다중혈관 관상동맥 환자에서 y-문합을 이용하여 양쪽 내흉동맥만을 사용한 우회술의 조기 성적

http://ieeexplore.ieee.org/iel5/5610941/5624686/05624745.pdf

Power electronics

Thyristor-Based FACTS Controllers for Electrical Transmission Systems

This paper discusses the power quality issues for distributed generation systems based on renewable energy sources, such as solar and wind energy. A thorough discussion about the power quality issues is conducted here. This paper starts with the power quality issues, followed by discussions of basic standards. A comprehensive study of power quality in power systems, including the systems with dc and renewable sources is done in this paper. Power quality monitoring techniques and possible solutions of the power quality issues for the power systems are elaborately studied. Then, we analyze the methods of mitigation of these problems using custom power devices, such as D-STATCOM, UPQC, UPS, TVSS, DVR, etc., for micro grid systems. For renewable energy systems, STATCOM can be a potential choice due to its several advantages, whereas spinning reserve can enhance the power quality in traditional systems. At Last, we study the power quality in dc systems. Simpler arrangement and higher reliability are two main advantages of the dc systems though it faces other power quality issues, such as instability and poor detection of faults.

https://vbn.aau.dk/ws/files/294611667/08314672.pdf

Analysis and Mitigation of Power Quality Issues in Distributed Generation Systems Using Custom Power Devices

Hybrid forecasting system based on an optimal model selection strategy for different wind speed forecasting problems

Wind energy conversion systems (WECS) which consist of wind turbines with permanent magnet synchronous generator (PMSG) and full-power converters have become widespread in the field of renewable power systems. Generally, conventional diode bridge rectifiers have used to obtain a constant DC bus voltage from output of PMSG based wind generator. In recent years, together advanced power electronics technology, Pulse Width Modulation (PWM) rectifiers have used in WECS. PWM rectifiers are used in many applications thanks to their characteristics such as high power factor and low harmonic distortion. In general, L, LC and LCL-type filter configurations are used in these rectifiers. These filter configurations are not exactly compensate current and voltage harmonics. This study proposes a hybrid passive filter configuration for PWM rectifiers instead of existing filters. The performance of hybrid passive filter was tested via MATLAB/Simulink environment under various operational conditions and was compared with LCL filter structure. In addition, neuro-fuzzy controller (NFC) was preferred to increase the performance of PWM rectifier in DC bus voltage control against disturbances because of its robust and nonlinear structure. The study demonstrates that the hybrid passive filter configuration proposed in this study successfully compensates current and voltage harmonics, and improves total harmonic distortion and true power factor.

Power Quality Improvement Using Hybrid Passive Filter Configuration for Wind Energy Systems

During the last decades, thanks to supportive policies of countries and a decrease in installation costs, total installed capacity of wind power has increased rapidly all around the world. The uncertain and variable nature of wind power has been a problem for transmission system operators and wind power plant owners. To solve this problem, numerous wind power forecast systems have been developed. Unfortunately none of them can obtain absolutely accurate forecasts yet. Thus, researchers assumed that wind power generation is a stochastic process and they proposed a stochastic programming approach to solve problems arising from the uncertainty of wind power. It is well known that representing stochastic process by possible scenarios is a major issue in the stochastic programming approach. Large numbers of scenarios can represent a stochastic process accurately, but it is not easy to solve a stochastic problem that contains a large number of scenarios. For this reason scenario reduction methods have been introduced. Finally, the quality of this reduced scenario set must be at an acceptable level to use them in calculations. All of these reasons have encouraged authors to develop a wind power scenario tool that can generate and reduce the scenario set and test the quality of it. The developed tool uses historical data to model wind forecast errors. Scenarios are generated around 24 day-ahead point wind power forecasts. A fast forward reduction algorithm is used to reduce the scenario set. Two metrics are proposed to assess the quality of the reduced scenario set. Site measurements are used to test the developed wind power scenario tool. Results showed that the tool can generate and reduce the scenario set successfully and the proposed metrics are useful to assess the quality.

/pdf/a-day-ahead-wind-power-scenario-generation-reduction-and-3znresgbbe.pdf

A Day-Ahead Wind Power Scenario Generation, Reduction, and Quality Test Tool

The major drawback of photovoltaic (PV) systems is their dependence on environmental conditions, such as solar radiation and temperature. Because of this dependency, maximum power point tracking (MPPT) control methods are used in PV systems in order to extract maximum power from the PV panels. This study proposes a controller with a hybrid structure based on angle of incremental conductance (AIC) method and Interval Type-2 Takagi Sugeno Kang fuzzy logic controller (IT2-TSK-FLC) for MPPT. MPPT performance of proposed hybrid controller is evaluated via detailed simulation studies and dSPACE-based experimental study. The results validate that the proposed hybrid controller offers fast-tracking speed, high stability, and robust performance against uncertainties arising from disturbance to inputs of the PV system.

https://www.mdpi.com/1996-1073/13/7/1842/pdf

Design and Hardware Implementation Based on Hybrid Structure for MPPT of PV System Using an Interval Type-2 TSK Fuzzy Logic Controller

It is well-known that rectifiers are used widely in many applications required AC/DC transformation. With technological advances, many studies are performed for AC/DC converters and many control methods are proposed in order to improve the performance of these rectifiers in recent years. Pulse width modulation (PWM) based rectifiers are one of the most popular rectifier types. PWM rectifiers have lower input current harmonics and higher power factor compared to classical diode and thyristor rectifiers. In this study, neuro-fuzzy controller (NFC) which has robust, nonlinear structure and do not require the mathematical model of the system to be controlled has been proposed for PWM rectifiers. Three NFCs are used in control scheme of proposed PWM rectifier in order to control the dq-axis currents and DC voltage of PWM rectifier. Moreover, simulation studies are carried out to demonstrate the performance of the proposed control scheme at MATLAB/Simulink environment in terms of rise time, settling time, overshoot, power factor, total harmonic distortion and power quality.

/pdf/improved-control-configuration-of-pwm-rectifiers-based-on-21qu38gzy6.pdf

Improved control configuration of PWM rectifiers based on neuro-fuzzy controller

Original scientific paper It is well-known that shunt active power filter (SAPF) is widely used to reduce harmonic distortion and to compensate reactive power in electrical power systems. DC bus voltage control of SAPF is very important for excellent power quality. In the control of SAPF, DC bus voltage is controlled by conventional control methods such as PI and PID controllers. However, these controllers cannot give good results under transient and steady state conditions. Robust and intelligent controllers are required in order to improve performance of SAPF. In this paper, interval type-2 fuzzy logic system (T2FLS) that does not require mathematical model to be controlled system is preferred for control of DC bus voltage of SAPF and compared with type-1 fuzzy logic system (T1FLS). SAPF structures with both controllers are designed and simulated using MATLAB /Simulink environment. Simulation results have shown that SAPF structure with proposed controller has superior features than T1FLS in terms of fixed DC bus voltage, total harmonic distortion and power quality.

Ahmet Gani

Papers

Power Quality Improvement Using Hybrid Passive Filter Configuration for Wind Energy Systems

A Day-Ahead Wind Power Scenario Generation, Reduction, and Quality Test Tool

Design and Hardware Implementation Based on Hybrid Structure for MPPT of PV System Using an Interval Type-2 TSK Fuzzy Logic Controller

Improved control configuration of PWM rectifiers based on neuro-fuzzy controller

Robust control of shunt active power filter using interval type-2 fuzzy logic controller for power quality improvement