We propose a variable-rate and variable-power MQAM modulation scheme for high-speed data transmission over fading channels. We first review results for the Shannon capacity of fading channels with channel side information, where capacity is achieved using adaptive transmission techniques. We then derive the spectral efficiency of our proposed modulation. We show that there is a constant power gap between the spectral efficiency of our proposed technique and the channel capacity, and this gap is a simple function of the required bit-error rate (BER). In addition, using just five or six different signal constellations, we achieve within 1-2 dB of the maximum efficiency using unrestricted constellation sets. We compute the rate at which the transmitter needs to update its power and rate as a function of the channel Doppler frequency for these constellation sets. We also obtain the exact efficiency loss for smaller constellation sets, which may be required if the transmitter adaptation rate is constrained by hardware limitations. Our modulation scheme exhibits a 5-10-dB power gain relative to variable-power fixed-rate transmission, and up to 20 dB of gain relative to nonadaptive transmission. We also determine the effect of channel estimation error and delay on the BER performance of our adaptive scheme. We conclude with a discussion of coding techniques and the relationship between our proposed modulation and Shannon capacity.

Variable-rate variable-power MQAM for fading channels

There is considerable pressure to define the key requirements of 5G, develop 5G standards, and perform technology trials as quickly as possible. Normally, these activities are best done in series but there is a desire to complete these tasks in parallel so that commercial deployments of 5G can begin by 2020. 5G will not be an incremental improvement over its predecessors; it aims to be a revolutionary leap forward in terms of data rates, latency, massive connectivity, network reliability, and energy efficiency. These capabilities are targeted at realizing high-speed connectivity, the Internet of Things, augmented virtual reality, the tactile internet, and so on. The requirements of 5G are expected to be met by new spectrum in the microwave bands (3.3-4.2 GHz), and utilizing large bandwidths available in mm-wave bands, increasing spatial degrees of freedom via large antenna arrays and 3-D MIMO, network densification, and new waveforms that provide scalability and flexibility to meet the varying demands of 5G services. Unlike the one size fits all 4G core networks, the 5G core network must be flexible and adaptable and is expected to simultaneously provide optimized support for the diverse 5G use case categories. In this paper, we provide an overview of 5G research, standardization trials, and deployment challenges. Due to the enormous scope of 5G systems, it is necessary to provide some direction in a tutorial article, and in this overview, the focus is largely user centric, rather than device centric. In addition to surveying the state of play in the area, we identify leading technologies, evaluating their strengths and weaknesses, and outline the key challenges ahead, with research test beds delivering promising performance but pre-commercial trials lagging behind the desired 5G targets.

5G : A tutorial overview of standards, trials, challenges, deployment, and practice

This paper provides an overview of the features of fifth generation (5G) wireless communication systems now being developed for use in the millimeter wave (mmWave) frequency bands. Early results and key concepts of 5G networks are presented, and the channel modeling efforts of many international groups for both licensed and unlicensed applications are described here. Propagation parameters and channel models for understanding mmWave propagation, such as line-of-sight (LOS) probabilities, large-scale path loss, and building penetration loss, as modeled by various standardization bodies, are compared over the 0.5–100 GHz range.

/pdf/overview-of-millimeter-wave-communications-for-fifth-3yhmjybx4f.pdf

Overview of Millimeter Wave Communications for Fifth-Generation (5G) Wireless Networks—With a Focus on Propagation Models

The fifth generation (5G) wireless communication networks are being deployed worldwide from 2020 and more capabilities are in the process of being standardized, such as mass connectivity, ultra-reliability, and guaranteed low latency. However, 5G will not meet all requirements of the future in 2030 and beyond, and sixth generation (6G) wireless communication networks are expected to provide global coverage, enhanced spectral/energy/cost efficiency, better intelligence level and security, etc. To meet these requirements, 6G networks will rely on new enabling technologies, i.e., air interface and transmission technologies and novel network architecture, such as waveform design, multiple access, channel coding schemes, multi-antenna technologies, network slicing, cell-free architecture, and cloud/fog/edge computing. Our vision on 6G is that it will have four new paradigm shifts. First, to satisfy the requirement of global coverage, 6G will not be limited to terrestrial communication networks, which will need to be complemented with non-terrestrial networks such as satellite and unmanned aerial vehicle (UAV) communication networks, thus achieving a space-air-ground-sea integrated communication network. Second, all spectra will be fully explored to further increase data rates and connection density, including the sub-6 GHz, millimeter wave (mmWave), terahertz (THz), and optical frequency bands. Third, facing the big datasets generated by the use of extremely heterogeneous networks, diverse communication scenarios, large numbers of antennas, wide bandwidths, and new service requirements, 6G networks will enable a new range of smart applications with the aid of artificial intelligence (AI) and big data technologies. Fourth, network security will have to be strengthened when developing 6G networks. This article provides a comprehensive survey of recent advances and future trends in these four aspects. Clearly, 6G with additional technical requirements beyond those of 5G will enable faster and further communications to the extent that the boundary between physical and cyber worlds disappears.

