Present Situation and Future Trends in Modelling of Machining Operations Progress Report of the CIRP Working Group ‘Modelling of Machining Operations’

The effect of runout on cutting geometry and forces in end milling

In this paper, a summary of work performed in the area of modeling of the dynamic metal cutting process is presented. A general view of evolution of the dynamic cutting process models is depicted. Specifically four modeling approaches including analytical, experimental, mechanistic and numerical methods are critically reviewed. A brief assessment offuture research needs is also given.

Machining Process Modeling: A Review

End milling of die/mold steels is a highly demanding operation because of the temperatures and stresses generated on the cutting tool due to high workpiece hardness. Modeling and simulation of cutting processes have the potential for improving cutting tool designs and selecting optimum conditions, especially in advanced applications such as high-speed milling. The main objective of this study was to develop a methodology for simulating the cutting process in flat end milling operation and predicting chip flow, cutting forces, tool stresses and temperatures using finite element analysis (FEA). As an application, machining of P-20 mold steel at 30 HRC hardness using uncoated carbide tooling was investigated. Using the commercially available software DEFORM-2D™, previously developed flow stress data of the workpiece material and friction at the chip–tool contact at high deformation rates and temperatures were used. A modular representation of undeformed chip geometry was used by utilizing plane strain and axisymmetric workpiece deformation models in order to predict chip formation at the primary and secondary cutting edges of the flat end milling insert. Dry machining experiments for slot milling were conducted using single insert flat end mills with a straight cutting edge (i.e. null helix angle). Comparisons of predicted cutting forces with the measured forces showed reasonable agreement and indicate that the tool stresses and temperatures are also predicted with acceptable accuracy. The highest tool temperatures were predicted at the primary cutting edge of the flat end mill insert regardless of cutting conditions. These temperatures increase wear development at the primary cutting edge. However, the highest tool stresses were predicted at the secondary (around corner radius) cutting edge.

Process simulation using finite element method — prediction of cutting forces, tool stresses and temperatures in high-speed flat end milling

Due to the development of CNC machining centers and automatic programming software, the ball-end milling have become the most widely used machining process for sculptured surfaces. In this study, the ball-end milling process has been analysed, and its cutting force model has been developed to predict the instantaneous cutting force on given machining conditions. The development of the model is based on the analysis of cutting geometry of the ball-end mill with plane rake faces. A cutting edge of the ball-end mill was considered as a series of infinitesimal elements, and the geometry of a cutting edge element was analysed to calculate the necessary parameters for its oblique cutting process assuming that each cutting edge was straight. The oblique cutting process in the small cutting edge element has been analysed as an orthogonal cutting process in the plane containing the cutting velocity and chip flow vectors. And with the orthogonal cutting data obtained from end turning tests on thin-walled tubes over wide range of cutting and tooling conditions, the cutting forces of ball-end milling could be predicted using the model. The predicted cutting forces have shown a fairly good agreement with test results in various machining modes.

J.R. Lindberg

Papers

The prediction of cutting forces in end milling with application to cornering cuts