An Integrated Agent Architecture for Software Defined Radio. Rapid-prototype cognitive radio, CR1, was developed to apply these.The modern software defined radio has been called the heart of a cognitive radio. Cognitive radio: an integrated agent architecture for software defined radio. Http:bwrc.eecs.berkeley.eduResearchMCMACR White paper final1.pdf. The cognitive radio, built on a software-defined radio, assumes. Radio: An Integrated Agent Architecture for Software Defined Radio, Ph.D. The need for software-defined radios is underlined and the most important notions used for such. Mitola III, Cognitive radio: an integrated agent architecture for software defined radio, Ph.D. This results in the set-theoretic ontology of radio knowledge defined in the. Cognitive Radio An Integrated Agent Architecture for Software.This article first briefly reviews the basic concepts about cognitive radio CR. Cognitive Radio-An Integrated Agent Architecture for Software Defined Radio. Cognitive Radio RHMZ 2007. Software-defined radio SDR idea 1. Cognitive radio: An integrated agent architecture for software.Cognitive Radio SOFTWARE DEFINED RADIO, AND ADAPTIVE WIRELESS SYSTEMS2 Cognitive Networks. 3 Joseph Mitola III, Cognitive Radio: An Integrated Agent Architecture for Software Defined Radio Stockholm.

/pdf/cognitive-radio-an-integrated-agent-architecture-for-1v855bviue.pdf

Cognitive Radio An Integrated Agent Architecture for Software Defined Radio

The demand for wireless mobile communications services is growing at an explosive rate, with the anticipation that communication to a mobile device anywhere on the globe at all times will be available in the near future. An array of antennas mounted on vehicles, ships, aircraft, satellites, and base stations is expected to play an important role in fulfilling the increased demand of channel requirement for these services, as well as for the realization of the dream that a portable communications device the size of a wristwatch be available at an affordable cost for such services. This paper is the first of a two-part study. It provides a comprehensive treatment, at a level appropriate to nonspecialists, of the use of an antenna array to enhance the efficiency of mobile communications systems. It presents an overview of mobile communications as well as details of how an array may be used in various mobile communications systems, including land-mobile, indoor-radio, and satellite-based systems. It discusses advantages of an array of antennas in a mobile communications system, highlights improvements that are possible by using multiple antennas compared to a single antenna in a system, and provides details on the feasibility of antenna arrays for mobile communications applications.

/pdf/applications-of-antenna-arrays-to-mobile-communications-i-4vrvp7rdiu.pdf

Applications of antenna arrays to mobile communications. I. Performance improvement, feasibility, and system considerations

Multiple-input-multiple-output (MIMO) wireless systems use multiple antenna elements at transmit and receive to offer improved capacity over single antenna topologies in multipath channels In such systems, the antenna properties as well as the multipath channel characteristics play a key role in determining communication performance This paper reviews recent research findings concerning antennas and propagation in MIMO systems Issues considered include channel capacity computation, channel measurement and modeling approaches, and the impact of antenna element properties and array configuration on system performance Throughout the discussion, outstanding research questions in these areas are highlighted

/pdf/a-review-of-antennas-and-propagation-for-mimo-wireless-1xbqo9fzkp.pdf

A review of antennas and propagation for MIMO wireless communications

In order to estimate the signal parameters accurately for mobile systems, it is necessary to estimate a system's propagation characteristics through a medium. Propagation analysis provides a good initial estimate of the signal characteristics. The ability to accurately predict radio-propagation behavior for wireless personal communication systems, such as cellular mobile radio, is becoming crucial to system design. Since site measurements are costly, propagation models have been developed as a suitable, low-cost, and convenient alternative. Channel modeling is required to predict path, loss and to characterize the impulse response of the propagating channel. The path loss is associated with the design of base stations, as this tells us how much a transmitter needs to radiate to service a given region. Channel characterization, on the other hand, deals with the fidelity of the received signals, and has to do with the nature of the waveform received at a receiver. The objective here is to design a suitable receiver that will receive the transmitted signal, distorted due to the multipath and dispersion effects of the channel, and that will decode the transmitted signal. An understanding of the various propagation models can actually address both problems. This paper begins with a review of the information available on the various propagation models for both indoor and outdoor environments. The existing models can be classified into two major classes: statistical models and site-specific models. The main characteristics of the radio channel - such as path loss, fading, and time-delay spread - are discussed. Currently, a third alternative, which includes many new numerical methods, is being introduced to propagation prediction. The advantages and disadvantages of some of these methods are summarized. In addition, an impulse-response characterization for the propagation path is also presented, including models for small-scale fading, Finally, it is shown that when two-way communication ports can be defined for a mobile system, it is possible to use reciprocity to focus the energy along the direction of an intended user without any explicit knowledge of the electromagnetic environment in which the system is operating, or knowledge of the spatial locations of the transmitter and the receiver.

