The validity of the cubic law for laminar flow of fluids through open fractures consisting of parallel planar plates has been established by others over a wide range of conditions with apertures ranging down to a minimum of 0.2 µm. The law may be given in simplified form by Q/Δh = C(2b)3, where Q is the flow rate, Δh is the difference in hydraulic head, C is a constant that depends on the flow geometry and fluid properties, and 2b is the fracture aperture. The validity of this law for flow in a closed fracture where the surfaces are in contact and the aperture is being decreased under stress has been investigated at room temperature by using homogeneous samples of granite, basalt, and marble. Tension fractures were artificially induced, and the laboratory setup used radial as well as straight flow geometries. Apertures ranged from 250 down to 4µm, which was the minimum size that could be attained under a normal stress of 20 MPa. The cubic law was found to be valid whether the fracture surfaces were held open or were being closed under stress, and the results are not dependent on rock type. Permeability was uniquely defined by fracture aperture and was independent of the stress history used in these investigations. The effects of deviations from the ideal parallel plate concept only cause an apparent reduction in flow and may be incorporated into the cubic law by replacing C by C/ƒ. The factor ƒ varied from 1.04 to 1.65 in these investigations. The model of a fracture that is being closed under normal stress is visualized as being controlled by the strength of the asperities that are in contact. These contact areas are able to withstand significant stresses while maintaining space for fluids to continue to flow as the fracture aperture decreases. The controlling factor is the magnitude of the aperture, and since flow depends on (2b)3, a slight change in aperture evidently can easily dominate any other change in the geometry of the flow field. Thus one does not see any noticeable shift in the correlations of our experimental results in passing from a condition where the fracture surfaces were held open to one where the surfaces were being closed under stress.

/pdf/validity-of-cubic-law-for-fluid-flow-in-a-deformable-rock-2ynq4id3hq.pdf

VALIDITY OF CUBIC LAW FOR FLUID FLOW IN A DEFORMABLE ROCK FRACTURE - eScholarship

A review of the current progress of CO2 injection EOR and carbon storage in shale oil reservoirs

Experimental study on fracture initiation and propagation in shale using supercritical carbon dioxide fracturing

Simultaneous Multifracture Treatments: Fully Coupled Fluid Flow and Fracture Mechanics for Horizontal Wells

A recently developed unconventional fracture model (UFM) is able to simulate complex fracture network propagation in a formation with pre-existing natural fractures. A method for computing the stress shadow from fracture branches in a complex hydraulic fracture network (HFN) based on an enhanced 2D displacement discontinuity method with correction for finite fracture height is implemented in UFM and is presented in detail including approach validation and examples. The influence of stress shadow effect from the HFN generated at previous treatment stage on the HFN propagation and shape at new stage is also discussed.

Kan Wu

Papers

CO2 injection for enhanced oil recovery in Bakken tight oil reservoirs

Simultaneous Multifracture Treatments: Fully Coupled Fluid Flow and Fracture Mechanics for Horizontal Wells

Mechanisms of Simultaneous Hydraulic-Fracture Propagation From Multiple Perforation Clusters in Horizontal Wells

Numerical Investigation of Complex Hydraulic-Fracture Development in Naturally Fractured Reservoirs

Effect of proppant addition schedule on the proppant distribution in a straight fracture for slickwater treatment