Development of wear maps of in-situ TiC+TiB2 reinforced AZ91 Mg matrix composite with varying microstructural conditions

Influence of SiC ceramic reinforcement size in establishing wear mechanisms and wear maps of ultrafine grained AA6063 composites

In this paper, the primary synthesis and secondary treatment of Aluminium matrix composites (AMCs) has been reviewed. The renewed quest for component materials with high strength-to-weight ratio, u...

A review on primary synthesis and secondary treatment of aluminium matrix composites

The mechanical properties and microstructure of Al-Cu-Li alloy sheets subjected to cryorolling (−100 °C, −190 °C) or hot rolling (400 °C) and subsequent aging at 160 °C for different times were investigated. The dynamic precipitation and dislocation characterizations were examined via transmission electron microscopy and X-ray diffraction. The grain morphologies and the fracture-surface morphologies were studied via optical microscopy and scanning electron microscopy. Samples subjected to cryorolling followed by aging exhibited relatively high dislocation densities and a large number of precipitates compared with hot-rolled samples. The samples cryorolled at −190 °C and then aged for 15 h presented the highest ultimate tensile strength (586 MPa), while the alloy processed via hot rolling followed by 10 h aging exhibited the highest uniform elongation rate (11.5%). The size of precipitates increased with the aging time, which has significant effects on the interaction mechanism between dislocations and precipitates. Bowing is the main interaction method between the deformation-induced dislocations and coarsened precipitates during tensile tests, leading to the decline of the mechanical properties of the alloy during overaging. These interesting findings can provide significant insights into the development of materials possessing both excellent strength and high ductility.

Mechanical properties and microstructure evolution of an Al-Cu-Li alloy subjected to rolling and aging

Aluminum–copper alloy system is extensively used in structural and aerospace applications for its high strength-to-weight ratio, good mechanical and tribological properties. Improving the properties of these alloys would likely widen their application area. In the present work, an attempt has been made to simultaneously enhance the wear resistance and mechanical properties of an Al–Cu alloy, AA2014 by imparting different levels of cryorolling strains and postroll aging treatment. The wear behavior of the material is studied under dry sliding condition by pin-on-disk experiments and mechanical properties are assessed by tensile test. Formation of high fraction of dislocation density and significant refinement of microstructure during cryorolling and nucleation of fine coherent Guinier–Preston (GP) zones of Al2Cu precipitates during postcryoroll aging has led to about 100% increment in the wear resistance of the material. Tensile test results proved that the synergetic effect of cryorolling and aging treatment led to 53% increment in strength (557 MPa) without compromising the material's ductility (22.5%). A detailed investigation on the various mechanisms responsible for the enhanced wear resistance and improved mechanical performance is presented based on the microstructural evidence.

I. Jaseem

Papers

Synergetic Effect of Cryorolling and Postroll Aging on Simultaneous Increase in Wear Resistance and Mechanical Properties of an Al–Cu Alloy