Effective management of the COVID-19 pandemic requires widespread and frequent testing of the population for SARS-CoV-2 infection. Saliva has emerged as an attractive alternative to nasopharyngeal samples for surveillance testing as it does not require specialized personnel or materials for its collection and can be easily provided by the patient. We have developed a simple, fast, and sensitive saliva-based testing workflow that requires minimal sample treatment and equipment. After sample inactivation, RNA is quickly released and stabilized in an optimized buffer, followed by reverse transcription loop-mediated isothermal amplification (RT-LAMP) and detection of positive samples using a colorimetric and/or fluorescent readout. The workflow was optimized using 1,670 negative samples collected from 172 different individuals over the course of 6 months. Each sample was spiked with 50 copies/L of inactivated SARS-CoV-2 virus to monitor the efficiency of viral detection. Using pre-defined clinical samples, the test was determined to be 100% specific and 97% sensitive, with a limit of detection comparable to commercially available RT-qPCR-based diagnostics. The method was successfully implemented in a CLIA laboratory setting for workplace surveillance and reporting. From April 2021-February 2022, more than 30,000 self-collected samples from 755 individuals were tested and 85 employees tested positive mainly during December and January, consistent with high infections rates in Massachusetts and nationwide. The rapid identification and isolation of infected individuals with trace viral loads before symptom onset minimized viral spread in the workplace.

Development and implementation of a simple and rapid extraction-free saliva SARS-CoV-2 RT-LAMP workflow for workplace surveillance

The pandemic of coronavirus disease 2019 (COVID-19), due to the novel coronavirus (SARS-CoV-2), has created an unprecedented threat to the global health system, especially in resource-limited areas. This challenge shines a spotlight on the urgent need for a point-of-care (POC) quantitative real-time PCR (qPCR) test for sensitive and rapid diagnosis of viral infections. In a POC system, a closed, single-use, microfluidic cartridge is commonly utilized for integration of nucleic acid preparation, PCR amplification and florescence detection. But, most current cartridge systems often involve complicated nucleic acid extraction via active pumping that relies on cumbersome external hardware, causing increases in system complexity and cost. In this work, we demonstrate a gravity-driven cartridge design for an integrated viral RNA/DNA diagnostic test that does not require auxiliary hardware for fluid pumping due to adopted extraction-free amplification. This microfluidic cartridge only contains two reaction chambers for nucleic acid lysis and amplification respectively, enabling a fast qPCR test in less than 30 min. This gravity-driven pumping strategy can help simplify and minimize the microfluidic cartridge, thus enabling high-throughput (up to 12 test cartridges per test) molecular detection via a small cartridge readout system. Thus, this work addresses the scalability limitation of POC molecular testing and can be run in any settings. We verified the analytical sensitivity and specificity of the cartridge testing for respiratory pathogens and sexually transmitted diseases using SARS-CoV-2, influenza A/B RNA samples, and human papillomavirus 16/18 DNA samples. Our cartridge system exhibited a comparable detection performance to the current gold standard qPCR instrument ABI 7500. Moreover, our system showed very high diagnostic accuracy for viral RNA/DNA detection that was well validated by ROC curve analysis. The sample-to-answer molecular testing system reported in this work has the advantages of simplicity, rapidity, and low cost, making it highly promising for prevention and control of infectious diseases in poor-resource areas.

A sample-to-answer, quantitative real-time PCR system with low-cost, gravity-driven microfluidic cartridge for rapid detection of SARS-CoV-2, influenza A/B, and human papillomavirus 16/18.

Effective management of the COVID-19 pandemic requires widespread and frequent testing of the population for SARS-CoV-2 infection. Saliva has emerged as an attractive alternative to nasopharyngeal samples for surveillance testing as it does not require specialized personnel or materials for its collection and can be easily provided by the patient. We have developed a simple, fast, and sensitive saliva-based testing workflow that requires minimal sample treatment and equipment. After sample inactivation, RNA is quickly released and stabilized in an optimized buffer, followed by reverse transcription loop-mediated isothermal amplification (RT-LAMP) and detection of positive samples using a colorimetric and/or fluorescent readout. The workflow was optimized using 1,670 negative samples collected from 172 different individuals over the course of 6 months. Each sample was spiked with 50 copies/μL of inactivated SARS-CoV-2 virus to monitor the efficiency of viral detection. Using pre-defined clinical samples, the test was determined to be 100% specific and 97% sensitive, with a limit of detection of 39 copies/mL. The method was successfully implemented in a CLIA laboratory setting for workplace surveillance and reporting. From April 2021-February 2022, more than 30,000 self-collected samples from 755 individuals were tested and 85 employees tested positive mainly during December and January, consistent with high infection rates in Massachusetts and nationwide. 

