Structural health monitoring (SHM) technology has been successfully applied to understand the loads, environment actions, and behaviors of a structure subjected to various actions through solving a...

Structural Health Monitoring in mainland China: Review and Future Trends

EIS analysis on chloride-induced corrosion behavior of reinforcement steel in simulated carbonated concrete pore solutions

Electrochemical noise (EN), as one of the most promising in situ electrochemical methods in corrosion and electrochemical science, has been developing rapidly in recent years with the advancements in instrumentation and signal processing methods. One advantage of EN is its application in long-term or early stage corrosion process monitoring because it instantly detects corrosion rate and corrosion forms. Investigators have applied various mathematical methods to extract characteristic parameters from EN. In this paper, identifying corrosion forms using parameters obtained from time domain, frequency domain and time–frequency domain is reviewed, and the correlation between parameters and corrosion forms is discussed. Finally, other in situ techniques are recommended to be employed synchronously with EN measurement in order to obtain reliable analyses.

Detection of corrosion degradation using electrochemical noise (EN): review of signal processing methods for identifying corrosion forms

Initiation and repassivation of pitting corrosion of carbon steel in carbonated concrete pore solution

In this paper, a novel kind of method to monitor corrosion expansion of steel rebars in steel reinforced concrete structures named fiber optic coil winding method is proposed, discussed and tested. It is based on the fiber optical Brillouin sensing technique. Firstly, a strain calibration experiment is designed and conducted to obtain the strain coefficient of single mode fiber optics. Results have shown that there is a good linear relationship between Brillouin frequency and applied strain. Then, three kinds of novel fiber optical Brillouin corrosion expansion sensors with different fiber optic coil winding packaging schemes are designed. Sensors were embedded into concrete specimens to monitor expansion strain caused by steel rebar corrosion, and their performance was studied in a designed electrochemical corrosion acceleration experiment. Experimental results have shown that expansion strain along the fiber optic coil winding area can be detected and measured by the three kinds of sensors with different measurement range during development the corrosion. With the assumption of uniform corrosion, diameters of corrosion steel rebars were obtained using calculated average strains. A maximum expansion strain of 6,738 μe was monitored. Furthermore, the uniform corrosion analysis model was established and the evaluation formula to evaluate mass loss rate of steel rebar under a given corrosion rust expansion rate was derived. The research has shown that three kinds of Brillouin sensors can be used to monitor the steel rebar corrosion expansion of reinforced concrete structures with good sensitivity, accuracy and monitoring range, and can be applied to monitor different levels of corrosion. By means of this kind of monitoring technique, quantitative corrosion expansion monitoring can be carried out, with the virtues of long durability, real-time monitoring and quasi-distribution monitoring.

/pdf/brillouin-corrosion-expansion-sensors-for-steel-reinforced-4ohxm8yb3y.pdf

Guofu Qiao

Papers

Corrosion monitoring of reinforcing steel in cement mortar by EIS and ENA