Effective management of the COVID-19 pandemic requires widespread and frequent testing of the population for SARS-CoV-2 infection. Saliva has emerged as an attractive alternative to nasopharyngeal samples for surveillance testing as it does not require specialized personnel or materials for its collection and can be easily provided by the patient. We have developed a simple, fast, and sensitive saliva-based testing workflow that requires minimal sample treatment and equipment. After sample inactivation, RNA is quickly released and stabilized in an optimized buffer, followed by reverse transcription loop-mediated isothermal amplification (RT-LAMP) and detection of positive samples using a colorimetric and/or fluorescent readout. The workflow was optimized using 1,670 negative samples collected from 172 different individuals over the course of 6 months. Each sample was spiked with 50 copies/L of inactivated SARS-CoV-2 virus to monitor the efficiency of viral detection. Using pre-defined clinical samples, the test was determined to be 100% specific and 97% sensitive, with a limit of detection comparable to commercially available RT-qPCR-based diagnostics. The method was successfully implemented in a CLIA laboratory setting for workplace surveillance and reporting. From April 2021-February 2022, more than 30,000 self-collected samples from 755 individuals were tested and 85 employees tested positive mainly during December and January, consistent with high infections rates in Massachusetts and nationwide. The rapid identification and isolation of infected individuals with trace viral loads before symptom onset minimized viral spread in the workplace.

Development and implementation of a simple and rapid extraction-free saliva SARS-CoV-2 RT-LAMP workflow for workplace surveillance

The pandemic of coronavirus disease 2019 (COVID-19), due to the novel coronavirus (SARS-CoV-2), has created an unprecedented threat to the global health system, especially in resource-limited areas. This challenge shines a spotlight on the urgent need for a point-of-care (POC) quantitative real-time PCR (qPCR) test for sensitive and rapid diagnosis of viral infections. In a POC system, a closed, single-use, microfluidic cartridge is commonly utilized for integration of nucleic acid preparation, PCR amplification and florescence detection. But, most current cartridge systems often involve complicated nucleic acid extraction via active pumping that relies on cumbersome external hardware, causing increases in system complexity and cost. In this work, we demonstrate a gravity-driven cartridge design for an integrated viral RNA/DNA diagnostic test that does not require auxiliary hardware for fluid pumping due to adopted extraction-free amplification. This microfluidic cartridge only contains two reaction chambers for nucleic acid lysis and amplification respectively, enabling a fast qPCR test in less than 30 min. This gravity-driven pumping strategy can help simplify and minimize the microfluidic cartridge, thus enabling high-throughput (up to 12 test cartridges per test) molecular detection via a small cartridge readout system. Thus, this work addresses the scalability limitation of POC molecular testing and can be run in any settings. We verified the analytical sensitivity and specificity of the cartridge testing for respiratory pathogens and sexually transmitted diseases using SARS-CoV-2, influenza A/B RNA samples, and human papillomavirus 16/18 DNA samples. Our cartridge system exhibited a comparable detection performance to the current gold standard qPCR instrument ABI 7500. Moreover, our system showed very high diagnostic accuracy for viral RNA/DNA detection that was well validated by ROC curve analysis. The sample-to-answer molecular testing system reported in this work has the advantages of simplicity, rapidity, and low cost, making it highly promising for prevention and control of infectious diseases in poor-resource areas.

A sample-to-answer, quantitative real-time PCR system with low-cost, gravity-driven microfluidic cartridge for rapid detection of SARS-CoV-2, influenza A/B, and human papillomavirus 16/18.

Effective management of the COVID-19 pandemic requires widespread and frequent testing of the population for SARS-CoV-2 infection. Saliva has emerged as an attractive alternative to nasopharyngeal samples for surveillance testing as it does not require specialized personnel or materials for its collection and can be easily provided by the patient. We have developed a simple, fast, and sensitive saliva-based testing workflow that requires minimal sample treatment and equipment. After sample inactivation, RNA is quickly released and stabilized in an optimized buffer, followed by reverse transcription loop-mediated isothermal amplification (RT-LAMP) and detection of positive samples using a colorimetric and/or fluorescent readout. The workflow was optimized using 1,670 negative samples collected from 172 different individuals over the course of 6 months. Each sample was spiked with 50 copies/μL of inactivated SARS-CoV-2 virus to monitor the efficiency of viral detection. Using pre-defined clinical samples, the test was determined to be 100% specific and 97% sensitive, with a limit of detection of 39 copies/mL. The method was successfully implemented in a CLIA laboratory setting for workplace surveillance and reporting. From April 2021-February 2022, more than 30,000 self-collected samples from 755 individuals were tested and 85 employees tested positive mainly during December and January, consistent with high infection rates in Massachusetts and nationwide. 

/pdf/development-and-implementation-of-a-simple-and-rapid-37fps1f0.pdf

Reverse transcription loop-mediated isothermal amplification (RT-LAMP) has emerged as a viable molecular diagnostic method to expand the breadth and reach of nucleic acid testing, particularly for SARS-CoV-2 detection and surveillance. While rapidly growing in prominence, RT-LAMP remains a relatively new method compared to the standard RT-qPCR, and contribution to our body of knowledge on designing LAMP primer sets and assays can have significant impact on its utility and adoption. Here we select and evaluate 18 LAMP primer sets for SARS-CoV-2 previously identified as sensitive ones under various conditions, comparing their speed and sensitivity with two LAMP formulations each with 2 reaction temperatures. We find that both LAMP formulations have some effects on the speed and detection sensitivity and identify several primer sets with similar high sensitivity for different SARS-CoV-2 gene targets. Significantly we observe a consistent sensitivity enhancement by combining primer sets for different targets, confirming and building on earlier work to create a simple, general approach to building better and more sensitive RT-LAMP assays. 

