In this paper, a multi-mode surface plasmon resonance absorber based on dart-type single-layer graphene is proposed, which has the advantages of polarization independence, tunability, high sensitivity, high figure of merit, etc. The device consists of a top layer dart-like patterned single-layer graphene array, a thicker silicon dioxide spacer layer and a metal reflector layer, and has simple structural characteristics. The numerical results show that the device achieves the perfect polarization-independent absorption at the resonance wavelengths of λI = 3369.55 nm, λII = 3508.35 nm, λIII = 3689.09 nm and λIV = 4257.72 nm, with the absorption efficiencies of 99.78%, 99.40%, 99.04% and 99.91%, respectively. The absorption effect of the absorber can be effectively regulated and controlled by adjusting the numerical values such as the geometric parameters and the structural period p of the single-layer graphene array. In addition, by controlling the chemical potential and the relaxation time of the graphene layer, the resonant wavelength and the absorption efficiency of the mode can be dynamically tuned. And can keep high absorption in a wide incident angle range of 0° to 50°. At last, we exposed the structure to different environmental refractive indices, and obtained the corresponding maximum sensitivities in four resonance modes, which are SI = 635.75 nm RIU−1, SII = 695.13 nm RIU−1, SIII = 775.38 nm RIU−1 and SIV = 839.39 nm RIU−1. Maximum figure of merit are 54.03 RIU−1, 51.49 RIU−1, 43.56 RIU−1, and 52.14 RIU−1, respectively. Therefore, this study has provided a new inspiration for the design of the graphene-based tunable multi-band perfect metamaterial absorber, which can be applied to the fields such as photodetectors and chemical sensors.

/pdf/multi-mode-surface-plasmon-resonance-absorber-based-on-dart-1cn48obr.pdf

Multi-mode surface plasmon resonance absorber based on dart-type single-layer graphene

Abstract This review article discusses progress in surface plasmon resonance (SPR) of two-dimensional (2D) and three-dimensional (3D) chip-based nanostructure array patterns. Recent advancements in fabrication techniques for nano-arrays have endowed researchers with tools to explore a material’s plasmonic optical properties. In this review, fabrication techniques including electron-beam lithography, focused-ion lithography, dip-pen lithography, laser interference lithography, nanosphere lithography, nanoimprint lithography, and anodic aluminum oxide (AAO) template-based lithography are introduced and discussed. Nano-arrays have gained increased attention because of their optical property dependency (light-matter interactions) on size, shape, and periodicity. In particular, nano-array architectures can be tailored to produce and tune plasmonic modes such as localized surface plasmon resonance (LSPR), surface plasmon polariton (SPP), extraordinary transmission, surface lattice resonance (SLR), Fano resonance, plasmonic whispering-gallery modes (WGMs), and plasmonic gap mode. Thus, light management (absorption, scattering, transmission, and guided wave propagation), as well as electromagnetic (EM) field enhancement, can be controlled by rational design and fabrication of plasmonic nano-arrays. Because of their optical properties, these plasmonic modes can be utilized for designing plasmonic sensors and surface-enhanced Raman scattering (SERS) sensors.

https://www.degruyter.com/document/doi/10.1515/nanoph-2019-0158/pdf

A Review of 2D and 3D Plasmonic Nanostructure Array Patterns: Fabrication, Light Management and Sensing Applications

The plasmon-induced transparency (PIT), which is destructive interference between the superradiation mode and the subradiation mode, is studied in patterned graphene-based terahertz metasurface composed of graphene ribbons and graphene strips. As the results of finite-difference time-domain (FDTD) simulation and coupled-mode theory (CMT) fitting, the PIT can be dynamically modulated by the dual-mode. The left (right) transmission dip is mainly tailored by the gate voltage applied to graphene ribbons (stripes), respectively, meaning a dual-mode on-to-off modulator is realized. Surprisingly, an absorbance of 50% and slow-light property of 0.7 ps are also achieved, demonstrating the proposed PIT metasurface has important applications in absorption and slow-light. In addition, coupling effects between the graphene ribbons and the graphene strips in PIT metasurface with different structural parameters also are studied in detail. Thus, the proposed structure provides a new basis for the dual-mode on-to-off multi-function modulators.

/pdf/dual-mode-on-to-off-modulation-of-plasmon-induced-2pwqomo3p7.pdf

Dual-Mode On-to-Off Modulation of Plasmon-Induced Transparency and Coupling Effect in Patterned Graphene-Based Terahertz Metasurface.

Solar energy absorption is a very important field in photonics. The successful development of an efficient, wide-band solar absorber is an extremely powerful driver in this field. We propose an ultra-wideband (UWB) solar energy absorber composed of a Ti ring and SiO2-Si3N4-Ti thin films. In the range of 300-4000 nm, the wide band has an absorption efficiency of more than 90% and can reach 3683 nm, and it has four absorption peaks with a high absorptivity. Moreover, the weighted average absorption efficiency of the solar absorber under AM 1.5 is maintained above 97.03%, which indicates it has great potential for use in the field of solar energy absorption. Moreover, we proved that the polarization is insensitive by analyzing the absorption characteristics at arbitrary polarization angles. For both the transverse electric (TE) and transverse magnetic (TM) modes, the UWB absorption is maintained at more than 90% in the wide incidence angle range of 60°. The UWB solar energy absorber has great potential for use in a variety of applications, such as converting solar light and heat into electricity for public use and reducing the side effects of coal-fired power generation. It can also be used in information detection and infrared thermal imaging owing to its UWB characteristics.

