M. Kanthababu

TL;DR: In this article, the effect of wire electrical discharge machining (WEDM) parameters such as pulse-on time (T ON), pulse-off time(T OFF), gap voltage (V) and wire feed (F) on material removal rate (MRR) and surface roughness (R R a) in metal matrix composites (MMCs) consisting of aluminium alloy (Al6063) and silicon carbide (SiCp) is discussed.

TL;DR: In this article, an attempt has been made to monitor the tool condition (in-process) using acoustic emission (AE) sensor in microendmilling of different materials such as aluminum, copper and steel alloys.

TL;DR: In this paper, the effects of tool wear on surface roughness (Ra), chip formation mechanisms and chip morphology in the micro-endmilling of aluminum alloy (AA 1100) using acoustic emission (AE) signals are analyzed in the time domain, frequency domain using fast Fourier transformation (FFT) and the discrete wavelet transformation (DWT) technique.

TL;DR: In this paper, a comprehensive investigation carried out to identify the significant honing parameters and their values for different honing operations was carried out, in which the cylinder liners after boring operation were subjected to rough, finish and plateau honing operation in which parameters such as rotary speed, reciprocating speed, pressure and honing time are selected on the basis of operator's experience.

TL;DR: In this article, the authors proposed a method to generate complete disassembly sequences for mechanical products by utilising the part interference matrix which contains the removal directions of the parts and the part connection graph which indicates the contact among the parts in the assembly.