Terrestrial net primary production (NPP) quantifies the amount of atmospheric carbon fixed by plants and accumulated as biomass. Previous studies have shown that climate constraints were relaxing with increasing temperature and solar radiation, allowing an upward trend in NPP from 1982 through 1999. The past decade (2000 to 2009) has been the warmest since instrumental measurements began, which could imply continued increases in NPP; however, our estimates suggest a reduction in the global NPP of 0.55 petagrams of carbon. Large-scale droughts have reduced regional NPP, and a drying trend in the Southern Hemisphere has decreased NPP in that area, counteracting the increased NPP over the Northern Hemisphere. A continued decline in NPP would not only weaken the terrestrial carbon sink, but it would also intensify future competition between food demand and proposed biofuel production.

Drought-Induced Reduction in Global Terrestrial Net Primary Production from 2000 Through 2009

An intermediate-complexity, quasi–physically based, meteorological model (MicroMet) has been developed to produce high-resolution (e.g., 30-m to 1-km horizontal grid increment) atmospheric forcings required to run spatially distributed terrestrial models over a wide variety of landscapes. The following eight variables, required to run most terrestrial models, are distributed: air temperature, relative humidity, wind speed, wind direction, incoming solar radiation, incoming longwave radiation, surface pressure, and precipitation. To produce these distributions, MicroMet assumes that at least one value of each of the following meteorological variables are available for each time step, somewhere within, or near, the simulation domain: air temperature, relative humidity, wind speed, wind direction, and precipitation. These variables are collected at most meteorological stations. For the incoming solar and longwave radiation, and surface pressure, either MicroMet can use its submodels to generate these fields, or it can create the distributions from observations as part of a data assimilation procedure. MicroMet includes a preprocessor component that analyzes meteorological data, then identifies and corrects potential deficiencies. Since providing temporally and spatially continuous atmospheric forcing data for terrestrial models is a core objective of MicroMet, the preprocessor also fills in any missing data segments with realistic values. Data filling is achieved by employing a variety of procedures, including an autoregressive integrated moving average calculation for diurnally varying variables (e.g., air temperature). To create the distributed atmospheric fields, spatial interpolations are performed using the Barnes objective analysis scheme, and subsequent corrections are made to the interpolated fields using known temperature–elevation, wind–topography, humidity–cloudiness, and radiation–cloud–topography relationships.

A Meteorological Distribution System for High Resolution Terrestrial Modeling (MicroMet)

The Global Land Surface Satellite (GLASS) product suite currently contains 12 products, including leaf area index, fraction of absorbed photosynthetically active radiation, fraction of green vegetation coverage, gross primary production, broadband albedo, broadband longwave emissivity, downward shortwave radiation and photosynthetically active radiation, land surface temperature, downward and upwelling thermal radiation, all-wave net radiation, and evapotranspiration. These products are generated from the Advanced Very High Resolution Radiometer and Moderate Resolution Imaging Spectroradiometer satellite data. Their unique features include long-term temporal coverage (many from 1981 to the present), high spatial resolutions of the surface radiation products (1 km and 0.05°), spatial continuities without missing pixels, and high quality and accuracy based on extensive validation using in situ measurements and intercomparisons with other existing satellite products. Moreover, the GLASS products are based on robust algorithms that have been published in peer-reviewed literature. Herein, we provide an overview of the algorithm development, product characteristics, and some preliminary applications of these products. We also describe the next steps, such as improving the existing GLASS products, generating more climate data records (CDRs), broadening product dissemination, and fostering their wider utilization. The GLASS products are freely available to the public.

/pdf/the-global-land-surface-satellite-glass-product-suite-29le5gpw6u.pdf

The Global Land Surface Satellite (GLASS) Product Suite

Satellite-derived LAI products exhibit large discrepancies and can lead to substantial uncertainty in simulated carbon and water fluxes

Sources of uncertainty in gross primary productivity simulated by light use efficiency models: Model structure, parameters, input data, and spatial resolution

A long-term simulation of forest carbon fluxes over the Qilian Mountains

We propose a long-term parameterization scheme for two critical parameters, zero-plane displacement height (d) and aerodynamic roughness length (z0m), that we further use in the Surface Energy Balance System (SEBS). A sensitivity analysis of SEBS indicated that these two parameters largely impact the estimated sensible heat and latent heat fluxes. First, we calibrated regression relationships between measured forest vertical parameters (Lorey’s height and the frontal area index (FAI)) and forest aboveground biomass (AGB). Next, we derived the interannual Lorey’s height and FAI values from our calibrated regression models and corresponding forest AGB dynamics that were converted from interannual carbon fluxes, as simulated from two incorporated ecological models and a 2009 forest basis map These dynamic forest vertical parameters, combined with refined eight-day Global LAnd Surface Satellite (GLASS) LAI products, were applied to estimate the eight-day d, z0m, and, thus, the heat roughness length (z0h). The obtained d, z0m and z0h were then used as forcing for the SEBS model in order to simulate long-term forest evapotranspiration (ET) from 2000 to 2012 within the Qilian Mountains (QMs). As compared with MODIS, MOD16 products at the eddy covariance (EC) site, ET estimates from the SEBS agreed much better with EC measurements (R2 = 0.80 and RMSE = 0.21 mm·day−1).

/pdf/simulation-of-forest-evapotranspiration-using-time-series-rnpwgh0us5.pdf

Simulation of forest evapotranspiration using time - series parameterization of the surface energy balance system (SEBS) over the Qilian Mountains

The quantification of forest Gross Primary Productivity (GPP) has been the focus of many scientific studies (e.g. carbon cycle, climate change, etc.). Current remote sensing-based models (i.e., the MODIS MOD_17 model), rely on the accurate meteorological data, specific vegetation parameter, the applicability and explicability of remote sensing data. In this study, the original MODIS GPP products were validated and showed significant underestimation compared to the eddy covariance measurements of the four forest sites over China. Thus the strategy of simple yet accurate and quantitative simulation of carbon fluxes was improved by using Sims TG model which was termed the Temperature and Greenness (TG) model and included the land surface temperature (LST) product and enhanced vegetation index (EVI) product from MODIS. The results indicated that Sims TG model was poor adaptive to tropical and subtropical evergreen forest in China. The model precision of deciduous forest was high but the GPP of evergreen forest are underestimated in Qianyanzhou and Xishuangbanna station in summer. After the parameter was optimized in Sims TG model, the estimation accuracy of evergreen forest GPP was improved to a certain extent and the model better adapt to dynamic change of forest GPP in China.

Wenwu Fan

Papers

A long-term simulation of forest carbon fluxes over the Qilian Mountains

Simulation of forest evapotranspiration using time - series parameterization of the surface energy balance system (SEBS) over the Qilian Mountains

Estimation of Gross Primary Productivity of four types of forest in China