Advances in processor, memory and radio technology will enable small and cheap nodes capable of sensing, communication and computation. Networks of such nodes can coordinate to perform distributed sensing of environmental phenomena. In this paper, we explore the directed diffusion paradigm for such coordination. Directed diffusion is datacentric in that all communication is for named data. All nodes in a directed diffusion-based network are application-aware. This enables diffusion to achieve energy savings by selecting empirically good paths and by caching and processing data in-network. We explore and evaluate the use of directed diffusion for a simple remote-surveillance sensor network.

/pdf/directed-diffusion-a-scalable-and-robust-communication-4tsx5vxsas.pdf

Directed diffusion: a scalable and robust communication paradigm for sensor networks

Mobile ad hoc routing protocols allow nodes with wireless adaptors to communicate with one another without any pre-existing network infrastructure. Existing ad hoc routing protocols, while robust to rapidly changing network topology, assume the presence of a connected path from source to destination. Given power limitations, the advent of short-range wireless networks, and the wide physical conditions over which ad hoc networks must be deployed, in some scenarios it is likely that this assumption is invalid. In this work, we develop techniques to deliver messages in the case where there is never a connected path from source to destination or when a network partition exists at the time a message is originated. To this end, we introduce Epidemic Routing, where random pair-wise exchanges of messages among mobile hosts ensure eventual message delivery. The goals of Epidemic Routing are to: i) maximize message delivery rate, ii) minimize message latency, and iii) minimize the total resources consumed in message delivery. Through an implementation in the Monarch simulator, we show that Epidemic Routing achieves eventual delivery of 100% of messages with reasonable aggregate resource consumption in a number of interesting scenarios.

/pdf/epidemic-routing-for-partially-connected-ad-hoc-networks-s5rslcaiip.pdf

Epidemic routing for partially-connected ad hoc networks

This paper describes two techniques that improve throughput in an ad hoc network in the presence of nodes that agree to forward packets but fail to do so. To mitigate this problem, we propose categorizing nodes based upon their dynamically measured behavior. We use a watchdog that identifies misbehaving nodes and a pathrater that helps routing protocols avoid these nodes. Through simulation we evaluate watchdog and pathrater using packet throughput, percentage of overhead (routing) transmissions, and the accuracy of misbehaving node detection. When used together in a network with moderate mobility, the two techniques increase throughput by 17% in the presence of 40% misbehaving nodes, while increasing the percentage of overhead transmissions from the standard routing protocol's 9% to 17%. During extreme mobility, watchdog and pathrater can increase network throughput by 27%, while increasing the overhead transmissions from the standard routing protocol's 12% to 24%.

/pdf/mitigating-routing-misbehavior-in-mobile-ad-hoc-networks-3fdj9bxaq3.pdf

Mitigating routing misbehavior in mobile ad hoc networks

A mobile ad hoc network consists of wireless hosts that may move often. Movement of hosts results in a change in routes, requiring some mechanism for determining new routes. Several routing protocols have already been proposed for ad hoc networks. This report suggests an approach to utilize location information (for instance, obtained using the global positioning system) to improve performance of routing protocols for ad hoc networks.

/pdf/location-aided-routing-lar-in-mobile-ad-hoc-networks-4ijy8yjn7d.pdf

Location-aided routing (LAR) in mobile ad hoc networks

The Dynamic Source Routing protocol (DSR) is a simple and efficient routing protocol designed specifically for use in multi-hop wireless ad hoc networks of mobile nodes. DSR allows the network to be completely self-organizing and self-configuring, without the need for any existing network infrastructure or administration. The protocol is composed of the two mechanisms of Route Discovery and Route Maintenance, which work together to allow nodes to discover and maintain source routes to arbitrary destinations in the ad hoc network. The use of source routing allows packet routing to be trivially loop-free, avoids the need for up-to-date routing information in the intermediate nodes through which packets are forwarded, and allows nodes forwarding or overhearing packets to cache the routing information in them for their own future use. All aspects of the protocol operate entirely on-demand, allowing the routing packet overhead of DSR to scale automatically to only that needed to react to changes in the routes currently in use. We have evaluated the operation of DSR through detailed simulation on a variety of movement and communication patterns, and through implementation and significant experimentation in a physical outdoor ad hoc networking testbed we have constructed in Pittsburgh, and have demonstrated the excellent performance of the protocol. In this chapter, we describe the design of DSR and provide a summary of some of our simulation and testbed implementation results for the protocol.

