Acid—base interfacial interactions in aqueous media

The final performance of a composite material depends strongly on the quality of the fibre-matrix interface. The interactions developed at the interface were studied using the acid-base or acceptor-donor concept. The surface characteristics of the carbon fibres and the epoxy matrix were studied using a tensiometric method and the inverse gas chromatography technique. Acid-base surface characters could be determined allowing the interactions at the interface to be described by a specific interaction parameter. It was shown that the shear strength of the interface, as measured by a fragmentation test, is strongly correlated to this specific interaction parameter, demonstrating the importance of acid-base interactions in the fibre-matrix adhesion.

The Role of the Interface in Carbon Fibre-Epoxy Composites

Nanocrystals of MgO and CaO have been prepared by a modified aerogel/hypercritical drying/dehydration method. For nanocrystalline MgO (AP-MgO) surface areas ranged from 250 to 500 m2/g, whereas for AP-CaO 100−160 m2/g. These materials have been compared with more conventional (CP) microcrystalline samples of lower surface area with regard to (1) morphology (AP-samples (autoclave preparation) are tiny polyhedral crystallites, while CP-samples (conventional preparation) are larger, hexagonal platelets and cubes); (2) residual surface OH (AP-samples have less acidic OH, which are more isolated from each other; (3) acid gas adsorption (AP-samples adsorb more SO2 and CO2 at low pressures and room temperature and prefer monodentate rather than bidentate adsorption modes, but at higher pressures CP-samples adsorb more SO2 and HCl apparently due to the formation of more well ordered multilayers); (4) destructive adsorption of organophosphorus compounds and chlorocarbons (AP-samples are superior due to higher surf...

Nanocrystals as Stoichiometric Reagents with Unique Surface Chemistry

The strength of macroscopic adhesive bonds of polymers is known to be directly proportional to the microscopic exothermic interfacial energy changes of bond formation, as measured by Dupre's 'work of adhesion'. Since the work of adhesion can be very appreciably increased by interfacial acid-base bonding with concomitant increases in adhesive bond strength, it is important to understand the acid-base character of polymers and of the surface sites of substrates or of the reinforcing fillers of polymer composites. The best known acid-base bonds are the hydrogen bonds; these are typical of acid-base bonds, with interaction energies dependent on the acidity of the hydrogen donor and on the basicity of the hydrogen acceptor. The strengths of the acidic or basic sites of polymers and of inorganic substrates can be easily determined by spectroscopic or calorimetric methods, and from this information one can start to predict the strengths of adhesive bonds. An important application of the new knowledge of interfac...

Role of acid-base interfacial bonding in adhesion

Tremendous efforts have been devoted to the development of electrode materials, electrolytes, and separators of energy-storage devices to address the fundamental needs of emerging technologies such as electric vehicles, artificial intelligence, and virtual reality. However, binders, as an important component of energy-storage devices, are yet to receive similar attention. Polyvinylidene fluoride (PVDF) has been the dominant binder in the battery industry for decades despite several well-recognized drawbacks, i.e., limited binding strength due to the lack of chemical bonds with electroactive materials, insufficient mechanical properties, and low electronic and lithium-ion conductivities. The limited binding function cannot meet inherent demands of emerging electrode materials with high capacities such as silicon anodes and sulfur cathodes. To address these concerns, in this review we divide the binding between active materials and binders into two major mechanisms: mechanical interlocking and interfacial b...

Terence E. Needham

Papers

Four-parameter equation for predicting enthalpies of adduct formation

Vier-parameter-gleichung zur berechnung von enthalpien der addukt-bldg.