Changes in portlandite morphology with solvent composition: Atomistic simulations and experiment

The methods and mechanisms of nonsolvent induced phase separation have been studied for more than fifty years. Today, phase inversion membranes are widely used in numerous chemical industries, biotechnology, and environmental separation processes. The body of knowledge has grown exponentially in the past fifty years, which suggests the need for a critical review of the literature. Here we present a review of nonsolvent induced phase separation membrane preparation and characterization for many commonly used membrane polymers. The key factors in membrane preparation discussed include the solvent type, polymer type and concentration, nonsolvent system type and composition, additives to the polymer solution, and film casting conditions. A brief introduction to membrane characterization is also given, which includes membrane porosity and pore size distribution characterization, membrane physical and chemical properties characterization, and thermodynamic and kinetic evaluation of the phase inversion process. ...

Preparation and Characterization of Membranes Formed by Nonsolvent Induced Phase Separation: A Review

This review examines the stages of drying, with the emphasis on the constant rate period (CRP), when the pores are full of liquid. It is during the CRP that most of the shrinkage occurs and the drying stresses rise to a maximum. We examine the forces that produce shrinkage and the mechanisms responsible for transport of liquid. By analyzing the interplay of fluid flow and shrinkage of the solid network, it is possible to calculate the pressure distribution in the liquid in the pores. The tension in the liquid is found to be greatest near the drying surface, resulting in greater compressive stresses on the network in that region. This produces differential shrinkage of the solid, which is the cause of cracking during drying. The probability of fracture is related to the size of the body, the rate of evaporation, and the strength of the network. A variety of strategies for avoiding fracture during drying are discussed.

Theory of Drying

Crystallization in pores

The solid–liquidphase transition temperatures and heats of fusion ΔH f of nonpolar organic solids confined in the pores of controlled pore glasses were measured by differential scanning calorimetry. The pore diameters d were in the range of 40–730 A and the organics studied were cis‐decalin, trans‐decalin, cyclohexane, benzene, chlorobenzene, naphthalene, and heptane. In accordance with previous reports on studies of primarily inorganic materials, the melting point of the pore solidT(d) decreased with decreasing pore diameter. In addition, a large reduction in the bulk enthalpy of fusion ΔH f of the pore solid was measured, which apparently has not been studied in detail by other workers. A linear correlation was found between the melting point depression (ΔT m ) and the reciprocal diameter, as predicted by theories of solidification in a capillary. The calculated values of the solid–liquid interfacial energy σsl were in reasonable agreement with values reported in the literature based on other methods of measurement.

/pdf/the-melting-behavior-of-organic-materials-confined-in-porous-315yrxd5fm.pdf

André Lallemand

Papers

A new method for the simultaneous determination of the size and shape of pores: the thermoporometry