1.0. Introduction 4044 2.0. Biomass Chemistry and Growth Rates 4047 2.1. Lignocellulose and Starch-Based Plants 4047 2.2. Triglyceride-Producing Plants 4049 2.3. Algae 4050 2.4. Terpenes and Rubber-Producing Plants 4052 3.0. Biomass Gasification 4052 3.1. Gasification Chemistry 4052 3.2. Gasification Reactors 4054 3.3. Supercritical Gasification 4054 3.4. Solar Gasification 4055 3.5. Gas Conditioning 4055 4.0. Syn-Gas Utilization 4056 4.1. Hydrogen Production by Water−Gas Shift Reaction 4056

/pdf/synthesis-of-transportation-fuels-from-biomass-chemistry-3sckhzoqoz.pdf

Synthesis of transportation fuels from biomass: chemistry, catalysts, and engineering.

As the oil reserves are depleting the need of an alternative fuel source is becoming increasingly apparent. One prospective method for producing fuels in the future is conversion of biomass into bio-oil and then upgrading the bio-oil over a catalyst, this method is the focus of this review article. Bio-oil production can be facilitated through flash pyrolysis, which has been identified as one of the most feasible routes. The bio-oil has a high oxygen content and therefore low stability over time and a low heating value. Upgrading is desirable to remove the oxygen and in this way make it resemble crude oil. Two general routes for bio-oil upgrading have been considered: hydrodeoxygenation (HDO) and zeolite cracking. HDO is a high pressure operation where hydrogen is used to exclude oxygen from the bio-oil, giving a high grade oil product equivalent to crude oil. Catalysts for the reaction are traditional hydrodesulphurization (HDS) catalysts, such as Co–MoS2/Al2O3, or metal catalysts, as for example Pd/C. However, catalyst lifetimes of much more than 200 h have not been achieved with any current catalyst due to carbon deposition. Zeolite cracking is an alternative path, where zeolites, e.g. HZSM-5, are used as catalysts for the deoxygenation reaction. In these systems hydrogen is not a requirement, so operation is performed at atmospheric pressure. However, extensive carbon deposition results in very short catalyst lifetimes. Furthermore a general restriction in the hydrogen content of the bio-oil results in a low H/C ratio of the oil product as no additional hydrogen is supplied. Overall, oil from zeolite cracking is of a low grade, with heating values approximately 25% lower than that of crude oil. Of the two mentioned routes, HDO appears to have the best potential, as zeolite cracking cannot produce fuels of acceptable grade for the current infrastructure. HDO is evaluated as being a path to fuels in a grade and at a price equivalent to present fossil fuels, but several tasks still have to be addressed within this process. Catalyst development, understanding of the carbon forming mechanisms, understanding of the kinetics, elucidation of sulphur as a source of deactivation, evaluation of the requirement for high pressure, and sustainable sources for hydrogen are all areas which have to be elucidated before commercialisation of the process.

A review of catalytic upgrading of bio-oil to engine fuels

Fossil fuel consumption in transportation system and energy-intensive sectors as the principal pillar of civilization is associated with progressive release of greenhouse gases. Hydrogen as a promising energy carrier is a perfect candidate to supply the energy demand of the world and concomitantly reduce toxic emissions. This article gives an overview of the state-of-the-art hydrogen production technologies using renewable and sustainable energy resources. Hydrogen from supercritical water gasification (SCWG) of biomass is the most cost effective thermochemical process. Highly moisturized biomass is utilized directly in SCWG without any high cost drying process. In SCWG, hydrogen is produced at high pressure and small amount of energy is required to pressurize hydrogen in the storage tank. Tar and char formation decreases drastically in biomass SCWG. The low efficiency of solar to hydrogen system as well as expensive photovoltaic cell are the most important barriers for the widespread commercial development of solar-based hydrogen production. Since electricity costs play a crucial role on the final hydrogen price, to generate carbon free hydrogen from solar and wind energy at a competitive price with fossil fuels, the electrical energy cost should be four times less than commercial electricity prices.

Hydrogen production from renewable and sustainable energy resources: Promising green energy carrier for clean development

As petroleum prices continue to increase, it is likely that biofuels will play an ever-increasing role in our energy future. The processing of biomass-derived feedstocks (including cellulosic, starch- and sugar-derived biomass, and vegetable fats) by catalytic cracking and hydrotreating is a promising alternative for the future to produce biofuels, and the existing infrastructure of petroleum refineries is well-suited for the production of biofuels, allowing us to rapidly transition to a more sustainable economy without large capital investments for new reaction equipment. This Review discusses the chemistry, catalysts, and challenges involved in the production of biofuels.

/pdf/synergies-between-bio-and-oil-refineries-for-the-production-2q18cylabz.pdf

Synergies between Bio‐ and Oil Refineries for the Production of Fuels from Biomass

Climate Change 1995 is a scientific assessment that was generated by more than 1 000 contributors from over 50 nations. It was jointly co-ordinated through two international agencies; the World Meteorological Organization and the United Nations Environment Programme. The assessment was completed by the Intergovernmental Panel on Climate Change (IPCC) with a primary aim of reviewing the current state of knowledge concerning the impacts of climate change on physical and ecological systems, human health, and socioeconomic factors. The second aim was to review the available information on the technical and economic feasibility of the potential mitigation and adaptation strategies.

Climate Change 1995

Natural gas is used for steam and heat production in industrial processes, residential and commercial heating, and electric power generation. Because of its importance in the power mix, a life cycle assessment on electricity generation via a natural gas combined cycle system has been performed.

/pdf/life-cycle-assessment-of-a-natural-gas-combined-cycle-power-2jrgopvl57.pdf

Life Cycle Assessment of a Natural Gas Combined-Cycle Power Generation System

https://energy.gov/sites/prod/files/2014/03/f10/33112.pdf

Update of Hydrogen from Biomass — Determination of the Delivered Cost of Hydrogen: Milestone Completion Report

Hydrogen production via thermal decomposition of methane using a solar reactor is analyzed for two different applications: (1) for a fueling station and (2) for power production. For the fueling station, the selling price of hydrogen is controlled by the high cost of hydrogen storage and compression, combined with storage limitations of the system, which prevents maximum hydrogen production. Two alternate scenarios to lower the hydrogen production cost are evaluated: (1) sending the hydrogen directly to a pipeline network and (2) adding a small electric heater, which provides heat to the solar reactor when the hydrogen supply is low. For power production, the economics of two options for the carbon produced from the solar process are evaluated: (1) selling the carbon black and (2) burning the carbon to produce more power.

/pdf/assessment-of-natural-gas-splitting-with-a-concentrating-4bzmf4tuse.pdf

Pamela L. Spath

Papers

Life Cycle Assessment of a Natural Gas Combined-Cycle Power Generation System

Update of Hydrogen from Biomass — Determination of the Delivered Cost of Hydrogen: Milestone Completion Report

Assessment of Natural Gas Splitting with a Concentrating Solar Reactor for Hydrogen Production