The absorption and emission properties of transition metal (TM)-doped zinc chalcogenides have been investigated to understand their potential application as room-temperature, mid-infrared tunable laser media. Crystals of ZnS, ZnSe, and ZnTe, individually doped with Cr/sup 2+/, Co/sup 2+/, Ni/sup 2+/, or Fe/sup 2+/ have been evaluated. The absorption and emission properties are presented and discussed in terms of the energy levels from which they arise. The absorption spectra of the crystals studied exhibit strong bands between 1.4 and 2.0 /spl mu/m which overlap with the output of strained-layer InGaAs diodes. The room-temperature emission spectra reveal wide-band emissions from 2-3 /spl mu/m for Cr and from 2.8-4.0 /spl mu/m for Co, Cr luminesces strongly at room temperature; Co exhibits significant losses from nonradiative decay at temperatures above 200 K, and Ni and Fe only luminesce at low temperatures, Cr/sup 2+/ is estimated to have the highest quantum yield at room temperature among the media investigated with values of /spl sim/75-100%. Laser demonstrations of Cr:ZnS and Cr:ZnSe have been performed in a laser-pumped laser cavity with a Co:MgF/sub 2/ pump laser. The output of both lasers were determined to peak at wavelengths near 2.35 /spl mu/m, and both lasers demonstrated a maximum slope efficiency of approximately 20%. Based on these initial results, the Cr/sup 2+/ ion is predicted to be a highly favorable laser ion for the mid-IR when doped into the zinc chalcogenides; Co/sup 2+/ may also serve usefully, but laser demonstrations yet remain to be performed.

Transition metal-doped zinc chalcogenides: Spectroscopy and laser demonstration of a new class of gain media

After a brief examination of known insulating laser crystals and the stimulated emission channels of their generating activator ions, this article reviews recent advances in the development of novel lasing crystals and ceramics, as well as inorganic and organic nonlinear-laser crystals for χ(3) and cascaded χ(3) ↔ χ(2) frequency converters Several new modern attractive technologies in the physics and techniques of crystalline lasers are also discussed

https://onlinelibrary.wiley.com/doi/pdf/10.1002/lpor.200710008

Laser crystals and ceramics: recent advances

Transition metal (TM) doped II-VI chalcogenide laser materials offer a unique blend of physical, spectroscopic, and technological parameters that make them the gain media of choice for cost effective broadly tunable lasing in the Mid-IR. The II-VI semiconductor hosts provide a low phonon cut-off, broad IR transparency, and high thermal conductivity. When doped with transition metal ions, these materials feature ultrabroadband gain, low saturation intensities, and large pump absorption coefficients. This combined with the low-cost mass production technology of crystal fabrication by postgrowth thermal diffusion, as well as broad availability of convenient pump sources, make these materials ideal candidates for broadly tunable mid-IR lasing in CW, gain-switched, free running, and mode-locked regimes of operation. This review summarizes experimental results on optically pumped lasers based on Cr and Fe doped II-VI wide band semiconductors providing access to the 1.9-6 μm spectral range with a high (exceeding 60%) efficiency, multi-Watt-level (18 W in gain switch and 30 W in pure CW) output powers, tunability in excess of 1000 nm, short-pulse (<;50 fs) multi-watt oscillation, multi-Joule long-pulse output energy, and narrow spectral linewidth (<;100 kHz).

Progress in Mid-IR Lasers Based on Cr and Fe-Doped II–VI Chalcogenides

Cryogenically cooled solid-state lasers promise a revolution in power scalability while maintaining a good beam quality because of significant improvements in efficiency and thermo-optic properties. This is particularly true for Yb lasers because of their relatively low quantum defect and relatively broadband absorption even at cryogenic temperatures. Thermo-optic properties of host materials, including thermal conductivity, thermal expansion, and refractive index at low temperature, are reviewed and data presented for YAG (ceramic and single crystal), GGG, GdVO4, and Y2O3. Spectroscopic properties of Yb:YAG and Yb:LiYF4 (YLF) including absorption cross sections, emission cross sections, and fluorescence lifetimes at cryogenic temperatures are characterized. Recent experiments have pushed the power from an end-pumped cryogenically cooled Yb:YAG laser to 455-W continuous-wave output power from 640-W incident pump power at an of M2 1.4.

Cryogenic Yb $^{3+}$ -Doped Solid-State Lasers

Recent progress in chromium and iron doped II-VI semiconductor materials makes them the laser sources of choice when one needs a compact system with tunability over 19–51 μm Output powers exceeding 10 W and efficiency up to 70% were demonstrated in several Cr doped semiconductors The unique combination of technological (low-cost ceramic material) and spectroscopic characteristics makes these materials ideal candidates for mid-IR tunable laser systems This article reviews transition metal doped II–VI materials and recent progress in Cr- and Fe-doped solid-state mid-IR lasers

Progress in Cr2+and Fe2+doped mid-IR laser materials

Lasing of Fe:ZnSe is demonstrated, for the first time to the authors’ knowledge, for temperatures ranging from 15 to 180 K.?The output wavelength of the Fe:ZnSe laser was observed to tune with temperature from 3.98 µm at 15 K to 4.54 µm at 180 K.?With an Er:YAG laser operating at 2.698 µm as the pump source, a maximum energy per pulse of 12 µJ at 130 K was produced. Laser slope efficiencies of 3.2% at 19 K and 8.2% at 150 K were determined for an output coupling of 0.6%. A laser emission linewidth of 0.007 µm at 3.98 µm was measured at 15 K.?Absorption and emission spectra and emission lifetimes for Fe:ZnSe are also discussed.

4.0-4.5-mum lasing of Fe:ZnSe below 180 K, a new mid-infrared laser material.

The spectroscopic properties of Fe:ZnSe were investigated and 4 micron lasing action was demonstrated for the first time at sub-ambient temperatures. Using an Er:YAG laser as a pump source, the Fe:ZnSe laser produced output energies of 8 µJ/pulse with pulse lengths of 48 µs at a repetition rate of 100 Hz. The output wavelength varied with temperature from 3.98 µm at 14 K to 4.54 µm at 180 K. A slope efficiency of 6.7% at 130 K was obtained.

/pdf/tunable-laser-action-at-4-0-microns-from-fe-znse-1vwbdnicwb.pdf

J J Adams

Papers

4.0-4.5-mum lasing of Fe:ZnSe below 180 K, a new mid-infrared laser material.

Tunable laser action at 4.0 microns from Fe:ZnSe