Ultra-wideband and wide-angle perfect solar energy absorber based on Ti nanorings surface plasmon resonance

We present a novel, structurally simple, multifunctional broadband absorber. It consists of a patterned vanadium dioxide film and a metal plate spaced by a dielectric layer. The temperature control allows...

Thermal tuning of terahertz metamaterial properties based on phase change material vanadium dioxide

We demonstrate the realization of plasmonic analog of electromagnetically induced transparency (EIT) in a system composing of two stub resonators side-coupled to metal-dielectric-metal (MDM) waveguide. Based on the coupled mode theory (CMT) and Fabry-Perot (FP) model, respectively, the formation and evolution mechanisms of plasmon-induced transparency by direct and indirect couplings are exactly analyzed. For the direct coupling between the two stub resonators, the FWHM and group index of transparent window to the inter-space are more sensitive than to the width of one cut, and the high group index of up to 60 can be achieved. For the indirect coupling, the formation of transparency window is determined by the resonance detuning, but the evolution of transparency is mainly attributed to the change of coupling distance. The consistence between the analytical solution and finite-difference time-domain (FDTD) simulations verifies the feasibility of the plasmon-induced transparency system. It is also interesting to notice that the scheme is easy to be fabricated and may pave the way to highly integrated optical circuits.

Formation and evolution mechanisms of plasmon-induced transparency in MDM waveguide with two stub resonators

We investigate a classic analog of electromagnetically induced transparency (EIT) in a metal-dielectric-metal (MDM) bus waveguide coupled to two stub resonators. A uniform theoretical model, for both direct and indirect couplings between the two stubs, is established to study spectral features in the plasmonic stub waveguide, and the theoretical results agree well with the finite difference time domain simulations. Adjusting phase difference and coupling strength of the interaction, one can realize the EIT-like phenomena and achieve the required slow light effect. The theoretical results may provide a guideline for the control of light in highly integrated optical circuits.

Uniform theoretical description of plasmon-induced transparency in plasmonic stub waveguide

We report a theoretical and numerical investigation of the plasmon-induced transparency (PIT) effect in a dual-ring resonator-coupled metal–dielectric–metal waveguide system. A transfer matrix method (TMM) is introduced to analyse the transmission and dispersion properties in the transparency window. A tunable PIT is realized in a constant separation design. The phase dispersion and slow-light effect are discussed in both the resonance and non-resonance conditions. Finally, a propagation constant based on the TMM is derived for the periodic system. It is found that the group index in the transparency window of the proposed structure can be easily tuned by the period p, which provides a new understanding, and a group index ∼51 is achieved. The quality factor of resonators can also be effective in adjusting the dispersion relation. These observations could be helpful to fundamental research and applications for integrated plasmonic devices.

https://iopscience.iop.org/article/10.1088/0022-3727/47/20/205101/pdf

Slow light based on plasmon-induced transparency in dual-ring resonator-coupled MDM waveguide system

We propose a novel combination of a radiation field model and the transfer matrix method (TMM) to demonstrate plasmon-induced transparency (PIT) in bright-dark mode waveguide structures. This radiation field model is more effective and convenient for describing direct coupling in bright-dark mode resonators, and is promoted to describe transmission spectra and scattering parameters quantitatively in infinite element structures by combining it with the TMM. We verify the correctness of this novel combined method through numerical simulation of the metal-dielectric-metal (MDM) waveguide side-coupled with typical bright-dark mode, H-shaped resonators; the large group index can be achieved in these periodic H-shaped resonators. These results may provide a guideline for the control of light in highly integrated optical circuits.

Combined theoretical analysis for plasmon-induced transparency in waveguide systems.

By taking the aperture as a resonator, we propose an analytical model to describe the dynamic transmission in metal-dielectric-metal (MDM) waveguide aperture-side-coupled with slot cavity. The theoretical results and the finite-difference time-domain (FDTD) simulations agree well with each other, and both demonstrate the mode selectivity and filtering tunability of the plasmonic structure. By adjusting the phase shifts in slot cavity or resonance frequency determined by the aperture, one can realize the required transmission spectra and slow light effect. The theoretical analysis may open up avenues for the control of light in highly integrated optical circuits.

Zhihui He

Papers

Formation and evolution mechanisms of plasmon-induced transparency in MDM waveguide with two stub resonators

Uniform theoretical description of plasmon-induced transparency in plasmonic stub waveguide

Slow light based on plasmon-induced transparency in dual-ring resonator-coupled MDM waveguide system

Combined theoretical analysis for plasmon-induced transparency in waveguide systems.

Systematic Theoretical Analysis of Selective-Mode Plasmonic Filter Based on Aperture-Side-Coupled Slot Cavity