Microstrip antennas have been one of the most innovative topics in antenna theory and design in recent years, and are increasingly finding application in a wide range of modern microwave systems. This paper begins with a brief overview of the basic characteristics of microstrip antennas, and then concentrates on the most significant developments in microstrip antenna technology that have been made in the last several years. Emphasis is on new antenna configurations for improved electrical performance and manufacturability and on advances in the analytical modeling of microstrip antennas and arrays. >

Microstrip antennas

A survey of microstrip antenna elements is presented, with emphasis on theoretical and practical design techniques. Available substrate materials are reviewed along with the relation between dielectric constant tolerance and resonant frequency of microstrip patches. Several theoretical analysis techniques are summarized, including transmission-line and modal-expansion (cavity) techniques as well as numerical methods such as the method of moments and finite-element techniques. Practical procedures are given for both standard rectangular and circular patches, as well as variations on those designs including circularly polarized microstrip patches. The quality, bandwidth, and efficiency factors of typical patch designs are discussed. Microstrip dipole and conformal antennas are summarized. Finally, critical needs for further research and development for this antenna are identified.

Microstrip antenna technology

A moment method solution to the problem of input impedance and mutual coupling of rectangular microstrip antenna elements is presented. The formulation uses the grounded dielectric slab Green's function to account rigorously for the presence of the substrate and surface waves. Both entire basis (EB) and piecewise sinosoidal (PWS) expansion modes are used, and their relative advantages are noted. Calculations of input impedance and mutual coupling are compared with measured data and other calculatious.

Input impedance and mutual coupling of rectangular microstrip antennas

Calculated data are presented on the performance of printed antenna elements on substrates which may be electrically thick, as would be the case for printed antennas at millimeter wave frequencies. Printed dipoles and microstrip patch antennas on polytetrafluoroethylene (PTFE), quartz, and gallium arsenide substrates are considered. Data are given for resonant length, resonant resistance, bandwidth, loss due to surface waves, loss due to dielectric heating, and mutual coupling. Also presented is an optimization procedure for maximizing or minimizing power launched into surface waves from a multielement printed antenna array. The data are calculated by a moment method solution.

Considerations for millimeter wave printed antennas

A comprehensive study of infinite phased arrays of printed dipole antennas is presented, with emphasis on the scan blindness phenomenon. A rigorus and efficient moment method procedure is used to calculate the array impedance versus scan angle. Data are presented for the input reflection coefficient for various element spacings and substrate parameters. A simple theory, based on coupling from Floquet modes to surface wave modes on the substrate, is shown to predict the occurrence of scan blindness. Measurements from a waveguide simulator of a blindness condition confirm the theory.

Scan blindness in infinite phased arrays of printed dipoles

Past and present technological developments in microstrip antenna arrays are summarized. Emphasis is on exploring the potential of such arrays for satisfying the requirements of advanced military and commercial applications.

Microstrip array technology

A detailed analysis of infinite slot arrays excited by delta-function current sources is presented. The existence of severe array blindness is proved for most of the cases of slots without metallic cavity separators.

On the use of metallized cavities in printed slot arrays with dielectric substrates

A spatial filtering technique using layered dielectrics for the reduction of antenna grating lobes or sidelobes is introduced and developed. The filters are used as a radome at the array face, and can be synthesized to have Chebyshev behavior in the spatial domain. Data are given for the design of two, three, and four layer filters with various spatial passband ranges and ripple levels.

R. Mailloux

Papers

Microstrip array technology

On the use of metallized cavities in printed slot arrays with dielectric substrates

Synthesis of spatial filters with Chebyshev characteristics