Water ice may be allowed to accumulate in permanently shaded regions on airless bodies in the inner solar system such as Mercury, the Moon, and Ceres [Watson K, et al. (1961) J Geophys Res 66:3033–3045]. Unlike Mercury and Ceres, direct evidence for water ice exposed at the lunar surface has remained elusive. We utilize indirect lighting in regions of permanent shadow to report the detection of diagnostic near-infrared absorption features of water ice in reflectance spectra acquired by the Moon Mineralogy Mapper [M (3)] instrument. Several thousand M (3) pixels (∼280 × 280 m) with signatures of water ice at the optical surface (depth of less than a few millimeters) are identified within 20° latitude of both poles, including locations where independent measurements have suggested that water ice may be present. Most ice locations detected in M (3) data also exhibit lunar orbiter laser altimeter reflectance values and Lyman Alpha Mapping Project instrument UV ratio values consistent with the presence of water ice and also exhibit annual maximum temperatures below 110 K. However, only ∼3.5% of cold traps exhibit ice exposures. Spectral modeling shows that some ice-bearing pixels may contain ∼30 wt % ice that is intimately mixed with dry regolith. The patchy distribution and low abundance of lunar surface-exposed water ice might be associated with the true polar wander and impact gardening. The observation of spectral features of H2O confirms that water ice is trapped and accumulates in permanently shadowed regions of the Moon, and in some locations, it is exposed at the modern optical surface.

https://www.pnas.org/content/pnas/115/36/8907.full.pdf

Direct evidence of surface exposed water ice in the lunar polar regions

An introduction to the NASA Hyperspectral InfraRed Imager (HyspIRI) mission and preparatory activities

Many studies exist on magmatic volatiles (H, C, N, F, S, Cl) in and on the Moon, within the last several years, that have cast into question the post-Apollo view of lunar formation, the distribution and sources of volatiles in the Earth-Moon system, and the thermal and magmatic evolution of the Moon. However, these recent observations are not the first data on lunar volatiles. When Apollo samples were first returned, substantial efforts were made to understand volatile elements, and a wealth of data regarding volatile elements exists in this older literature. In this review paper, we approach volatiles in and on the Moon using new and old data derived from lunar samples and remote sensing. From combining these data sets, we identified many points of convergence, although numerous questions remain unanswered.

The abundances of volatiles in the bulk silicate Moon (BSM), lunar mantle, and urKREEP [last ~1% of the lunar magma ocean (LMO)] were estimated and placed within the context of the LMO model. The lunar mantle is likely heterogeneous with respect to volatiles, and the relative abundances of F, Cl, and H2O in the lunar mantle (H2O > F >> Cl) do not directly reflect those of BSM or urKREEP (Cl > H2O ≈ F). In fact, the abundances of volatiles in the cumulate lunar mantle were likely controlled by partitioning of volatiles between LMO liquid and nominally anhydrous minerals instead of residual liquid trapped in the cumulate pile. An internally consistent model for lunar volatiles in BSM should reproduce the absolute and relative abundances of volatiles in urKREEP, the anorthositic primary crust, and the lunar mantle within the context of processes that occurred during the thermal and magmatic evolution of the Moon. Using this mass-balance constraint, we conducted LMO crystallization calculations with a specific focus on the distributions and abundances of F, Cl, and H2O to determine whether or not estimates of F, Cl, and H2O in urKREEP are consistent with those of the lunar mantle, estimated independently from the analysis of volatiles in mare volcanic materials. Our estimate of volatiles in the bulk lunar mantle are 0.54–4.5 ppm F, 0.15–5.3 ppm H2O, 0.26–2.9 ppm Cl, 0.014–0.57 ppm C, and 78.9 ppm S. Our estimates of H2O are depleted compared to independent estimates of H2O in the lunar mantle, which are largely biased toward the “wettest” samples. Although the lunar mantle is depleted in volatiles relative to Earth, unlike the Earth, the mantle is not the primary host for volatiles. The primary host of the Moon’s incompatible lithophile volatiles (F, Cl, H2O) is urKREEP, which we estimate to have 660 ppm F, 300–1250 ppm H2O, and 1100–1350 ppm Cl. This urKREEP composition implies a BSM with 7.1 ppm F, 3–13 ppm H2O, and 11–14 ppm Cl. An upper bound on the abundances of F, Cl, and H2O in urKREEP and the BSM, based on F abundances in CI carbonaceous chondrites, are reported to be 5500 ppm F, 0.26–1.09 wt% H2O, and 0.98–1.2 wt% Cl and 60 ppm F, 27–114 ppm H2O, and 100–123 ppm Cl, respectively.

