Dissimilar welding of AISI 310 austenitic stainless steel to nickel-based alloy Inconel 657

Characterization of microstructures and mechanical properties of Inconel 617/310 stainless steel dissimilar welds

An assessment of microstructure, mechanical properties and corrosion resistance of dissimilar welds between Inconel 718 and 310S austenitic stainless steel

The wire and arc-based additive manufacturing process applies arc welding technology; the wire material is melted by the arc discharge, and is then accumulated successively in this process. The wire and arc-based additive manufacturing process directly and locally adds material to the molten pool. By changing the material locally during the process, more than one kind of material can be used simultaneously in a single manufactured component. In this study, two kinds of dissimilar metal deposition were conducted. A combination used was a stainless steel and Ni-based alloy. Mechanical properties near the interface such as hardness and bond strength were investigated. As a result, it was found that the mechanical properties of the manufactured alloy were comparable to those of a bulk material. In addition, an additive manufacturing system and a torch path planning method for using more than two kinds of material were proposed. By using this method, highly functional shapes whose surfaces and inner structures are made of different material could be made.

Dissimilar metal deposition with a stainless steel and nickel-based alloy using wire and arc-based additive manufacturing

Microstructure and hardness studies of electron beam welded Inconel 625 and stainless steel 304L

Dissimilar welding of nickel-based Alloy 690 to SUS 304L with Ti addition

This study investigates the microstructure and fracture behavior of dissimilar weldments of alloy 690 and SUS 304L for various additions of niobium (0.1, 1.03, 2.49, and 3.35 wt pct) in the flux. With identical parameters and procedures, weldments were butt welded by the shielding metal arc welding (SMAW) process using three layers, with each layer being deposited in a single pass. The results indicate that the microstructure of the fusion zone was primarily dendritic and that the contents of Ni, Cr, and Fe within this zone remain relatively constant and resemble alloy 690. With Nb addition, it is noted that the microstructure changes from a cellular to columnar dendrite and equiaxed dendrite. Meanwhile, the dendrite arm spacing reduces and the secondary arms grow longer. Moreover, the composition of the interdendritic phase, whose precipitate volume percentage increases from 5 to 25 pct, changes from Al-Ti-O to Nb rich. The spread of the interdendritic phase is less in the root bead than in the cap bead due to the greater influence of base metal dilution in this region. Mechanical tests indicate that Nb addition increases the average hardness of the weldment and reduces its elongation prior to rupture. However, the tensile strength is essentially unchanged by Nb addition. It is found that the average hardness of the root bead is generally lower than the cap bead, and that the tensile specimens all rupture in the fusion zone, with the fracture surfaces exhibiting ductile features. It is noted that the cap bead tends to rupture interdendritically with increasing Nb addition. Finally, fractography shows that the dimples in the root become larger and shallower with Nb addition and are rich with an interdendritic phase.

Sheng-Long Jeng

Papers

Dissimilar welding of nickel-based Alloy 690 to SUS 304L with Ti addition

The microstructure and fracture behavior of the dissimilar alloy 690-SUS 304L joint with various Nb addition