M.Yu. Zadorozhnyy

TL;DR: PLA/15%HA porous scaffolds obtained by 3D-printing with shape recovery of 98% may be used as self-fitting implant for small bone defect replacement owing to SME and were found to withstand up to three compression-heating-compression cycles without delamination.

TL;DR: It was demonstrated that 3D-printed porous PLA/HA scaffolds support mesenchymal stromal cells survival, and stimulate active proliferation of the cells as well, which has the potential to be used as self-fitting implants for bone replacement and could also be beneficial in the engineering of complex tissues.

TL;DR: A series of nanostructured alloys based on TiFe intermetallic compound were synthesized from the metallic elements in a planetary ball mill by solid state mechanical alloying.

TL;DR: In this article, the mechanism of mechanical alloying (MA) synthesis of TiFe intermetallic compound (IMC) from individual components Ti and Fe has been studied and the partition coefficient of the apparent diffusion and the reaction rate constant during MA solid-state synthesis of the IMC in a planetary ball mill have been estimated.

TL;DR: The influence of homogenization regimes on precipitations of fine Mn-bearing dispersoids, recrystallisation kinetics, grain structure, mechanical properties and superplasticity of cold worked sheets of Al-3Mg alloys with Mn, Cr and Zr is studied in this article.