The role of volatiles in many lunar geologic processes was also determined and discussed. Specifically, analyses of volatiles from lunar glass beads as well as the phase assemblages present in coatings on those beads were used to infer that H2 is likely the primary vapor component responsible for propelling the fire-fountain eruptions that produced the pyroclastic glass beads (as opposed to CO). The textural occurrences of some volatile-bearing minerals are used to identify hydrothermal alteration, which is manifested by sulfide veining and sulfide-replacement textures in silicates. Metasomatic alteration in lunar systems differs substantially from terrestrial alteration due to differences in oxygen fugacity between the two bodies that result in H2O as the primary solvent for alteration fluids on Earth and H2 as the primary solvent for alteration fluids on the Moon (and other reduced planetary bodies). Additionally, volatile abundances in volatile-bearing materials are combined with isotopic data to determine possible secondary processes that have affected the primary magmatic volatile signatures of lunar rocks including degassing, assimilation, and terrestrial contamination; however, these processes prove difficult to untangle within individual data sets. Data from remote sensing and lunar soils are combined to understand the distribution, origin, and abundances of volatiles on the lunar surface, which can be explained largely by solar wind implantation and spallogenic processes, although some of the volatiles in the soils may also be either indigenous to the Moon or terrestrial contamination. We have also provided a complete inventory of volatile-bearing mineral phases indigenous to lunar samples and discuss some of the “unconfirmed” volatile-bearing minerals that have been reported. Finally, a compilation of unanswered questions and future avenues of research on the topic of lunar volatiles are presented, along with a critical analysis of approaches for answering these questions.

/pdf/magmatic-volatiles-h-c-n-f-s-cl-in-the-lunar-mantle-crust-3fqf0i0ynk.pdf

Magmatic volatiles (H, C, N, F, S, Cl) in the lunar mantle, crust, and regolith: Abundances, distributions, processes, and reservoirs

The evolution of rifting on the volcanic margin of the Pelotas Basin and the contextualization of the Paraná–Etendeka LIP in the separation of Gondwana in the South Atlantic

Real‐time radar–rain‐gauge merging using spatio‐temporal co‐kriging with external drift in the alpine terrain of Switzerland

[1] The NASA Discovery Moon Mineralogy Mapper imaging spectrometer was selected to pursue a wide range of science objectives requiring measurement of composition at fine spatial scales over the full lunar surface. To pursue these objectives, a broad spectral range imaging spectrometer with high uniformity and high signal-to-noise ratio capable of measuring compositionally diagnostic spectral absorption features from a wide variety of known and possible lunar materials was required. For this purpose the Moon Mineralogy Mapper imaging spectrometer was designed and developed that measures the spectral range from 430 to 3000 nm with 10 nm spectral sampling through a 24 degree field of view with 0.7 milliradian spatial sampling. The instrument has a signal-to-noise ratio of greater than 400 for the specified equatorial reference radiance and greater than 100 for the polar reference radiance. The spectral cross-track uniformity is >90% and spectral instantaneous field-of-view uniformity is >90%. The Moon Mineralogy Mapper was launched on Chandrayaan-1 on the 22nd of October. On the 18th of November 2008 the Moon Mineralogy Mapper was turned on and collected a first light data set within 24 h. During this early checkout period and throughout the mission the spacecraft thermal environment and orbital parameters varied more than expected and placed operational and data quality constraints on the measurements. On the 29th of August 2009, spacecraft communication was lost. Over the course of the flight mission 1542 downlinked data sets were acquired that provide coverage of more than 95% of the lunar surface. An end-to-end science data calibration system was developed and all measurements have been passed through this system and delivered to the Planetary Data System (PDS.NASA.GOV). An extensive effort has been undertaken by the science team to validate the Moon Mineralogy Mapper science measurements in the context of the mission objectives. A focused spectral, radiometric, spatial, and uniformity validation effort has been pursued with selected data sets including an Earth-view data set. With this effort an initial validation of the on-orbit performance of the imaging spectrometer has been achieved, including validation of the cross-track spectral uniformity and spectral instantaneous field of view uniformity. The Moon Mineralogy Mapper is the first imaging spectrometer to measure a data set of this kind at the Moon. These calibrated science measurements are being used to address the full set of science goals and objectives for this mission.

https://agupubs.onlinelibrary.wiley.com/doi/pdf/10.1029/2011JE003797

The Moon Mineralogy Mapper (M3) imaging spectrometer for lunar science: Instrument description, calibration, on‐orbit measurements, science data calibration and on‐orbit validation

A.S.K. Kumar

Papers

The Moon Mineralogy Mapper (M3) imaging spectrometer for lunar science: Instrument description, calibration, on‐orbit measurements, science data calibration and on‐orbit validation