Thermal dissipation probe (TDP) method (Granier, 1985) is widely used to estimate tree transpiration (i.e., the water evaporated from the leaves) because it is simple to build, easy to install, and relatively inexpensive. However, the universality of the original calibration has been questioned and, in many cases, proved to be inaccurate. Thus, when the TDP is used in a new species, specific tests should be carried out. Our aim was to propose a new method for improving the accuracy of TDP on trees in the field. Small hazelnut trees (diameter at breast height 5 cm) were used for the experiment. The response of TDP sensors was compared with a reference water uptake measured with an electronic potometer system provided with a high precision liquid flow meter. We equipped three stems where we measured the sap flow density, the sapwood area (by using fuchsine), the total tree water uptake (reference), and the main meteorological parameters during summer 2018. Results confirmed that the original Granier’s calibration underestimated the effective tree transpiration (relative error about −60%). We proposed a new equation for improving the measurement accuracy within an error of about 4%. The system proposed appeared an easier solution compared to potted trees and particularly suitable for orchards, thus contributing to improve the irrigation management worldwide.

background

https://www.mdpi.com/1424-8220/19/10/2419/pdf

Development of a Thermal Based Flow Measurement Technique for Very Low Flow Velocities

Citations

Calibration of Granier-Type (TDP) Sap Flow Probes by a High Precision Electronic Potometer

Related Papers (5)

Experimental verification of the four-sensor probe model for flow diagnosis in air water flow in vertical pipe

Modeling flow pattern transitions for gas liqud flow

Flow-regime characterization for horizontal two-phase steam flow

Simulations of asphalt-base crude oil flow in vertical riser

Thermodynamics of pipeline gas flow