Journal ArticleDOI
Evaluation of friction forces in the 0·022 × 0·028 edgewise bracket in vitro
Reads0
Chats0
TLDR
Different bracket-archwire-angulation combinations are quantified to show relative comparisons for wires and brackets used clinically to show force needed to overcome friction and coefficient of friction.About:
This article is published in Journal of Biomechanics.The article was published on 1970-03-01. It has received 153 citations till now. The article focuses on the topics: Bracket & Lubrication.read more
Citations
More filters
Journal ArticleDOI
Corrosion behavior of self-ligating and conventional metal brackets
Lúcio Henrique Esmeraldo Gurgel Maia,Hibernon Lopes Filho,Antônio Carlos de Oliveira Ruellas,Mônica Tirre de Souza Araújo,Delmo Santiago Vaitsman +4 more
TL;DR: Comparison of metal release in self-ligating and conventional brackets from the same manufacturer proved that the SCs group released more nickel, chromium and iron than the GN group after 7 and 14 days, but less chromium, iron and nickel at the three experimental time intervals.
Journal ArticleDOI
Comparison of force loss during sliding of low friction and conventional TMA orthodontic archwires: An in vitro study
TL;DR: The friction property of the low friction TMA archwire was superior to the conventional T MA archwire but was still inferior to the stainless steel archwire.
Journal Article
Effect of Bracketsâ Types on the Amount of Movement and Rotation of Canine during Retraction: A Simulated In vitro Study
TL;DR: In this paper, the authors evaluated the effect of brackets' materials on the distance moved by canine and rotation during sliding in an in vitro study and found that canine moved more with stainless steel brackets with less rotation while it was just the opposite with ceramic brackets.
Journal ArticleDOI
Blomechanical analysis of arch-guided molar distallzation when employing superelastic NiTi coil springs
TL;DR: Small forces are biologically more favorable and thus should be preferred in the orthodontically effective forces measured, and the mean frictional forces increased, reaching values between 50 and 80% of the applied force of the compression springs.
References
More filters
Journal ArticleDOI
Routine use of minute forces
TL;DR: A research study on “The Selection of Forces for Tooth Movement” finds that the rate of tooth movement is largely determined by the speed with which the periodontal membrane re-establishes circulation in the areas of pressure and tension.