N.S. Das

TL;DR: In this paper, the effect of dominant cutting parameters on cutting forces in straight turning of aluminum metal matrix composites under dry cutting condition was evaluated. And the results showed that low cutting forces are associated with the lowest level of depth of cut and the highest level of cutting speed and sensitivity analysis revealed that cutting speed is most significant factor influencing the response variables investigated.

TL;DR: In this article, the effect of certain cutting variables on surface roughness in plain turning of aluminium alloy (LM6) -SiC p metal matrix composites under dry cutting condition is evaluated.

TL;DR: The prevalence of ABO group discrepancy was 0.12% at the authors' center and the causes of discrepancy were analyzed and resolved using anti-A 1 , anti-H, anti-AB, and other immunohematological tests like antibody screening and identification, saliva inhibition test, adsorption-elution studies.

TL;DR: In this article, axisymmetric compression tests on solid composite (LM6/SiCp) cylinders under various lubrication conditions and aspect ratio (height/diameter) suggest that the resulting curvatures of the barrels formed fit closely to circular arcs, the radii of which follow a power law with respect to the true axial compressive stress.

TL;DR: In this article, the deformation behavior of solid aluminium alloy (LM6) and silicon carbide metal matrix composite cylinders under axi-symmetric compression over constant aspect ratios using different lubricants were examined.