Statistics for Spatial Data.

[1] The Shuttle Radar Topography Mission produced the most complete, highest-resolution digital elevation model of the Earth. The project was a joint endeavor of NASA, the National Geospatial-Intelligence Agency, and the German and Italian Space Agencies and flew in February 2000. It used dual radar antennas to acquire interferometric radar data, processed to digital topographic data at 1 arc sec resolution. Details of the development, flight operations, data processing, and products are provided for users of this revolutionary data set.

/pdf/the-shuttle-radar-topography-mission-4x49lt5xnj.pdf

The Shuttle Radar Topography Mission

Temporal and geometrical decorrelation often prevents SAR interferometry from being an operational tool for surface deformation monitoring and topographic profile reconstruction. Moreover, atmospheric disturbances can strongly compromise the accuracy of the results. The authors present a complete procedure for the identification and exploitation of stable natural reflectors or permanent scatterers (PSs) starting from long temporal series of interferometric SAR images. When, as it often happens, the dimension of the PS is smaller than the resolution cell, the coherence is good even for interferograms with baselines larger than the decorrelation one, and all the available images of the ESA ERS data set can be successfully exploited. On these pixels, submeter DEM accuracy and millimetric terrain motion detection can be achieved, since atmospheric phase screen (APS) contributions can be estimated and removed. Examples are then shown of small motion measurements, DEM refinement, and APS estimation and removal in the case of a sliding area in Ancona, Italy. ERS data have been used.

Permanent scatterers in SAR interferometry

We present a new differential synthetic aperture radar (SAR) interferometry algorithm for monitoring the temporal evolution of surface deformations. The presented technique is based on an appropriate combination of differential interferograms produced by data pairs characterized by a small orbital separation (baseline) in order to limit the spatial decorrelation phenomena. The application of the singular value decomposition method allows us to easily "link" independent SAR acquisition datasets, separated by large baselines, thus increasing the observation temporal sampling rate. The availability of both spatial and temporal information in the processed data is used to identify and filter out atmospheric phase artifacts. We present results obtained on the data acquired from 1992 to 2000 by the European Remote Sensing satellites and relative to the Campi Flegrei caldera and to the city of Naples, Italy, that demonstrate the capability of the proposed approach to follow the dynamics of the detected deformations.

/pdf/a-new-algorithm-for-surface-deformation-monitoring-based-on-ot8ep5chnm.pdf

A new algorithm for surface deformation monitoring based on small baseline differential SAR interferograms

On February 22, 2000 Space Shuttle Endeavour landed at Kennedy Space Center, completing the highly successful 11-day flight of the Shuttle Radar Topography Mission (SRTM). Onboard were over 300 high-density tapes containing data for the highest resolution, most complete digital topographic map of Earth ever made. SRTM is a cooperative project between NASA and the National Imagery and Mapping Agency (NIMA) of the U.S. Department of Defense. The mission was designed to use a single-pass radar interferometer to produce a digital elevation model (DEM) of the Earth's land surface between about 60 deg north and 56 deg south latitude. When completed, the DEM will have 30 m pixel spacing and about 15 m vertical accuracy. Two orthorectified image mosaics (one from the ascending passes with illumination from the southeast and one from descending passes with illumination from the southwest) will also be produced.

ABoVE: Active Layer Thickness Derived from Airborne L- and P-band SAR, Alaska, 2017

Titan's Empty Lake Basins: Constraining Surface Physical Properties by Investigating Radar Backscatter Behavior at Multiple Incidence Angles

A Depth Profile of Titan's Ontario Lacus and Further Constraints on Wave Heights from Cassini RADAR Data

Cassini RADAR Observations of the Nature and Seasonal Varibility of Titan's Lakes

Progress, significant results, publications and future plans are discussed in relation to the following objectives: (1) To model, experimentally characterize, and verify penetration phenomena in hyperarid and vegetated regions using the SIR-C/X-SAR multiparameter radar system and groundbased receivers; (2) To invert measured radar backscatter as a function of frequency and polarization in terms of geophysical parameters of the surface, subsurface and vegetation canopy such as surface roughness, subsurface geomorphology, or tree height and density; and (3) To display subsurface and within-canopy features in an image format, thus easing the interpretability of the results.

Howard A. Zebker

Papers

ABoVE: Active Layer Thickness Derived from Airborne L- and P-band SAR, Alaska, 2017

Titan's Empty Lake Basins: Constraining Surface Physical Properties by Investigating Radar Backscatter Behavior at Multiple Incidence Angles

A Depth Profile of Titan's Ontario Lacus and Further Constraints on Wave Heights from Cassini RADAR Data

Cassini RADAR Observations of the Nature and Seasonal Varibility of Titan's Lakes

Radar Interferometric and Penetration Investigations using SIR-C Data