagnosis techniques and their applications. Comments on the advantages and constraints of various diagnosis techniques, including model-based, signal-based, knowledge-based, and hybrid/active diagnosis techniques, are also given. An overlook on the future development of fault diagnosis is presented.

A Survey of Fault Diagnosis and Fault-Tolerant Techniques—Part II: Fault Diagnosis With Knowledge-Based and Hybrid/Active Approaches

In this paper, a fast voltage control strategy of three-phase AC/DC pulsewidth modulation (PWM) converters applying a feedback linearization technique is proposed. First, incorporating the power balance of the input and output sides in system modeling, a nonlinear model of the PWM converter is derived with state variables such as AC input currents and DC output voltage. Then, by input-output feedback linearization, the system is linearized and a state feedback control law is obtained by pole placement. With this control scheme, output voltage responses become faster than those in a conventional cascade control structure. For robust control to parameter variations, integrators are added to the exact feedback control law. Since the fast voltage control is feasible for load changes, it is shown that the DC electrolytic capacitor size can be reduced. In addition, the capacitor current is analyzed for size reduction of the capacitor. As is usual with PWM converters, the input current is regulated to be sinusoidal and the source power factor can be controlled at unity. The experimental results are provided to verify the validity of the proposed control algorithm for a 1.5 kVA insulated gate bipolar transistor PWM converter system.

DC-bus voltage control of three-phase AC/DC PWM converters using feedback linearization

This paper proposes a low-voltage ride-through technique of a doubly fed induction generator (DFIG) wind turbine system using a dynamic voltage restorer (DVR). For effective control of the DVR, digital all-pass filters are used for extracting the positive-sequence component from the unbalanced grid voltage since they have the advantages of giving a desired phase shift and no magnitude reduction over conventional low- or high-pass filters. Using the positive-sequence component, the phase angles for the positive- and negative-sequence components of the grid voltage are derived. A control algorithm for the DVR that is dual voltage controllers only is implemented for the two sequence components in the dq synchronous reference frame. In order to achieve the power rating reduction of the DVR, the stator power reference for the DFIG is reduced during faults. In addition, a control scheme of pitch angle system is applied to stabilize the operation of the wind turbine system in the event of grid faults. PSCAD/EMTDC simulations show the effectiveness of the proposed technique and a feasibility of reducing the power rating of DVR for the fault ride-through capability of DFIG. The validity of the proposed control scheme for the DVR has also been verified by experimental results.

A Fault Ride-Through Technique of DFIG Wind Turbine Systems Using Dynamic Voltage Restorers

This paper proposes a low-voltage ride-through scheme for the permanent magnet synchronous generator (PMSG) wind power system at the grid voltage sag. The dc-link voltage is controlled by the generator-side converter instead of the grid-side converter (GSC). Considering the nonlinear relationship between the generator speed ωm and the dc-link voltage Vdc , a dc-link voltage controller is designed using a feedback linearization theory. The GSC controls the grid active power for a maximum power point tracking. The validity of this control algorithm has been verified by simulation and experimental results for a reduced-scale PMSG wind turbine simulator.

LVRT Scheme of PMSG Wind Power Systems Based on Feedback Linearization

In this paper, a novel overmodulation technique for space-vector pulsewidth modulation (PWM) inverters is proposed. The overmodulation range is divided into two modes depending on the modulation index (MI). In mode I, the reference angles are derived from the Fourier series expansion of the reference voltage which corresponds to the MI. In mode II, the holding angles are also derived in the same way. The strategy, which is easier to understand graphically, produces a linear relationship between the output voltage and the MI up to six-step operation. The relationship between those angles and the MI can be written in lookup tables or, for real-time implementation, can be piecewise linearized. In addition, harmonic components and total harmonic distortion (THD) of the output voltage are analyzed. When the method is applied to the V/f control of an induction motor, a smooth operation during transition from the linear control range to the six-step mode is demonstrated through experimental results.

A novel overmodulation technique for space vector PWM inverters

In this paper, an advanced pitch angle control strategy based on the fuzzy logic is proposed for the variable-speed wind turbine systems, in which the generator output power and speed are used as control input variables for the fuzzy logic controller (FLC). The pitch angle reference is produced by the FLC, which can compensate for the nonlinear characteristic of the pitch angle to the wind speed. With the control variables of the generator output power and speed, the wind turbine is smoothly controlled to maintain the aerodynamic power and its speed at the rated values without any fluctuation in the output power and speed in the high-wind-speed regions. The effectiveness of the proposed method is verified by simulation results for a 2-MW permanent-magnet synchronous generator (PMSG) wind turbine system, and experimental results for a reduced-scale PMSG wind turbine simulator.

Dong-Choon Lee

Papers

DC-bus voltage control of three-phase AC/DC PWM converters using feedback linearization

A Fault Ride-Through Technique of DFIG Wind Turbine Systems Using Dynamic Voltage Restorers

LVRT Scheme of PMSG Wind Power Systems Based on Feedback Linearization

A novel overmodulation technique for space vector PWM inverters

Advanced Pitch Angle Control Based on Fuzzy Logic for Variable-Speed Wind Turbine Systems