Journal ArticleDOI
Parameter Design of EDM Process to Optimize Surface Roughness and Material Removal Rate Using Taguchi Method
About:
This article is published in Materials Science Forum.The article was published on 2021-04-01. It has received 0 citations till now. The article focuses on the topics: Taguchi methods & Surface roughness.read more
References
More filters
Journal ArticleDOI
Effect of diluted dielectric medium on spark energy in green EDM process using TGRA approach
TL;DR: In this paper, a research endeavor was performed to analyze the influence of process parameters with normal tap water mixed deionized water as insulating medium, and the optimum combination has also been found using Taguchi Grey-relational approach to achieve better multiple response parameters in the proposed eco friendly electrical discharge machining process.
Journal ArticleDOI
Experimental investigation and optimization of cobalt bonded tungsten carbide composite by hybrid AHP-TOPSIS approach
TL;DR: In this article, the influence of process parameters like pulse on time, pulse off time, and pulse current and voltage on the performance aspects like material removal rate (MRR), tool wear rate (TWR), and surface roughness (SR) of an electrical discharge machining (EDM) with graphite and copper electrodes was investigated.
Journal ArticleDOI
Multi-characteristics optimization in EDM of NiTi alloy, NiCu alloy and BeCu alloy using Taguchi’s approach and utility concept
TL;DR: In this article, the authors investigated the effect of input parameters such as workpiece electrical conductivity, gap current, gap voltage, pulse-on-time and pulse-off-time on the responses namely material removal rate (MRR) and tool wear rate (TWR).
Journal Article
Analysis of MRR and SR with different electrode for SS 316 on Die-Sinking EDM using Taguchi Technique
TL;DR: In this paper, the results of experimentation were analyzed analytically as well as graphically, and the optimal value of MRR and SR were also calculated using their signal to noise ratio value.
Journal ArticleDOI
Fabrication and Characterization of Weldments AISI 304 and AISI 316 Used in Industrial Applications
TL;DR: In this article, the effect of welding parameters on tensile strength, grain structure and hardness of dissimilar weldments was measured. But the welding speed was selected as 4, 8, 12 cm/sec.
Related Papers (5)
Optimization of process parameters in wire-cut EDM of Inconel 625 using Taguchi’s approach
M. Subrahmanyam,T. Nancharaiah +1 more