/pdf/development-and-implementation-of-a-simple-and-rapid-37fps1f0.pdf

Reverse transcription loop-mediated isothermal amplification (RT-LAMP) has emerged as a viable molecular diagnostic method to expand the breadth and reach of nucleic acid testing, particularly for SARS-CoV-2 detection and surveillance. While rapidly growing in prominence, RT-LAMP remains a relatively new method compared to the standard RT-qPCR, and contribution to our body of knowledge on designing LAMP primer sets and assays can have significant impact on its utility and adoption. Here we select and evaluate 18 LAMP primer sets for SARS-CoV-2 previously identified as sensitive ones under various conditions, comparing their speed and sensitivity with two LAMP formulations each with 2 reaction temperatures. We find that both LAMP formulations have some effects on the speed and detection sensitivity and identify several primer sets with similar high sensitivity for different SARS-CoV-2 gene targets. Significantly we observe a consistent sensitivity enhancement by combining primer sets for different targets, confirming and building on earlier work to create a simple, general approach to building better and more sensitive RT-LAMP assays. 

/pdf/improving-rt-lamp-detection-of-sars-cov-2-rna-through-primer-15f32v59.pdf

Improving RT-LAMP detection of SARS-CoV-2 RNA through primer set selection and combination

Rapid and accurate detection and identification of pathogens in clinical samples is essential for all infection diseases. However, in the case of epidemics, it plays a key role not only in the implementation of effective therapy but also in limiting the spread of the epidemic. In this study, we present the application of two nucleic acid isothermal amplification methods—reverse transcription helicase dependent amplification (RT-HDA) and reverse transcription loop-mediated amplification (RT-LAMP)—combined with lateral flow assay as the tools for the rapid detection of SARS-CoV-2, the etiological agent of COVID-19, which caused the ongoing global pandemic. In order to optimize the RT-had, the LOD was 3 genome copies per reaction for amplification conducted for 10–20 min, whereas for RT-LAMP, the LOD was 30–300 genome copies per reaction for a reaction conducted for 40 min. No false-positive results were detected for RT-HDA conducted for 10 to 90 min, but false-positive results occurred when RT-LAMP was conducted for longer than 40 min. We concluded that RT-HDA combined with LFA is more sensitive than RT-LAMP, and it is a good alternative for the development of point-of-care tests for SARS-CoV-2 detection as this method is simple, inexpensive, practical, and does not require qualified personnel to perform the test and interpret its results.

/pdf/detection-of-sars-cov-2-using-reverse-transcription-helicase-29xk5r28.pdf

Detection of SARS-CoV-2 Using Reverse Transcription Helicase Dependent Amplification and Reverse Transcription Loop-Mediated Amplification Combined with Lateral Flow Assay

The global COVID-19 pandemic has highlighted the need for rapid, accurate and accessible nucleic acid tests to enable timely identification of infected individuals. We optimized a sample-to-answer nucleic acid test for SARS-CoV-2 that provides results in <1 hour using inexpensive and readily available reagents. The test workflow includes a simple lysis and viral inactivation protocol followed by direct isothermal amplification of viral RNA using RT-LAMP. The assay was validated using two different instruments, a portable isothermal fluorimeter and a standard thermocycler. Results of the RT-LAMP assay were compared to traditional RT-qPCR for nasopharyngeal swabs, nasal swabs, and saliva collected from a cohort of patients hospitalized due to COVID-19. For all three sample types, positive agreement with RT-LAMP performed using the isothermal fluorimeter was 100% for samples with Ct <30 and 69–91% for samples with Ct <40. Following validation, the test was successfully scaled to test the saliva of up to 400 asymptomatic individuals per day as part of the campus surveillance program at Rice University. Successful development, validation, and scaling of this sample-to-answer, extraction-free real-time RT-LAMP test for SARS-CoV-2 adds a highly adaptable tool to efforts to control the COVID-19 pandemic, and can inform test development strategies for future infectious disease threats.

