Chemical Reviews is published by the American Chemical Society. 1155 Sixteenth Street N.W., Washington, DC 20036 “Green” Atom Transfer Radical Polymerization: From Process Design to Preparation of Well-Defined Environmentally Friendly Polymeric Materials Nicolay V. Tsarevsky, and Krzysztof Matyjaszewski Chem. Rev., 2007, 107 (6), 2270-2299• DOI: 10.1021/cr050947p • Publication Date (Web): 27 May 2007 Downloaded from http://pubs.acs.org on April 2, 2009

"Green" atom transfer radical polymerization: from process design to preparation of well-defined environmentally friendly polymeric materials.

https://www.cell.com/biophysj/pdf/S0006-3495(01)75737-2.pdf

Mesoscopic Simulation of Cell Membrane Damage, Morphology Change and Rupture by Nonionic Surfactants

In the alkoxy-derived sol-gel system, various macroporous morphologies can be obtained by inducing the phase separation parallel to the sol-gel transition. This principle of macroporous morphology control can be best applied to pure silica and silica-based multicomponent oxide systems. The earlier the phase separation takes place than the sol-gel transition, the larger the characteristic sizes of pores and gel skeletons become. The time resolved light scattering measurements revealed that the morphology formation process exhibits the features of spinodal decomposition and that the final gel morphology is determined by the competitive kinetics between the domain coarsening and the structure freezing by sol-gel transition. The mesopore structure of such macroporous gel skeletons could be easily tailored by the solvent exchange procedures. Silica gels with controlled macropores and mesopores were successfully applied as a material for the continuous rod type column for high performance liquid chromatography.

Pore Structure Control of Silica Gels Based on Phase Separation

Surfaces containing poly(ethylene oxide) (PEO) are interesting biomaterials because they exhibit low degrees of protein adsorption and cell adhesion. In this study different molecular weight PEO molecules were covalently attached to poly(ethylene terephthalate) (PET) films using cyanuric chloride chemistry. Prior to the PEO immobilization, amino groups were introduced onto the PET films by exposing them to an allylamine plasma glow discharge. The amino groups on the PET film were next activated with cyanuric chloride and then reacted with bis-amino PEO. The samples were characterized by scanning electron microscopy, water contact angle measurements, gravimetric analysis, and electron spectroscopy for chemical analysis (ESCA). The adsorption of 125I-labeled baboon fibrinogen and bovine serum albumin was studied from buffer solutions. Gravimetric analysis indicated that the films grafted with the low-molecular-weight PEO contained many more PEO molecules than the surfaces grafted with higher-molecular-weight PEO. The high-molecular-weight PEO surfaces, however, exhibited greater wettability (lower water contact angles) and less protein adsorption than the low-molecular-weight PEO surfaces. Adsorption of albumin and fibrinogen to the PEO surfaces decreased with increasing PEO molecular weight up to 3500. A further increase in molecular weight resulted in only slight decreases in protein adsorption. Protein adsorption studies as a function of buffer ionic strength suggest that there may be an ionic interaction between the protein and the allylamine surface. The trends in protein adsorption together with the water contact angle results and the gravimetric analysis suggest that a kind of "cooperative" water structuring around the larger PEO molecules may create an "excluded volume" of the hydrated polymer coils. This may be an important factor contributing to the observed low protein adsorption behavior.

Nobuhiro Kuwahara

Papers

Upper and lower critical solution temperatures in poly (ethylene glycol) solutions

Upper and Lower Critical Solution Temperatures in Polystyrene Solutions. II

Phase separation of poly(ethylene glycol)-water-salt systems

Pressure dependence of upper critical solution temperatures in the polystyrene - cyclohexane system

Upper and Lower Critical Solution Temperatures in Polystyrene Solutions. III. Temperature Dependence of theη1Parameter