Showing papers by "Jürgen Mienert published in 2007"

The role of sedimentation rate and permeability in the slope stability of the formerly glaciated Norwegian continental margin: the Storegga slide model

Abstract: Despite the gently dipping slopes (ca 1°), large-scale submarine slope failures have occurred on the mid-Norwegian continental margin (Storegga, Sklinnadjupet, Traenadjupet), suggesting the presence of special conditions predisposing to failure in this formerly glaciated margin. With a volume estimated between 2,400 and 3,200 km3 and an affected area of approximately 95,000 km2, the Storegga slide represents one of the largest and best-studied submarine slides of Holocene age known worldwide. Finite element modeling of slope failure indicates that a large (6.5 < Ms < 7.0) seismic triggering mechanism would not be sufficient to cause failure at more than 110 m below the seabed as observed for the slip planes at Storegga (northern sidewall). This implies that other factors (e.g., liquefaction, strain softening, gas charging, rapid burial) are needed to explain the occurrence of the Storegga slide with a deep surface of failure. In this paper, we discuss the importance of the compaction effect of rapidly accumulated sediments in the slide area. During compaction, sediment grains reorganize themselves, thereby, expelling pore water. Consequently, depending on sedimentation rate and permeability, excess pore pressures might result beneath less permeable sediments. Our modeling and cross-checking illustrate how excess pore pressure generation due to high sedimentation rate could explain the development of layers of weakness, and thus, how such a large slide might have been initiated in deep sediments. Using the highest sedimentation rate estimated in the area (36 and 27 m/kyr between 16.2 and 15 kyr BP), 1D modeling shows excess pore pressure values of around 200 kPa at a depth of 100 m below the seafloor 15 kyr BP and 60 kPa at a depth of 100 m at the time of the slide (8 kyr BP). Excess pore pressure apparently drastically reduced the resistance of the sediment (incomplete consolidation). In addition, 2D modeling shows that permeability anisotropies can significantly affect the lateral extent of excess pore pressure dissipation, affecting, that way, normally consolidated sediments far from the excess pore pressure initiation area.

The Fugløy Reef at 70°N; acoustic signature, geologic, geomorphologic and oceanographic setting

Abstract: This is the first in-depth study of a cluster of cold-water coral reefs, the Fugloy Reefs, found at 70°N on the Norwegian margin. Combining high-resolution seismic reflection data, side-scan sonar, video-images, and oceanographic measurements reveals the geologic, geomorphologic and oceanographic setting in which the reefs occur. The reefs consist mainly of the scleractinian ahermatypic Lophelia pertusa, and exist below the thermocline at water depths between 140 m and 190 m. The reefs appear as cone-shaped, acoustically transparent features on seismic reflection data, consistently located in places characterized by the availability of hard substrate, high relief, and periodical exposure to high tidal currents (>30 cm/s). These currents transport water of the Norwegian Atlantic Current to the reefs from an area with fluid expulsion-related pockmarks. The spatial relationship between reef, pockmark locations, and current directions suggests that seepage of biogenic gas might be a catalyst to reef growth. With a height of more than 40 m some of the Fugloy reefs are among the highest reported from the Norwegian Margin. This indicates highly favourable growth conditions, and conservative estimates indicate a net growth rate for the reefs of ~5 mm/year. We expect that cold-water reefs will be found further north along the Barents Sea margin as general awareness on the geophysical signature and appearance of the reefs increases, because all known factors involved in reef establishment and growth are within the required intervals also further north.