/pdf/sample-to-answer-extraction-free-real-time-rt-lamp-test-for-3el3jrj4.pdf

Sample-to-answer, extraction-free, real-time RT-LAMP test for SARS-CoV-2 in nasopharyngeal, nasal, and saliva samples: Implications and use for surveillance testing


 Patients with titinopathy or hand paralysis often lack quality, low cost therapeutic tools to aid in gaining hand strength and range of motion. As a result, our team sought to develop a way to increase flexion and passive motion in the hand of a patient with titinopathy in order to gain functionality. This paper outlines the design and development of a novel therapeutic glove for a 4 year old boy with a neuromuscular disease that prevents him from flexing the two distal joints of his fingers.
 The team has developed a low-cost hand movement glove (HMG) to be used as a supplement to traditional physical therapy. The device utilizes a motor-cable system secured to each finger, allowing for independent and synchronized flexion of each finger. Phase I of prototyping resulted in a working model to assess the finger movement mechanism and overall wearability of the device. Phase II utilized an Arduino Uno microcontroller, circuit switch, PCA9685 driver board, micro servo motors, a cotton woven glove, and 3-D printed components to characterize a more robust model allowing independent flexion of each finger.
 Initial testing has proven the device’s ability to achieve physiologically relevant degrees of flexion in each finger. Upon completion of further testing, we anticipate this device having a profound impact as an additional tool utilized in the patient’s physical therapy regimen to allow for regained flexion at both proximal and distal interphalangeal joints.

Hand movement glove for child with titinopathy

High-risk human papillomavirus (HPV) DNA testing is widely acknowledged as the most sensitive cervical cancer screening method but has limited availability in resource-limited settings, where the burden of cervical cancer is highest. Recently, HPV DNA tests have been developed for use in resource-limited settings, but they remain too costly for widespread use and require instruments that are often limited to centralized laboratories. To help meet the global need for low-cost cervical cancer screening, we developed a prototype, sample-to-answer, point-of-care test for HPV16 and HPV18 DNA. Our test relies on isothermal DNA amplification and lateral flow detection, two technologies that reduce the need for complex instrumentation. We integrated all test components into a low-cost, manufacturable platform, and performance of the integrated test was evaluated with synthetic samples, provider-collected clinical samples in a high-resource setting in the United States, and self-collected clinical samples in a low-resource setting in Mozambique. We demonstrated a clinically relevant limit of detection of 1000 HPV16 or HPV18 DNA copies per test. The test requires six user steps, yields results in 45 min, and can be performed using a benchtop instrument and minicentrifuge by minimally trained personnel. The projected per-test cost is <$5, and the projected instrumentation cost is <$1000. These results show the feasibility of a sample-to-answer, point-of-care HPV DNA test. With the inclusion of other HPV types, this test has the potential to fill a critical gap for decentralized and globally accessible cervical cancer screening. Description We developed an HPV16 and HPV18 test and demonstrated its potential for cervical cancer screening in low-resource settings. Editor’s summary DNA-based screening methods for high-risk human papillomavirus (HPV) have proven to be highly effective for early cervical cancer detection but remain too expensive and difficult to use in resource-limited settings. Kundrod et al. developed a prototype, sample-to-answer, point-of-care test for detecting HPV16 and HPV18. This test uses isothermal DNA amplification and lateral flow detection with low-cost components that can detect HPV DNA at a clinically relevant limit of detection. This test was successfully demonstrated in a high-resource setting in the United States and in a low-resource setting in Mozambique, and it could be performed by minimally trained personnel at an estimated cost of <$5 per test. These results suggest that a sample-to-answer, point-of-care HPV DNA test is viable for low-resource settings and could improve access to cervical cancer screening. —Christiana Fogg

Akshaya Santhanaraj

Papers

Sample-to-answer, extraction-free, real-time RT-LAMP test for SARS-CoV-2 in nasopharyngeal, nasal, and saliva samples: Implications and use for surveillance testing

Hand movement glove for child with titinopathy

An integrated isothermal nucleic acid amplification test to detect HPV16 and HPV18 DNA in resource-limited settings