Analogue modelling of intraplate strike-slip tectonics: A review and new experimental results

Experimental modelling of orogenic wedges: A review

Angles of friction and dilatancy of sand

Basin inversion and contractional reactivation of inherited normal faults: A review based on previous and new experimental models

Abstract We report results of a study comparing numerical models of sandbox-type experiments. Two experimental designs were examined: (1) A brittle shortening experiment in which a thrust wedge is built in material of alternating frictional strength; and (2) an extension experiment in which a weak, basal viscous layer affects normal fault localization and propagation in overlying brittle materials. Eight different numerical codes, both commercial and academic, were tested against each other. Our results show that: (1) The overall evolution of all numerical codes is broadly similar. (2) Shortening is accommodated by in-sequence forward propagation of thrusts. The surface slope of the thrust wedge is within the stable field predicted by critical taper theory. (3) Details of thrust spacing, dip angle and number of thrusts vary between different codes for the shortening experiment. (4) Shear zones initiate at the velocity discontinuity in the extension experiment. The asymmetric evolution of the models is similar for all numerical codes. (5) Resolution affects strain localization and the number of shear zones that develop in strain-softening brittle material. (6) The variability between numerical codes is greater for the shortening than the extension experiment. Comparison to equivalent analogue experiments shows that the overall dynamic evolution of the numerical and analogue models is similar, in spite of the difficulty of achieving an exact representation of the analogue conditions with a numerical model. We find that the degree of variability between individual numerical results is about the same as between individual analogue models. Differences among and between numerical and analogue results are found in predictions of location, spacing and dip angle of shear zones. Our results show that numerical models using different solution techniques can to first order successfully reproduce structures observed in analogue sandbox experiments. The comparisons serve to highlight robust features in tectonic modelling of thrust wedges and brittle-viscous extension.

/pdf/the-numerical-sandbox-comparison-of-model-results-for-a-556s6e4hwx.pdf

The numerical sandbox: Comparison of model results for a shortening and an extension experiment

Mechanical behaviour of granular materials used in analogue modelling: insights from grain characterisation, ring-shear tests and analogue experiments

Comparisons between analogue and numerical models of thrust wedge development

Sandbox experiments on basin inversion: testing the influence of basin orientation and basin fill

Abstract We use both analogue and numerical experiments to study the inversion by shortening of a symmetric sedimentary basin. The combination of the two modelling techniques uses the strengths of each method to provide insight into basin-inversion processes. The experiments start with a pre-existing basin filled, in part, with weak layers simulating weak sedimentary rocks. Both footwall and hanging wall can deform freely. The physical properties of the materials used in the analogue experiments (sand and microbeads) and the numerical experiments are appropriately scaled to represent upper crustal rocks. We present a systematic study of the effects of basin infill, basin width and basin location and a sensitivity analysis to understand the effects of the boundary conditions. The results of both methods show that the graben fill accommodates most shortening. Weak layers play an important role in localising shortening with limited reactivation of pre-existing (but weakened) faults. In general, forward thrusts and back thrusts nucleate at the lateral contrast of strong and weak materials and cut across the graben-bounding faults. Weak basal detachments are required to transfer shortening to the basin region. The overall evolution of the analogue and numerical models is encouragingly similar.

Marion Panien

Papers

Mechanical behaviour of granular materials used in analogue modelling: insights from grain characterisation, ring-shear tests and analogue experiments

Comparisons between analogue and numerical models of thrust wedge development

Sandbox experiments on basin inversion: testing the influence of basin orientation and basin fill

Inversion of a symmetric basin: insights from a comparison between analogue and numerical experiments