M
Mohammed Al-Nehari
Researcher at Taiyuan University of Technology
Publications - 10
Citations - 117
Mohammed Al-Nehari is an academic researcher from Taiyuan University of Technology. The author has contributed to research in topics: Tip-speed ratio & Grinding. The author has an hindex of 2, co-authored 7 publications receiving 42 citations.
Papers
More filters
Journal ArticleDOI
Study the influence of using guide vanes blades on the performance of cross-flow wind turbine
TL;DR: In this article, the best configuration between guide vanes and cross-flow vertical axis wind turbine was investigated to determine the turbine with the highest power coefficient, which increased around 59% of the turbine's performance using GV.
Journal ArticleDOI
Influence of tilt angle and the number of guide vane blades towards the Savonius rotor performance
TL;DR: In this paper, the influence of the guide vanes on the Savonius rotor performance was investigated under different tilt angles, i.e., 0°, 20°, 40°, and 60°.
Journal ArticleDOI
Development and Validation of a Vibration-Based Virtual Sensor for Real-Time Monitoring NOx Emissions of a Diesel Engine
Muhammad Iqbal,Tie Wang,Guoxing Li,Senxiang Li,Guicheng Hu,Tiantian Yang,Fengshou Gu,Mohammed Al-Nehari +7 more
TL;DR: In this paper , a vibration-based virtual NOx sensor is developed based on these critical relationships for real-time NOx monitoring, which is proven to meet the accuracy requirement of vehicle emission monitoring for both steady-state and transient conditions and has a better frequency response compared to the emission measurement system.
Journal ArticleDOI
Comparative study on the joining performance of TiH2 and ZrH2 modified AgCu28 brazing alloys with pulsed laser welding-brazing
TL;DR: In this paper, the authors investigated the addition of elemental Zr to improve the connection effect of alloys and showed that Zr-free brazing alloys inhibited the overproduction of the hard-brittle phase of Cu3Ti and formed other intermetallic compounds such as AgZr2 and Cu10Zr7, which were beneficial to the metallurgical joint.
Posted ContentDOI
Investigation of the wear behavior of abrasive grits in a dry machining Inconel 718 narrow-deep-groove with a single-layer cubic boron nitride grinding wheel
Guang Li,Guoxing Liang,Xingquan Shen,Ming Lv,Donggang Liu,Xinhui Hao,Huang Yonggui,Tochukwu Ojiako Princewill,Mohammed Al-Nehari +8 more
TL;DR: In this paper, the wear behavior of a single-layer electroplated cubic boron nitride (cBN) grinding wheel was investigated in a creep feed grinding Inconel 718 narrow-deep-groove with a width of 2 mm.