/pdf/dsr-the-dynamic-source-routing-protocol-for-multihop-1z8tw11xj9.pdf

DSR: the dynamic source routing protocol for multihop wireless ad hoc networks

Mobile ad hoc networks are characterized by multi-hop wireless links, absence of any cellular infrastructure, and frequent host mobility. Design of efficient routing protocols in such networks is a challenging issue. As class of routing protocols called on-demandprotocols hs recently found attention because of their low routing overhead. The on-demand protocols depend on query floods to discover routes whenever a new route is needed. Such floods take up a substantial portion of network bandwidth. We focus on a particular on-demand protocol, called Dynamic Source Routing, and show how intelligent use of multipath techniques can reduce the frequency of query floods. We develop an analytic modeling framework to determine the relative frequency of query floods for various techniques. Our modeling effort shows that while multipath routing is significantly better than single path routing, the performance advantage is small beyond a few paths and for long paths lengths. It also shows that providing all intermediate nodes in the primary (shortest) route with alternative paths has a significantly better performance than providing only the source with alternate paths. We perform some simulation experiments which validate these findings.

/pdf/performance-of-multipath-routing-for-on-demand-protocols-in-11zbgshr61.pdf

Performance of multipath routing for on-demand protocols in mobile ad hoc networks

We evaluate several routing protocols for mobile, wireless, ad hoc networks via packet level simulations. The protocol suite includes routing protocols specifically designed for ad hoc routing, as well as more traditional protocols, such as link state and distance vector used for dynamic networks. Performance is evaluated with respect to fraction of packets delivered, end-to-end delay and routing load for a given traffic and mobility model. It is observed that the new generation of on-demand routing protocols use a much lower routing load. However the traditional link state and distance vector protocols provide, in general, better packet delivery and delay performance.

Comparative performance evaluation of routing protocols for mobile, ad hoc networks

In this paper we evaluate several routing protocols for mobile, wireless, ad hoc networks via packetdlevel simulations. The ad hoc networks are multidhop wireless networks with dynamically changing network connectivity owing to mobility. The protocol suite includes several routing protocols specifically designed for ad hoc routing, as well as more traditional protocols, such as link state and distance vector, used for dynamic networks. Performance is evaluated with respect to fraction of packets delivered, enddtodend delay, and routing load for a given traffic and mobility model. Both small l30 nodesr and medium sized l60 nodesr networks are used. It is observed that the new generation of onddemand routing protocols use much lower routing load, especially with small number of peerdtodpeer conversations. However, the traditional link state and distance vector protocols provide, in general, better packet delivery and enddtodend delay performance.

Simulation-based performance evaluation of routing protocols for mobile ad hoc networks

Mobile ad hoc networks are characterized by multi-hop wireless links, absence of any cellular infrastructure, and frequent host mobility. Design of efficient routing protocols in such networks is a challenging issue. A class of routing protocols called on-demand protocols has recently found attention because of their low routing overhead. We propose a technique that can reduce the routing overhead even further. The on-demand protocols depend on query floods to discover routes whenever a new route is needed. Our technique utilizes prior routing histories to localize the query flood to a limited region of the network. Simulation results demonstrate excellent reduction of routing overheads with this mechanism. This also contributes to a reduced level of network congestion and better end-to-end delay performance of data packets.

Robert Castañeda

Papers

Performance of multipath routing for on-demand protocols in mobile ad hoc networks

Comparative performance evaluation of routing protocols for mobile, ad hoc networks

Simulation-based performance evaluation of routing protocols for mobile ad hoc networks

Query localization techniques for on-demand routing protocols in ad hoc networks

Query localization techniques for on-demand routing protocols in ad hoc networks