The path towards delamination-free drilling of composite materials

Metal matrix composites (MMCs) are newly advanced materials having the properties of light weight, high specific strength, good wear resistance and a low thermal expansion coefficient. These materials are extensively used in industry. Greater hardness and reinforcement makes it difficult to machine using traditional techniques, which has impeded the development of MMCs. The use of traditional machinery to machine hard composite materials causes serious tool wear due to the abrasive nature of reinforcement. These materials can be machined by many non-traditional methods like water jet and laser cutting but these processes are limited to linear cutting only. Electrical discharge machining (EDM) shows higher capability for cutting complex shapes with high precision for these materials. The paper presents a review of EDM process and year wise research work done in EDM on MMCs. The paper also discusses the future trend of research work in the same area.

Review of research work in sinking EDM and WEDM on metal matrix composite materials

Experimental investigation and optimisation in drilling of GFRP composites

Grey relational analysis coupled with principal component analysis for optimization design of the cutting parameters in high-speed end milling

Electrical discharge machining (EDM) is one of the most extensively used non-conventional material removal processes. The Taguchi method has been utilized to determine the optimal EDM conditions in several industrial fields. The method, however, was designed to optimize only a single performance characteristic. To remove that limitation, the Grey relational analysis theory has been used to resolve the complicated interrelationships among the multiple performance characteristics. In the present study, we attempted to find the optimal machining conditions under which the micro-hole can be formed to a minimum diameter and a maximum aspect ratio. The Taguchi method was used to determine the relations between machining parameters and process characteristics. It was found that electrode wear and the entrance and exit clearances had a significant effect on the diameter of the micro-hole when the diameter of the electrode was identical. Grey relational analysis was used to determine the optimal machining parameters, among which the input voltage and the capacitance were found to be the most significant. The obtained optimal machining conditions were an input voltage of 60V, a capacitance of 680pF, a resistance of 500Ω, the feed rate of 1.5μm/s and a spindle speed of 1500rpm. Under these conditions, a micro-hole of 40μm average diameter and 10 aspect ratio could be machined.

/pdf/optimization-of-edm-process-for-multiple-performance-1riblqf7vr.pdf

P.Narender Singh

Papers

Optimization by Grey relational analysis of EDM parameters on machining Al–10%SiCP composites

Electric discharge machining of Al–10%SiCP as-cast metal matrix composites