/pdf/towards-6g-wireless-communication-networks-vision-enabling-2tj7a36yux.pdf

Towards 6G wireless communication networks: vision, enabling technologies, and new paradigm shifts

A system and method in a building or vehicle for an actuator operation in response to a sensor according to a control logic, the system comprising a router or a gateway communicating with a device associated with the sensor and a device associated with the actuator over in-building or in-vehicle networks, and an external Internet-connected control server associated with the control logic implementing a PID closed linear control loop and communicating with the router over external network for controlling the in-building or in-vehicle phenomenon. The sensor may be a microphone or a camera, and the system may include voice or image processing as part of the control logic. A redundancy is used by using multiple sensors or actuators, or by using multiple data paths over the building or vehicle internal or external communication. The networks may be wired or wireless, and may be BAN, PAN, LAN, WAN, or home networks.

System and method for server based control

A new two-dimensional modulation technique called Orthogonal Time Frequency Space (OTFS) modulation designed in the delay-Doppler domain is introduced. Through this design, which exploits full diversity over time and frequency, OTFS coupled with equalization converts the fading, time-varying wireless channel experienced by modulated signals such as OFDM into a time-independent channel with a complex channel gain that is roughly constant for all symbols. Thus, transmitter adaptation is not needed. This extraction of the full channel diversity allows OTFS to greatly simplify system operation and significantly improves performance, particular in systems with high Doppler, short packets, and large antenna arrays. Simulation results indicate at least several dB of block error rate performance improvement for OTFS over OFDM in all of these settings. In addition these results show that even at very high Dopplers (500 km#x002F;h), OTFS approaches channel capacity through linear scaling of throughput with the MIMO order, whereas the performance of OFDM under typical design parameters breaks down completely.

Orthogonal Time Frequency Space Modulation

This paper introduces a new two-dimensional modulation technique called Orthogonal Time Frequency Space (OTFS) modulation. OTFS has the novel and important feature of being designed in the delay-Doppler domain. When coupled with a suitable equalizer, OTFS modulation is able to exploit the full channel diversity over both time and frequency. Moreover, it converts the fading, time-varying wireless channel experienced by modulated signals such as OFDM into a time-independent channel with a complex channel gain that is essentially constant for all symbols. 
This design obviates the need for transmitter adaptation, and greatly simplifies system operation. The paper describes the basic operating principles of OTFS as well as a possible implementation as an overlay to current or anticipated standardized systems. OTFS is shown to provide significant performance improvement in systems with high Doppler, short packets, and/or large antenna array. In particular, simulation results indicate at least several dB of block error rate performance improvement for OTFS over OFDM in all of these settings.

In this paper, we introduce a new 2D modulation scheme referred to as OTFS (Orthogonal Time Frequency & Space) that multiplexes information QAM symbols over new class of carrier waveforms that correspond to localized pulses in a signal representation called the delay-Doppler representation. OTFS constitutes a far reaching generalization of conventional time and frequency modulations such as TDM and FDM and, from a broader perspective, it establishes a conceptual link between Radar and communication. The OTFS waveforms couple with the wireless channel in a way that directly captures the underlying physics, yielding a high-resolution delay-Doppler Radar image of the constituent reflectors. As a result, the time-frequency selective channel is converted into an invariant, separable and orthogonal interaction, where all received QAM symbols experience the same localized impairment and all the delay-Doppler diversity branches are coherently combined. The high resolution delay-Doppler separation of the reflectors enables OTFS to approach channel capacity with optimal performance-complexity tradeoff through linear scaling of spectral efficiency with the MIMO order and robustness to Doppler and multipath channel conditions. OTFS is an enabler for realizing the full promise of MUMIMO gains even in challenging 5G deployment settings where adaptation is unrealistic.

OTFS: A New Generation of Modulation Addressing the Challenges of 5G.

Due to the increased demand for data rate, flexibility, and reliability of 5G cellular systems, new modulation formats need to be considered. A recently proposed scheme, Orthogonal Time Frequency Space (OTFS), offers various advantages in particular in environments with high frequency dispersion. Such environments are encountered, e.g, in mm-wave systems, both due to the higher phase noise, and the larger Doppler spreads encountered there. The current paper provides a performance evaluation of OTFS at 5G mm-wave frequencies. Comparisons with OFDM modulation show that OTFS has lower BER than OFDM in a number of situations.

Orthogonal Time Frequency Space (OTFS) modulation for millimeter-wave communications systems

A local area network uses coaxial cable wiring for interconnection of terminal devices. A frequency selective network interface device is placed at the building point of entry or another point in the wiring to reflect network signals transmitted by terminal devices back into the building distribution to be received by other terminal devices. By reflecting network upstream signals back into the building as downstream signals, the network interface provides a path for terminal devices to transmit to and receive from other terminal devices.

Anton Monk

Papers

Orthogonal Time Frequency Space Modulation

Orthogonal Time Frequency Space Modulation

OTFS: A New Generation of Modulation Addressing the Challenges of 5G.

Orthogonal Time Frequency Space (OTFS) modulation for millimeter-wave communications systems

Network interface device and broadband local area network using coaxial cable