A
A. N. M. Tanvir
Researcher at Tennessee Technological University
Publications - 9
Citations - 224
A. N. M. Tanvir is an academic researcher from Tennessee Technological University. The author has contributed to research in topics: Welding & Inconel 625. The author has an hindex of 5, co-authored 7 publications receiving 76 citations. Previous affiliations of A. N. M. Tanvir include University of Notre Dame.
Papers
More filters
Journal ArticleDOI
Heat treatment effects on Inconel 625 components fabricated by wire + arc additive manufacturing (WAAM)—part 1: microstructural characterization
TL;DR: In this paper, a Ni-based superalloy wire, i.e., Inconel 625, is melted and deposited additively through a cold metal transfer (CMT)-based WAAM process.
Journal ArticleDOI
Fabrication of bimetallic additively manufactured structure (BAMS) of low carbon steel and 316L austenitic stainless steel with wire + arc additive manufacturing
TL;DR: In this paper, a gas metal arc welding (GMAW) based wire + arc additive manufacturing (WAAM) system has been developed to use two material successively and fabricate bimetallic additively manufactured structure (BAMS) of low carbon steel and AISI 316L stainless steel (SS).
Journal ArticleDOI
Heat-treatment effects on a bimetallic additively-manufactured structure (BAMS) of the low-carbon steel and austenitic-stainless steel
Md. R. U. Ahsan,A. N. M. Tanvir,Gi-Jeong Seo,Brian Bates,Wayne Hawkins,Chanho Lee,Peter K. Liaw,Mark W. Noakes,Andrzej Nycz,Duck Bong Kim +9 more
TL;DR: In this paper, a BAM of low carbon steel and austenitic-stainless steel was fabricated using a gas-metal-arc-welding (GMAW)-based additive manufacturing (WAAM) process.
Journal ArticleDOI
Phase stability and mechanical properties of wire + arc additively manufactured H13 tool steel at elevated temperatures
A. N. M. Tanvir,Md. R. U. Ahsan,Gi-Jeong Seo,Brian Bates,Chanho Lee,Peter K. Liaw,Mark W. Noakes,Andrzej Nycz,Changwook Ji,Duck Bong Kim +9 more
TL;DR: In this article, the AISI H13 tool steel, a popular die-casting tool metal, is manufactured by cold metal transfer (CMT)-based additive manufacturing (WAAM) and is then comprehensively analyzed for its microstructural and mechanical properties.
Journal ArticleDOI
Heat treatment effects on Inconel 625 components fabricated by wire + arc additively manufacturing (WAAM)—part 2: mechanical properties
A. N. M. Tanvir,R. U. Ahsan,Gi-Jeong Seo,Jae-duk Kim,Changwook Ji,Brian Bates,Yousub Lee,Duck Bong Kim +7 more
TL;DR: In this article, the authors investigated the mechanical properties of the wire + arc additively manufactured Inconel 625 thin wall and found that the annealing procedure improved the ultimate tensile strength by 5%.