Enhanced dielectric properties and electrical responses of cobalt-doped CaCu3Ti4O12 thin films

Effect of SnO2 doping on microstructural and electrical properties of ZnO–Pr6O11 based varistor ceramics

Improved dielectric and non-ohmic properties of (Zn + Zr) codoped CaCu3Ti4O12 thin films

Significantly improved non-Ohmic and giant dielectric properties of CaCu3-xZnxTi4O12 ceramics by enhancing grain boundary response

Influence of sintering conditions on microstructure and electrical properties of CaCu3Ti4O12 (CCTO) ceramics

Influence of zinc on electrical and microstructural properties of CaCu3Ti4O12 ceramics prepared by sol–gel process

Microstructure and electrical properties of Sc2O3-doped ZnO–Bi2O3-based varistor ceramics

Effect of AETiO3 (AE = Mg, Ca, Sr) doping on dielectric and varistor characteristics of CaCu3Ti4O12 ceramic prepared by the sol–gel process

http://www.ysxbcn.com/down/paperDown.aspx?id=32362

Effects of high-energy ball milling oxide-doped and varistor ceramic powder on ZnO varistor

In this work, the influence of Lu 2 O 3 doped on the dielectric and electrical properties of CaCu 3 Ti 4 O 12 was reported. Lu 2 O 3 -doped CCTO was prepared by a conventional solid state technique using CuO, TiO 2 , and CaCO 3 as starting materials. The samples were studied by X-ray diffraction (XRD) and scanning electron microscopy (SEM); dielectric measurements were measured in the 10 2  Hz–10 7  Hz frequency range at room temperature; and the nonlinear behavior of all samples was measured. The doping of Lu 2 O 3 resulted in an increase in the dielectric constant of CCTO, but decreased the stability of the frequency dependence. Increasing concentrations of Lu 2 O 3 resulted in decreasing nonlinear coefficients.

Influence of Lu2O3 on electrical and microstructural properties of CaCu3Ti4O12 ceramics

Guoping Zhao

Papers

Influence of zinc on electrical and microstructural properties of CaCu3Ti4O12 ceramics prepared by sol–gel process

Microstructure and electrical properties of Sc2O3-doped ZnO–Bi2O3-based varistor ceramics

Effect of AETiO3 (AE = Mg, Ca, Sr) doping on dielectric and varistor characteristics of CaCu3Ti4O12 ceramic prepared by the sol–gel process

Effects of high-energy ball milling oxide-doped and varistor ceramic powder on ZnO varistor

Influence of Lu2O3 on electrical and microstructural properties of CaCu3Ti4O12 ceramics