Showing papers on "Sea-level curve published in 2021"

Holocene Sea-Level Changes in Southern Brazil Based on High-Resolution Radar Stratigraphy

Abstract: This paper focuses on high-resolution coastal stratigraphy data, which were revealed by the Ground Penetrating Radar (GPR) system. Surveys performed with GPR on the surface of prograded barriers reveal patterns of reflections that allow the interpretation of the geometry and stratigraphy of coastal deposits in a continuous mode. At the Curumim prograded barrier in southern Brazil (29°30′ S–49°53′ W), a two-dimensional transverse GPR survey revealed, with high precision, a serial of contacts between aeolian deposits of relict foredunes and relict beach deposits that have a strong correlation with sea level. In a 4 km GPR profile, a total of 24 of these contacts were identified. The high accurate spatial positioning of the contacts combined with Optical Stimulated Luminescence dating resulted in the first confident sea-level curve that tells the history of sea-level changes during the last 7 ka on the southernmost sector of the Brazilian coast. The curve shows that sea-level was still rising before 6 ka BP, with a maximum level of 1.9 m reached close to 5 ka BP; after that, sea-level started to falling slowly until around 4 ka BP when fall accelerated.

Modelling the role of dynamic topography and eustasy in the evolution of the Great Artesian Basin

Abstract: Widespread flooding of the Australian continent during the Early Cretaceous, referred to as the Eromanga Sea, deposited extensive shallow marine sediments throughout the Great Artesian Basin (GAB). This event had been considered ‘out of sync’ with eustatic sea level and was instead solely attributed to dynamic subsidence associated with Australia's passage over eastern Gondwanan subducted material. However, mantle convection models previously used to explain this event have since been shown to overestimate dynamic topography amplitude by a factor of two compared with residual topography estimates. Previous models were also based on a Cretaceous eustatic sea level peak at ca. 90 Ma in conventional eustatic sea level curves; however, more recent estimates of global sea level from ocean basin volume (OBV) suggest this peak may have occurred earlier at ca. 120 Ma. Our work links time‐dependent erosion and deposition with dynamic topography and eustasy to test their contribution to basin development using the landscape evolution code pyBadlands. Our results show that the lower amplitude estimates of dynamic topography derived from pseudo‐compressible mantle flow models better reflect the Cretaceous vertical motions of the Australian continent (ca. 100 m) compared with their incompressible counterparts (ca. 200–400 m). Additionally, our models include the Neogene north‐eastward tilting of Australia, elusive in most previously published geodynamic models. In conjunction with an OBV‐derived sea level curve, our preferred landscape evolution model broadly matches the Cretaceous inundation patterns and first‐order sedimentary sequences in the GAB. The results highlight that the Early Cretaceous inundation of the Australian continent is likely a combination of high global sea levels and the regional effects of dynamic subsidence. Our work provides a framework for a new generation of evolving paleogeographic models at continental scales, while also providing key insights into the viability of existing sea level curves and dynamic topography estimates for reproducing topographic and basin evolution.