A survey of various propagation models for mobile communication

We provide a comprehensive overview of mathematical models and analytical techniques for millimeter wave (mmWave) cellular systems. The two fundamental physical differences from conventional sub-6-GHz cellular systems are: 1) vulnerability to blocking and 2) the need for significant directionality at the transmitter and/or receiver, which is achieved through the use of large antenna arrays of small individual elements. We overview and compare models for both of these factors, and present a baseline analytical approach based on stochastic geometry that allows the computation of the statistical distributions of the downlink signal-to-interference-plus-noise ratio (SINR) and also the per link data rate, which depends on the SINR as well as the average load. There are many implications of the models and analysis: 1) mmWave systems are significantly more noise-limited than at sub-6 GHz for most parameter configurations; 2) initial access is much more difficult in mmWave; 3) self-backhauling is more viable than in sub-6-GHz systems, which makes ultra-dense deployments more viable, but this leads to increasingly interference-limited behavior; and 4) in sharp contrast to sub-6-GHz systems cellular operators can mutually benefit by sharing their spectrum licenses despite the uncontrolled interference that results from doing so. We conclude by outlining several important extensions of the baseline model, many of which are promising avenues for future research.

Modeling and Analyzing Millimeter Wave Cellular Systems

To acquire a knowledge of radio propagation characteristics in the microcellular environments for personal communications services (PCS), a comprehensive measurement program was conducted by Telesis Technologies Laboratory (TTL) in the San Francisco Bay area using three base station antenna heights of 3.2 m, 8.7 m, and 13.4 m and two frequencies at 900 MHz and 1900 MHz. Five test settings were chosen in urban, suburban, and rural areas in order to study propagation in a variety of environments. This paper reports the LOS measurements in different environments, all of which show variations of signal strength with distance that have distinct near and far regions separated by a break point. It was also found that the location of the break point for different frequencies and antenna heights can be calculated based on first Fresnel zone clearance. The regression analysis reveals a slope that is less than two before the break point, while it is greater than two after the break point. This break distance can be used to define the size of microcell and to design for fast hand-off. Beyond the first Fresnel zone break distance the base station antenna height gain was observed to approximately follow the square power law of antenna height. >

http://materias.fi.uba.ar/6654/download/Radio%20propagation.pdf

Radio propagation characteristics for line-of-sight microcellular and personal communications

Propagation characteristics of radio signals in the UHF band place fundamental limits on the design and performance of wireless personal communications systems, such as cellular mobile radio (CMR), wireless LANs, and personal communication services (PCS). Because the radio link is direct to each subscriber, the prediction of signal characteristics is most important in urban areas where subscriber density is high, and the buildings have a profound influence on the propagation. The paper starts by reviewing the characteristic signal variations observed in CMR systems employing high base station antennas to cover macrocells having radius out to 20 km. Theoretical models incorporating diffraction are shown to explain the observed range dependence and shadow loss statistics. For the low base station antennas envisioned to cover microcells of radius out to 1 km for PCS applications, signal propagation is more strongly dependent on the building environment and on the location of the antennas in relation to the buildings. Various levels of theoretical modeling of this dependence are discussed in conjunction with measurements made in various building environments. Finally, the paper discusses advances in site specific prediction for outdoor and indoor propagation. >

UHF propagation prediction for wireless personal communications

New microcellular systems have been proposed to operate over short radio paths by using low-base station antennas, and transmitting at low power. In order to study radio propagation in the microcellular environments for future personal communications services (PCS), comprehensive radio propagation measurements were conducted by Telesis Technologies Laboratory (TTL) in the San Francisco Bay area using three transmitting antenna heights of 3.2, 8.7, and 13.4 m and two frequencies in the 900 and 1900 MHz bands. The paper reports the path loss measurements made in urban and suburban areas where the receiving mobile was driven along preselected line-of-sight (LOS), zig-zag, and staircase routes to gather information about direct propagation along streets, as well as diffraction over the roofs in suburban areas, and diffraction around the corners in urban areas. The results obtained for the three antenna heights are studied, and show the height gain that can be expected for microcells in different environments. >

Microcellular propagation characteristics for personal communications in urban and suburban environments

One of the key characteristics of IMT-2000 is the advanced radio technologies that will offer a whole new range of capabilities to the users of international mobile telecommunications. This article starts by comparing the significant differences between second-generation mobile systems and the major objectives envisioned for IMT-2000, with particular emphasis on the satellite component. It also describes the flexible modular architecture for IMT-2000, which will facilitate the introduction and evolution of new capabilities. The article overviews the technology facilitators that, by the year 2000, will greatly assist the economic implementation of these new systems. Finally, the ITU process for the selection of radio technologies that will fulfil these ambitious requirements is also outlined.

IMT-2000 standards: radio aspects

A knowledge of radio propagation characteristics in the microcell environment is recognized to be essential for future frequency allocation and system implementation of proposed personal communications services (PCS). A comprehensive radio propagation measurement program in the San Francisco Bay area is discussed. Measurements were performed using three transmitting antenna heights of 3.2 m, 8.7 m, and 13.4 m and two frequencies in the 900 MHz and 1900 MHz bands. Five test settings were chosen in urban, suburban, and rural areas in order to study propagation in a variety of environments. For all LOS measurements even in different environments, the variation of signal strength with distance was found to show distinct ear and far regions separated by a break point. It was also found that the location of the break point for different frequencies and antenna heights could be calculated based on first Fresnel zone clearance. The regression analysis shows a slope that is less than two before the break point, while it is greater than two after the break point. This break distance can be used to define the size of the microcell and to design for fast hand-off. >

H.H. Xia

Papers

Radio propagation characteristics for line-of-sight microcellular and personal communications

UHF propagation prediction for wireless personal communications

Microcellular propagation characteristics for personal communications in urban and suburban environments

IMT-2000 standards: radio aspects

Radio propagation measurements and modelling for line-of-sight microcellular systems