/pdf/improving-rt-lamp-detection-of-sars-cov-2-rna-through-primer-15f32v59.pdf

Improving RT-LAMP detection of SARS-CoV-2 RNA through primer set selection and combination

Rapid and accurate detection and identification of pathogens in clinical samples is essential for all infection diseases. However, in the case of epidemics, it plays a key role not only in the implementation of effective therapy but also in limiting the spread of the epidemic. In this study, we present the application of two nucleic acid isothermal amplification methods—reverse transcription helicase dependent amplification (RT-HDA) and reverse transcription loop-mediated amplification (RT-LAMP)—combined with lateral flow assay as the tools for the rapid detection of SARS-CoV-2, the etiological agent of COVID-19, which caused the ongoing global pandemic. In order to optimize the RT-had, the LOD was 3 genome copies per reaction for amplification conducted for 10–20 min, whereas for RT-LAMP, the LOD was 30–300 genome copies per reaction for a reaction conducted for 40 min. No false-positive results were detected for RT-HDA conducted for 10 to 90 min, but false-positive results occurred when RT-LAMP was conducted for longer than 40 min. We concluded that RT-HDA combined with LFA is more sensitive than RT-LAMP, and it is a good alternative for the development of point-of-care tests for SARS-CoV-2 detection as this method is simple, inexpensive, practical, and does not require qualified personnel to perform the test and interpret its results.

/pdf/detection-of-sars-cov-2-using-reverse-transcription-helicase-29xk5r28.pdf

Detection of SARS-CoV-2 Using Reverse Transcription Helicase Dependent Amplification and Reverse Transcription Loop-Mediated Amplification Combined with Lateral Flow Assay

The global COVID-19 pandemic has highlighted the need for rapid, accurate and accessible nucleic acid tests to enable timely identification of infected individuals. We optimized a sample-to-answer nucleic acid test for SARS-CoV-2 that provides results in <1 hour using inexpensive and readily available reagents. The test workflow includes a simple lysis and viral inactivation protocol followed by direct isothermal amplification of viral RNA using RT-LAMP. The assay was validated using two different instruments, a portable isothermal fluorimeter and a standard thermocycler. Results of the RT-LAMP assay were compared to traditional RT-qPCR for nasopharyngeal swabs, nasal swabs, and saliva collected from a cohort of patients hospitalized due to COVID-19. For all three sample types, positive agreement with RT-LAMP performed using the isothermal fluorimeter was 100% for samples with Ct <30 and 69–91% for samples with Ct <40. Following validation, the test was successfully scaled to test the saliva of up to 400 asymptomatic individuals per day as part of the campus surveillance program at Rice University. Successful development, validation, and scaling of this sample-to-answer, extraction-free real-time RT-LAMP test for SARS-CoV-2 adds a highly adaptable tool to efforts to control the COVID-19 pandemic, and can inform test development strategies for future infectious disease threats.

/pdf/sample-to-answer-extraction-free-real-time-rt-lamp-test-for-3el3jrj4.pdf

Sample-to-answer, extraction-free, real-time RT-LAMP test for SARS-CoV-2 in nasopharyngeal, nasal, and saliva samples: Implications and use for surveillance testing

BACKGROUND
High-risk HPV (HR-HPV) infection is a risk factor for anal cancer, yet no anal cancer screening guidelines exist for women with lower genital tract HPV-related disease. We sought to describe the prevalence of anal HR-HPV or cytologic abnormalities in such women.


METHODS
This cross-sectional study was performed between October 2018 and December 2021. Inclusion criteria were >21 years of age and a prior diagnosis of high-grade dysplasia/cancer of the cervix, vagina, or vulva. Participants underwent anal cytology and anal/cervicovaginal HR-HPV testing. Women with abnormal anal cytology were referred for high-resolution anoscopy (HRA).


RESULTS
324 evaluable women were enrolled. Primary diagnosis was high-grade dysplasia/cancer of the cervix (77%), vagina (9%), and vulva (14%). Anal HR-HPV was detected in 92 patients (28%) and included HPV-16 in 24 (26%), HPV-18 in 6 (7%), and other HR-HPV types in 72 (78%) patients. Anal cytology was abnormal in 70 patients (23%) and included ASCUS (80%), LSIL (9%), HSIL (1%), and ASC-H (10%). Of these patients, 55 (79%) underwent HRA. Anal biopsies were performed in 14 patients: two patients had AIN 2/3, one patient had AIN 1, and 11 patients had negative biopsies. Both patients with AIN 2/3 had a history of cervical dysplasia.


CONCLUSION
Our results suggest an elevated risk of anal HR-HPV infection and cytologic abnormalities in women with lower genital tract dysplasia/cancer.


IMPACT
These results add to the growing body of evidence suggesting the need for evaluation of screening methods for anal dysplasia/cancer in this patient population to inform evidence-based screening recommendations.

A cross-sectional study of the prevalence of anal dysplasia among women with high-grade cervical, vaginal, and vulvar dysplasia or cancer: The PANDA Study.

Anthony Price

Papers

Sample-to-answer, extraction-free, real-time RT-LAMP test for SARS-CoV-2 in nasopharyngeal, nasal, and saliva samples: Implications and use for surveillance testing

A cross-sectional study of the prevalence of anal dysplasia among women with high-grade cervical, vaginal, and vulvar dysplasia or cancer: The PANDA Study.