Showing papers on "Ballistic impact published in 1977"
TL;DR: In this article, the axisymmetric response of an infinite plate to an impacting projectile is determined analytically on the hypothesis that, for large deformations, a ductile plate behaves to a good approximation like a membrane under uniform tension.
Abstract: T he axisymmetric response of an infinite plate to an impacting projectile is determined analytically on the hypothesis that, for large deformations, a ductile plate behaves to a good approximation like a membrane under uniform tension. The lowest projectile velocity that results in perforation (the ballistic limit), and the residual velocity after perforation, then are determined on the basis of a critical-strain failure criterion. A figure of merit that depends only on the material properties of the target and characterizes the resistance of the material to impact appears naturally in the analysis. Variations in the ballistic limit with target thickness and projectile dimensions can be determined when this figure of merit is known. The theoretical ballistic limit and residual velocity for a steel cylinder impacting a titanium plate are found to agree with available measured values. Further support for the membrane model and an estimate of its range of validity are obtained by comparing the maximum displacement of an impulsively-loaded, circular membrane with experimental data for circular plates.
19 citations
01 Mar 1977
TL;DR: In this article, computer codes were developed for simulating the dynamic fracture and viscoelastic constitutive response due to stress wave interaction and reflections caused by ballistic impact on woven textiles.
Abstract: Computer codes were developed for simulating the dynamic fracture and viscoelastic constitutive response due to stress wave interaction and reflections caused by ballistic impact on woven textiles. The method, which was developed for use in the design and analysis of protection devices for personnel armor, has potential for use in studies of rotor blade burst containment at high velocity. Alterations in coding required for burst containment problems are discussed.
1 citations
25 Oct 1977
TL;DR: The application of energy absorbing surface layers to Si3N4 and SiC was investigated in this paper, where microcracked materials such as iron titanate and a silica-zircon mixture were used as energy absorbing surfaces.
Abstract: The application of energy absorbing surface layers to Si3N4 and SiC was investigated. Among the layers studied were microcracked materials such as iron titanate and a silica-zircon mixture and porous materials such as reaction sintered Si3N4. Energy absorption due to microcrack extension upon impact was found not to be an important mechanism. Instead, the fivefold improvement in Charpy and ballistic impact at elevated temperature (1250 C and 1370 C) found for Fe2TiO5 was due to plastic deformation while similar improvement found for silica-zircon mixtures at RT was due to crushing of the porous material. Due to thermal expansion mismatch, these two materials could not withstand thermal cycling when used as energy absorbing surface layers on Si3N4. Reaction sintered Si3N4 layers on dense Si3N4 were found to give up to a sevenfold increase in ballistic impact resistance due to crushing of the layer upon impact. High porosity (45%), large particle size R.S. Si3N4 layers fabricated from -100, +200 mesh Si powder gave better impact improvement than less porous (30%), small particle size layers fabricated from -325 mesh Si powder.
1 citations